Torque distribution of a four in-wheel motors electric vehicle based on a PMSM system model

Abstract

This study investigates a method for determining the torque distribution between front and rear in-wheel motors in an electric vehicle to improve energy efficiency. The method is based on an analytical model of the permanent magnet synchronous motor (PMSM) losses, which consist of the losses from electric motors and inverters. The loss model is used to analyze the optimal torque distribution ratio for minimum system losses. The analysis is conducted for two cases: the first is for identical motor parameter values of the front and rear wheels; the second is for different motor parameter values. For the first case, the results show that the even torque distribution between the front and rear wheels results in minimum system losses if the motor loss is a convex function of electromagnetic torque. When the motor parameters for the front and rear wheels are different, the optimal torque distribution coefficient depends on the motor parameters. To validate the analysis results, simulations of the four-motor drive system were conducted. Furthermore, the idle loss is added to the system efficiency data and a numerical optimization method is used to resolve the optimal distribution ratio. It is shown that the optimal solutions are consistent with the analytical results. Finally, the proposed method is validated through bench tests and vehicle dynamometer tests.

Keywords

Torque distribution energy efficiency four in-wheel motors electric vehicle permanent magnet synchronous motor loss model

Get full access to this article

View all access options for this article.

References

Zhang

et al . Hardware-in-the-loop simulation of pressure-difference-limiting modulation of the hydraulic brake for regenerative braking control of electric vehicles. Proc IMechE Part D: J Automobile Eng 2014; 6: 649–662.

Zhang

et al . Mechanism analysis and evaluation methodology of regenerative braking contribution to energy efficiency improvement of electrified vehicles. Energy Convers Manage 2015; 92: 469–482.

Mashadi

Ebrahimi

Marzbanrad

. Effect of front-wheel drive or rear-wheel drive on the limit handling behavior of passenger vehicles. Proc IMechE Part D: J Automobile Eng 2007; 4: 393–403.

Pennycott

Novellis

Sabbatini

et al . Reducing the motor power losses of a four-wheel drive, fully electric vehicle via wheel torque allocation. Proc IMechE Part D: J Automobile Eng 2014; 7: 830–839.

Zhang

Göhlich

. Improvement in the vehicle stability of distributed-drive electric vehicles based on integrated model-matching control. Proc IMechE Part D: J Automobile Eng 2018; 232(3): 341–356. DOI: 10.1177/0954407017701284.

Novellis

Sorniotti

Gruber

. Wheel torque distribution criteria for electric vehicles with torque-vectoring differentials. IEEE Trans Veh Technol 2014; 63: 1593–1602.

Park

Jeong

Jang

et al . Torque distribution algorithm for an independently driven electric vehicle using a fuzzy control method. Energies 2015; 8: 8537–8561.

Lin

. Wheel torque distribution of four-wheel-drive electric vehicles based on multi-objective optimization. Energies 2015; 8: 3815–3831.

Chen

Wang

. Design and experimental evaluations on energy efficient control allocation methods for overactuated electric vehicles: longitudinal motion case. IEEE/ASME Trans Mechatronics 2014; 2: 538–548.

10.

Chen

Wang

. Fast and global optimal energy-efficient control allocation with applications to over-actuated electric ground vehicles. IEEE Trans Control Syst Technol 2012; 5: 1202–1211.

11.

Zhang

Xing

. Optimized torque distribution control to achieve higher fuel economy of 4WD electric vehicle with four in-wheel motors. J Tongji Univ 2005; 33: 1355–1361.

12.

Yuan

Wang

. Torque distribution strategy for a front- and rear-wheel-driven electric vehicle. IEEE Trans Veh Technol 2012; 61: 3365–3374.

13.

Ouyang

et al . Torque distribution algorithm for permanent brushless DC hub motor for four-wheel drive electric vehicle. J Tsinghua Univ 2012; 52: 451–456.

14.

Ouyang

et al . Instantaneous optimal regenerative braking control for a permanent-magnet synchronous motor in a four-wheel-drive electric vehicle. Proc IMechE Part D: J Automobile Eng 2014; 228: 894–908.

15.

Kobayashi

Katsuyama

Sugiura

et al . Direct yaw moment control and power consumption of in-wheel motor vehicle in steady-state turning. Veh Syst Dyn 2017; 55: 104–120.

16.

Kobayashi

Katsuyama

Sugiura

et al . Efficient direct yaw moment control during acceleration and deceleration while turning (first report). SAE paper 2016-01-1674, 2016.

17.

Himeno

Katsuyama

Kobayashi

. Efficient direct yaw moment control during acceleration and deceleration while turning (second report). SAE paper 2016-01-1677, 2016.

18.

Zhang

Guo

. An accurate modeling for permanent magnet synchronous wheel motor including iron loss. SAE Int J Alt Power 2014; 1: 105–112.

19.

Bethoux

Laboure

Remy

et al . Real-time optimal control of a 3-phase PMSM in 2-phase degraded mode. IEEE Trans Veh Technol 2017; 3: 2044–2052.

20.

Deng

Zhao

. Energy efficiency improvement via bus voltage control of inverter for electric vehicles. IEEE Trans Veh Technol 2017; 66: 1063–1073.

21.

Fernandez-Bernal

Garcia-Cerrada

Faure

. Determination of parameters in interior permanent-magnet synchronous motors with iron losses without torque measurement. IEEE Trans Ind Appl 2001; 5: 1265–1272.

22.

Liu

Zhu

. Quantum genetic algorithm based parameter estimation of PMSM under variable speed control accounting for system identifiability and VSI nonlinearity. IEEE Trans Ind Electron 2015; 62: 2362–2371.

23.

Kolar

Ertl

Zach

. Influence of the modulation method on the conduction and switching losses of a PWM converter system. IEEE Trans Ind Appl 1991; 27: 1063–1075.

24.

Ikeda

Itsumi

Funato

. The power loss of the PWM voltage-fed inverter. In: 19th annual IEEE power electronics specialists conference, PESC’88 record, Kyoto, Japan, 11–14 April 1988, Vol. 1, pp.277–283. New York: IEEE.

25.

Zhou

et al . The control strategy of electronic differential for EV with four in-wheel motors. In: 2010 Chinese control and decision conference (CCDC), Xuzhou, China, 26–28 May 2010, pp.4190–4195. New York: IEEE.

26.

Song

Cui

. Study on improving the performance of permanent magnet wheel motor for the electric vehicle application. IEEE Trans Magn 2007; 1: 438–442.