Abstract
Syngas produced from glycerol using aqueous phase reforming for nickel-based catalysts with different support materials were tested in a compression ignition (CI) engine. Experiments were conducted using nickel–alumina, nickel–lanthanum (NL), and nickel–ceria catalysts at 1:1, 1:2, 1:3, and 1:4 glycerol–water ratios and temperatures of 240°C, 260°C, and 280°C. The NL catalyst showed the highest syngas and hydrogen yield of 90.58% and 76.42%, respectively, at 1:3 ratio and 260°C. The optimized NL syngas and diesel were tested in a CI engine at 6 to 30 lpm flow rates. At 30 lpm flow, brake thermal efficiency increased by 3.15%, NOx emission was reduced by 21.22%, and smoke lowered significantly compared to diesel. The faster hydrogen combustion in syngas increased the heat release rate and cylinder peak pressure. CO and HC emissions increased at lower loads due to diluted combustion but reduced at higher loads. NL showed the best performance and emissions among the syngases due to higher hydrogen content. In summary, the NL syngas at 30 lpm showed great potential in CI engines by improving combustion and performance and reducing emissions.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
