An in-situ three point bending device was designed to study the vibrational response of ZrB2+SiC and LaCoO3 ceramics under loading. The developed device was calibrated using four different materials, Al, La0·8Sr0·2Ga0·8Mg0·2O3, La0·8Ca0·2CoO3, and B4C, with prior known properties and the measured stress-strain deformation curves were in excellent agreement with the results published in the literature. The piezo-spectroscopic coefficients of LO and TO SiC Raman bands have been established for ZrB2+10wt%SiC ceramic composite. Several eight hour constant 66 MPa load experiments were performed to estimate if a tensile load would have an effect on vibrational properties of LaCoO3 perovskite.
GogotsiGA: ‘Fracture toughness of ceramics and ceramic composites’, Ceram. Int., 2003, 29, 777–784.
2.
PancheriP, BosettiP, MaschioR, SglavoVM: ‘Production of sharp cracks in ceramic materials by three-point bending of sandwiched specimens’, Eng. Fract. Mech., 1998, 59, 447–456.
3.
GhoshD, SubhashG, OrlovskayaN: ‘Measurement of scratch-induced residual stress within SiC grains in ZrB2–SiC composite using micro-Raman spectroscopy’, Acta Mater., 2008, 56, 5345–5354.
4.
LugovyM, SlyunyayaevV, YarmolenkoS, SankarJ, GrauleT, KueblerJ, NicholsonD, OrlovskayaN: ‘A further insight into spherical indentation: ring crack formation in a brittle La0.8Sr0.2Ga0.8Mg0.2O3 perovskite’, Acta Mater., 2011, 59, 4425–4436.
5.
BarsoumMW: ‘Fundamentals of ceramics’, 1st edn; 2002, New York, Taylor & Francis Group.
6.
FengZC, ChoykeWJ, PowellJA: ‘Raman determination of layer stresses and strains for heterostructures and its application to the cubic SiC/Si system’, J. Appl. Phys., 1988, 64, 6827–6835.
7.
LukichS, CarpenterC, OrlovskayaN: ‘Temperature and stress induced changes of the vibrational response of cubic and rhombohedral 10 mol%Sc2O3–1 mol%CeO2–ZrO2 ceramics’, J. Power Sources, 2010, 195, 2301–2309.
8.
OrlovskayaN, LugovyM, CarpenterC, PathakS, SteinmetzD, Lara-CurzioE, KlemenzC, RadovicM: ‘On thermal and vibrational properties of LaGaO3 single crystals’, Acta Mater., 2009, 57, 2984–2992.
9.
OrlovskayaN, CoratoloA, LugovyM, JohnsonC, GemmenR: ‘Structural evolution of La–Cr–O thin films: Part I. Microstructure and phase development’, Thin Solid Films, 2006, 515, 1741–1747.
10.
OrlovskayaN, CoratoloA, JohnsonC, GemmenR: ‘Structural characterization of lanthanum chromite perovskite coating deposited by magnetron sputtering on an iron-based chromium-containing alloy as a promising interconnect material for SOFCs’, J. Am. Ceram. Soc., 2004, 87, 1981–1987.
11.
PaulA, VaidhyanathanB, BinnerJ: ‘Micro-Raman spectroscopy of indentation induced phase transformation in nanozirconia ceramics’, Adv. Appl. Ceram., 2001, 110, 114–119.
12.
OrlovskayaN, SteinmetzD, YarmolenkoS, PaiD, SankarD, GoodenoughJ: ‘Detection of temperature and stress induced modifications of LaCoO3 by micro-Raman spectroscopy’, Phys. Rev. B, 2005, 72B, 014122.
13.
FerdousMS, MakabeC, RanaMS, MiyazakiT: ‘Improving the fatigue strength of a multiple hole specimen by applying additional holes or notches’, Eng. Fail. Anal., 2001, 18, 75–87.
