A series of welds were fabricated in high strength low alloy 65 steel. The first pass went the entire length of the plate and each subsequent pass was indented ∼25 mm. This allowed the authors to determine the change in hardness on a pass-by-pass basis by mapping the hardness over each weld pass.
MoonD. W., LambrakosS. G., WongR. J. and MetzbowerE. A.: Sci. Technol. Weld. Joining, 2003, 8, (2), 95–101.
2.
MoonD. W., LambrakosS. G., WongR. J. and MetzbowerE. A.: Sci. Technol. Weld. Joining, 2003, 8, (5), 334–339.
3.
MetzbowerE. A., MoonD. W., FengC. R., LambrakosS. G. and WongR. J.: in ‘Mathematical modeling of weld phenomena’, (ed. H. Cerjak et al.), Vol. 7, 327–339; 2005, Graz, Graz University of Technology Publishing.
4.
MoonD. W., FengC. R.LambrakosS. G. and MetzbowerE. A.: Proc. 7th Int. Conf. on ‘Trends in welding research’, Pine Mountain, GA, USA, May 2005, ASM, 725–730.
5.
MetzbowerE. A. and MoonD. W.: Sci. Technol. Weld. Joining, 2007, 12, (2), 189–196.
6.
MetzbowerE. A. and MoonD. W.: ‘Mathematical modeling of weld phenomena’, Vol. 8; 2006, Graz, to be published.
