Sage Journals: Discover world-class research

Abstract

Two face milling cutter systems, both with PCBN (polycrystalline cubic boron nitride) tools, were used to study burr formation in high-speed machining of grey cast iron under various cutting conditions. Surface roughness parameters R_a and R_i, tool life (based on flank wear, VB_max) and burr formation (length of the burr, h) were recorded and used for comparing machining performance. The best performance in terms of tool life and surface roughness was obtained with the milling cutter system consisting of 24 teeth and 24 square wiper inserts. Machining with this cutter configuration produced acceptable surface roughness values, well below the rejection criterion, after machining a batch of 3000 motor blocks in addition to achieving a significant reduction in the burr length.

Keywords

burr formation milling cutter system PCBN tools tool wear surface finish

References

Tool wear in the cutting of thin-gauge steel sheets. ASTME Research Report 22, American Society of Tool and Manufacturing Engineers, Dearborn, Michigan, 1959.

Dornfeld

D. A.

Integrated designs and manufacturing for milling burr minimization. Research Reports by CODEF, Laboratory for Manufacturing Automation, University of California, Berkeley, 1998.

Gillespie

L. K.

Blotter

P. T.

The formation and properties of machining burrs. Trans. ASME, 1976, 98, 66–74.

Nakayama

Arai

Burr formation in metal cutting. Ann. CIRP, 1987, 36, 33–36.

Pekelharing

A. J.

The exit failure uninterrupted cutting. Ann. CIRP, 1978, 27(1), 5–10.

Hashimura

Chang

Y. P.

Dornfeld

D. A.

Analysis of burr formation mechanism in orthogonal cutting. J. Mfg Sci. Engng, 1999, 121, 1–7.

S. L.

Dornfeld

D. A.

Analysis of fracture in burr formation at the exit stage of metal cutting. J. Mater. Processing Technol., 1996, 58, 189–200.

S. L.

Dornfeld

D. A.

Burr formation and fracture in oblique cutting. J. Mater. Processing Technol., 1996, 63, 24–36.

Chern

G. L.

Dornfeld

D. A.

Burr/breakout model development and experimental verification. J. Engng Mater. Technol., 1996, 118, 201–206.

10.

Trent

E. M.

Metal Cutting, 3rd edition, 1991, 273 pp. (Butterworths-Heinemann, London).

11.

Olvera

Barrow

Influence of exit angle and tool nose geometry on burr formation in face milling operations. Proc. Instn Mech. Engrs, Part B: J. Engineering Manufacture, 1998, 212(B1), 59–72.

12.

Lee

Horne

J. G.

Tabor

The mechanism of notch formation at the depth of cut line of ceramic tools when machining nickel base superalloys. In Proceedings of International Conference on Wear Materials, ASME, Dearborn, Michigan, 16–18 April 1979 460–469.

13.

Mills

Redford

A. H.

Machinability of Engineering Materials, 1983 (Applied Science Publications, London).

Burr formation in face milling of cast iron with different milling cutter systems

Abstract

Abstract

Keywords

References