OrlovskayaN, LugovyM, PathakS, SteinmetzD, LloydJ, FegelyL, RadovicM, PayzantEA, Lara-CurzioE, AllardLF, KueblerJ: ‘Thermal and mechanical properties of LaCoO3 and La0.8Ca0.2CoO3 perovskites’, J. Power Sources, 2008, 182, 230–239.
16.
OrlovskayaN, YarmolenkoS, SankarJ, KueblerJ, LugovyM: ‘Effects of rolling and hot pressing on mechanical properties of boron carbide-based ceramics’, J. Mater. Sci., 2008, 43, 5942–5947.
17.
van WieDM, DrewryDG, KingDE, HudsonCM: ‘The hypersonic environment: required operating conditions and design challenges’, J. Mater. Sci., 2004, 39, 5915–5924.
18.
JacksonTA, EklundDR, FinkAJ: ‘High speed propulsion: performance advantage of advanced materials’, J. Mater. Sci., 2004, 39, 5905–5913.
19.
FahrenholtzWG, HilmasGE, TalmyIG, ZaykoskiJA: ‘Refractory diborides of zirconium and hafnium’, J. Am. Ceram. Soc., 2007, 90, 1347–1364.
20.
RezaieA, FahrenholtzWG, HilmasGE: ‘Effect of hot pressing time and temperature on the microstructure and mechanical properties of ZrB2–SiC’, J. Mater. Sci., 2007, 42, 2735–2744.
21.
ChamberlainAL, FahrenholtzWG, HilmasGE: ‘Low-temperature densification of zirconium diboride ceramics by reactive hot pressing’, J. Am. Ceram. Soc., 2006, 89, 3638–3645.
22.
OrlovskayaN, StadelmannR, LugovyM, SubbotinV, NeubertM, AnezirisCG, GrauleT, KueblerJ: ‘Mechanical properties of ZrB2–SiC ceramic composites: room temperature instantaneous behavior’, J. Eur. Ceram. Soc., in preparation for submission.
SuCM, WuttigM, FekadeA, SpencerM: ‘Elastic and anelastic properties of chemical vapor deposited epitaxial 3C-SiC’, J. Appl. Phys., 1995, 77, 5611–5615.
DonohueM, CarpenterC, OrlovskayaN: ‘Vibrational properties of Zr(Hf)B2–SiC UHTC composites by micro-Raman spectroscopy’, in ‘Boron rich solids: sensors, ultra high temperature ceramics, thermoelectrics, armor’, (ed. , OrlovskayaN, LugovyM), 287–302; 2010, Dordrecht, Springer.
28.
MukaidaH, OkumuraH, LeeJH, DaimonH, SakumaE, MisawaS, EndoK, YoshidaS: ‘Raman scattering of SiC: estimation of the internal stress in 3C-SiC on Si’, J. Appl. Phys., 1987, 62, 254–257.
29.
WattsJ, HilmasG, FahrenholtzWG, BrownD, ClausenB: ‘Stress measurements in ZrBd–SiC composites using Raman spectroscopy and neutron diffraction’, J. Eur. Ceram. Soc., 2010, 30, 2165–2171.
30.
YangY, ChenZ: ‘Identification of SiC polytypes by etched Si-face morphology’, Mater. Sci. Semicon. Proc., 2009, 12, 113–117.
31.
LiuJ, VohraYK: ‘Raman modes of 6H polytype of silicon carbide to ultrahigh pressures: a comparison with silicon and diamond’, Phys. Rev. Lett., 1994, 72, 4105–4108.
32.
LimargaAM, ClarkeDR: ‘Piezo-spectroscopic coefficients of tetragonal-prime yttria-stabilized zirconia’, J. Am. Ceram. Soc., 2007, 90, 1272–1275.
33.
RadovicM, SpeakmanSA, AllardLF, PayzantEA, Lara-CurzioE, KrivenWM, LloydJ, FegelyL, OrlovskayaN: ‘Thermal, mechanical and phase stability of LaCoO3 in reducing and oxidizing environments’, J. Power Sources, 2008, 184, 77–83.
