Abstract
The target of this investigation is to illustrate the nonlinear fluid flow, heat transfer, and vortex formation phenomena in an orifice pulse tube refrigerator by numerical simulation. Numerical results confirm that jet streaming is generated at the low-temperature end of the pulse tube in between the junction of U-shaped tube and pulse tube. The primary vortex, which is generated due to the minor loss, continuously grows because of velocity change and eventually leads to the formation of secondary eddy. Consequently, flow straighteners have been adopted at the hot side of the regenerator, hot heat exchanger, and both sides of U-shaped tube. It is noticed that, jet streaming has been suppressed at the cold end of the pulse tube. Nevertheless, the streaming effect generated due to the oscillating flow of the gas parcels within the pulse tube, and third type of streaming have not been suppressed with the flow-straightener. Additionally, the numerical simulation shows different gas flow behaviors within the pulse tube that occurs due to the oscillating pressure pulse. An experimental investigation is conducted to compare experimental results with the numerical results and a valid agreement is observed between them.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
