Fe-based amorphous coatings are increasingly recognised as promising candidates for the protection of coal-fired boilers against corrosion. The present study prepared Fe-based amorphous coatings on a T91 substrate by plasma spraying technology. The corrosion behaviour of the coating in hot Na2SO4 + K2SO4 salts at 700°C was investigated, and measurements of the mean mass gain were performed after each cycle to establish the hot corrosion kinetics of the coatings using the thermogravimetric technique. The coated specimens, especially specimens with 380-μm-thick coatings, exhibited lower mean gain rates at all operating cycles as compared to the uncoated T91 samples. The highest hot corrosion resistance was a result of the amorphous composite microstructure and high Cr and Ni elemental contents, which contributed to the formation of the protective oxides of chromium and nickel such as Cr2O3, NiO and NiCr2O4.
International Energy Agency (IEA). Key energy statistics; 2009. See also: http://www.iea.org.
2.
HöökM, ZittelW, SchindlerJ, Global coal production outlooks based on a logistic model. Fuel. 2010;89:3546–3558. doi: 10.1016/j.fuel.2010.06.013
3.
ChuiEH, GaoH.Estimation of NOx emissions from coal-fired utility boilers. Fuel. 2010;89:2977–2984. doi: 10.1016/j.fuel.2010.05.008
4.
SeongBG, HwangSY, KimKY.High-temperature corrosion of recuperators used in steel mills. Surf Coat Technol. 2000;126:256–265. doi: 10.1016/S0257-8972(00)00523-5
5.
ZhongXY, WuXQ, HanEH.The characteristic of oxide scales on T91 tube after long-term service in an ultra-supercritical coal power plant. J Supercrit Fluid. 2012;72:68–77. doi: 10.1016/j.supflu.2012.08.015
6.
ChathaSS, SidhuHS, SidhuBS.High temperature hot corrosion behaviour of NiCr and Cr3C2-NiCr coatings on T91 boiler steel in an aggressive environment at 750°C. Surf Coat Technol. 2012;206:3839–3850. doi: 10.1016/j.surfcoat.2012.01.060
7.
UusitaloMA, VuoristoPMJ, MäntyläTA.High temperature corrosion of coatings and boiler steels below chlorine-containing salt deposits. Corros Sci. 2004;46:1311–1331. doi: 10.1016/j.corsci.2003.09.026
MishraSB, PrakashS.Erosion-corrosion behaviour of Ni-20Cr plasma coating in actual boiler environment. Surf Eng. 2015;31(1):29–38. doi: 10.1179/1743294414Y.0000000338
10.
KaurM, SinghH, PrakashS.Role of detonation gun spray Cr3C2-NiCr coating in improving high temperature corrosion resistance of SAE-213-T22 and SAE-347H steel in presence of Na2SO4-82%Fe2(SO4)(3) salt deposits. Surf Eng. 2010;26(6):428–439. doi: 10.1179/026708409X12490360425963
11.
LiuWY, HouY, LiuC, Hot corrosion behavior of a centimeter Fe-based amorphous composite coating prepared by laser cladding in molten Na2SO4+K2SO4 salts. Surf Coat Technol. 2015;270:33–38. doi: 10.1016/j.surfcoat.2015.03.022
12.
Science and Technology Review. Lawrence Livermore National Laboratory; 2009.
13.
GuilemanyJM, FernάndezJ, DelgadoJ.Electrochemical measurements and characterisation of a thermally sprayed HVOF Cr3C2-NiCr coating in a corrosive environment. Proceedings of the ITSC; 1999; Düsseldorf, Germany; 474–478.
14.
GuilemanyJM, FernάndezJ, DelgadoJ, Effects of thickness coating on the electrochemical behaviour of thermal spray Cr3C2-NiCr coatings. Surf Coat Technol. 2002;153:107–113. doi: 10.1016/S0257-8972(01)01679-6
15.
WangAP, ZhangT, WangJQ.Ni-based full amorphous metallic coating with high corrosion resistance. Philos Mag Lett. 2006;86:5–11. doi: 10.1080/09500830500479718
16.
ZhangSD, ZhangWL, WangSG, Characterisation of three-dimensional porosity in an Fe-based amorphous coating and its correlation with corrosion behavior. Corros Sci. 2015;93:211–221. doi: 10.1016/j.corsci.2015.01.022
17.
HashimotoK, AsamiK, KawashimaA, The role of corrosion-resistant alloying elements in passivity. Corros Sci. 2007;49:42–52. doi: 10.1016/j.corsci.2006.05.003
18.
WangY, ZhengYG, KeW, Slurry erosion-corrosion behaviour of high-velocity oxy-fuel (HVOF) sprayed Fe-based amorphous metallic coatings for marine pump in sand-containing NaCl solutions. Corros Sci. 2011;53:3177–3185. doi: 10.1016/j.corsci.2011.05.062
19.
XuZH, MuRD, HeLM, Effect of diffusion barrier on the high-temperature oxidation behavior of thermal barrier coatings. J Alloy Comp. 2008;466:471–478. doi: 10.1016/j.jallcom.2007.11.083
20.
MaJ, JiangSM, GongJ, Hot corrosion properties of composite coatings in the presence of NaCl at 700 and 900°C. Corros Sci. 2013;70:29–36. doi: 10.1016/j.corsci.2013.01.004
21.
GuoRQ, ZhangC, YangY, Corrosion and wear resistance of a Fe-based amorphous coating in underground environment. Intermetallics. 2012;30:94–99. doi: 10.1016/j.intermet.2012.03.026
22.
ZhangYJ, SunXF, GuanHR, Effect of sprayed powder particle size on the oxidation behavior of MCrAlY materials during high velocity oxygen-fuel deposition. Surf Coat Technol. 2002;161:302–305. doi: 10.1016/S0257-8972(02)00468-1
23.
SidhuTS, PrakashS, AgrawalRD.Characterizations and hot corrosion resistance of Cr3C2-NiCr coating on Ni-base super alloys in an aggressive environment. J Therm Spray Technol. 2006;15:811–816. doi: 10.1361/105996306X147162
24.
MatthewsSJ, JamesBJ, HylandMM.The role of microstructure in the mechanism of high velocity erosion of Cr3C2-NiCr, thermal spray coatings: part 2-heat treated coatings. Surf Coat Technol. 2009;203:1094–1100. doi: 10.1016/j.surfcoat.2008.10.013
25.
DasD, BalasubramaniamR, MungoleMN.Hot corrosion of carbon-alloyed Fe3Al-based iron aluminides. Mater Sci Eng A. 2002;338:24–32. doi: 10.1016/S0921-5093(02)00072-2