34.
HuangK, FengM, GoodenoughJB, SchmerlingM: ‘Characterization of Sr-doped LaMnO3 and LaCoO3 as cathode materials for a doped LaGaO3 ceramic fuel cell’, J. Electrochem. Soc., 1996, 143, 3630–3636.
35.
KushimaA, YipS, YildizB: ‘Competing strain effects in reactivity of LaCoO3 with oxygen’, Phys. Rev. B, 2010, 82B, 115435.
36.
HochMJR, NellutlaS, van TolJ, ChoiES, LuJ, ZhengH, MitchellJF: ‘Diamagnetic to paramagnetic transition in LaCoO3’, Phys. Rev. B, 2009, 79B, 214421.
37.
TsvetkovDS, ZuevAY, VylkovAI, PetrovAN: ‘Oxide ion transport in undoped and Cr-doped LaCoO3-d’, Solid State Ion., 2007, 178, 1458–1462.
38.
GoodenoughJ, ZhouJS: ‘Transport properties’, in ‘Structure and bonding’, (ed. , GoodenoughJ, ed), Vol. 98, 17–113; 2001, Berlin, Springer.
39.
HsuH, BlahaP, WentzcovitchRM, LeightonC: ‘Cobalt spin states and hyperfine interactions in LaCoO3 investigated by LDA+U calculations’, Phys. Rev. B, 2010, 82B, 100406.
40.
EderR: ‘Spin-state transition in LaCoO3 by variational cluster approximation’, Phys. Rev. B, 2010, 81B, 035101.
41.
VankoG, RueffJP, MattilaA, NemethZ, ShuklaA: ‘Temperature- and pressure-induced spin-state transitions in LaCoO3’, Phys. Rev. B, 2006, 73B, 024424.
42.
RadaelliPG, CheongSW: ‘Structural phenomena associated with the spin-state transition in LaCoO3’, Phys. Rev. B, 2002, 66B, 094408.
43.
LengsdorfR, RueffJP, VankoG, LorenzT, TjengLH, Abd-ElmeguidMM: ‘Spin-state-driven metal-insulator transition in (La,Sr)CoO3 under high-pressure’, Phys. Rev. B, 2007, 75B, 180401.
44.
SehlinSR, AndersonHU, SparlinDM: ‘Semiempirical model for the electrical properties of La1-xCaxCoO3’, Phys. Rev. B, 1995, 52B, 11681–11689.
45.
TokuraY, OkimotoY, YamaguchiS, TaniguchiH, KimuraT, TakagiH: ‘Thermally induced insulator-metal transition in LaCoO3: a view based on the Mott transition’, Phys. Rev. B, 1998, 58B, R1699–R1702.
46.
LugovyM, SlyunyayevV, OrlovskayaN, VerbyloD, ReeceMJ: ‘Room-temperature creep of LaCoO3-based perovskites: equilibrium strain under compression’, Phys. Rev. B, 2008, 78B, 024107.
47.
OrlovskayaN, GogotsiY, ReeceM, ChengB, GibsonI: ‘Ferroelasticity and hysteresis in LaCoO3 based perovskites’, Acta Mater., 2002, 50, 715–723.
48.
OrlovskayaN, BrowningN, NichollsA: ‘Ferroelasticity in mixed conducting LaCoO3 based perovskites: a ferroelastic phase transition’, Acta Mater., 2003, 51, 5063–5071.
49.
RavindranP, FjellvagH, KjekshusA, BlahaP, SchwarzK, LuitzJ: ‘Itinerant metamagnetism and possible spin transition in LaCoO3 by temperature/hole doping’, J. Appl. Phys., 2002, 91, 291–303.
50.
KyomenT, SanoA, MurachiY, HanayaM, SuzukiK, ItoM: ‘Coupling of ferroelasticity and ferromagnetism in La1-xSrxCoO3 twin crystals’, Phys Rev. B, 2010, 82B, 064402.
