A Physico-Mathematical Model for the Dispersion Process in a Co-Rotating Intermeshing Twin Screw Extruder

Abstract

To modify the properties of polymers, mineral fillers are frequently added during the compounding process. Due to adhesive forces, these pulverized fillers tend to agglomerate. Therefore, in order to achieve a good homogenisation, it is essential not only to distribute them but also to break down the solid agglomerates. A number of relating models have been published, describing observations (agglomerate rupture, erosion, clustering) made during the dispersion process in a mostly isolated manner. Here, a new model considering each observed effect has been developed in order to get a comprehensive description of the dispersion process. To verify the model, it was implemented into a program for the process simulation of co-rotating twin screw extruders (SIGMA [1]), and thus compared to experimental data. It showed that the model could well describe the experimentally determined data.

Keywords

twin screw extruder process simulation mineral fillers dispersion process

Get full access to this article

View all access options for this article.

References

1. H. Potente, U. Melisch, and J. Flecke, ANTEC, Indianapolis (1996).

2. J. Raasch, Beanspruchung und Verhalten suspendierter Feststoffteilchen in Scherströmungen hoher Festigkeit, Ph.D. Thesis, TH Karlsruhe, (1961).

3. J. Krekel, Herstellung und Messung von Scherströmungen mit extrem großen Geschwindigkeiten, TH Karlsruhe, (1964).

4. H. Rumpf , International Symposium Philadelphia (1961).

5. I. Manas-Zloczower , Mixing and Compounding of Polymers, Hanser Publishers, (1994).

6. R. Powell and S. Mason , AlChE Journal, 28, 286-293, (1982).

7. M. Boriers , A. Huneault and P.G. Lafleur , Intern. Polymer Proc., XIV (1999) 3.