A real gas-based throughflow method for the analysis of SCO 2 centrifugal compressors

Abstract

The supercritical carbon dioxide Brayton cycle is recognized as a promising candidate for the next generation of nuclear power and energy system. Among all the components in the cycle, the centrifugal compressor is one of the most important ones. This paper presents a streamline curvature throughflow method based on real gas properties and capable of dealing with condensation flows in the supercritical carbon dioxide compressors. A fluid thermodynamic property calculation method based on look-up tables is adopted to account for the real gas effects and fluid condensation and to reduce the computational time. For extending the simulation capability to the region below the saturation curve to assess the condensation possibility, the homogeneous equilibrium model is adopted. Finally, the real gas-based streamline curvature method is applied in the analysis of a supercritical carbon dioxide centrifugal compressor working near the critical point. Then, computational fluid dynamics calculations are performed to validate the method in detail. The results of the computational validation indicate that the real gas-based streamline curvature method presented in the paper can obtain an accurate enough flow field as that obtained by three-dimensional computational fluid dynamics simulations considering the coarse grid and the much less calculation time.

Keywords

streamline curvature throughflow method condensation flows

Get full access to this article

View all access options for this article.

References

Dostal V, Driscoll MJ and Hejzlar P. A supercritical carbon dioxide cycle for next generation nuclear reactors. PhD Thesis, Massachusetts Institute of Technology, Department of Nuclear Engineering, 2004.

McClung A, Brun K and Chordia L. Technical and economic evaluation of supercritical oxy-combustion for power generation. In: Fourth supercritical CO₂ power cycles symposium, Pittsburgh, PA, September 2014, pp.9–10.

Wright SA, Radel RF, Vernon ME, et al. Operation and analysis of a supercritical CO₂ Brayton cycle. Sandia Report, No. SAND2010-0171 2010.

Motoaki

Hiroshi

Takashi

. Demonstration test plant of closed cycle gas turbine with supercritical CO₂ as working fluid. J Strojarstvo 2010; 52: 459–465.

Cha JE, Bae SW, Lee J, et al. Operation results of a closed supercritical CO₂ simple Brayton cycle. In: The fifth international symposium-supercritical CO₂ power cycles, San Antonio, TX, 28–31 March 2016.

Brenes BM. Design of supercritical carbon dioxide centrifugal compressors. PhD Thesis, University of Seville, 2014. DOI: 10.1016/j.vetpar.2012.02.017.

Lee J, Lee JI, Ahn Y, et al. Design methodology of supercritical CO₂ Brayton cycle turbomachineries. In: Proceedings of the ASME turbo expo 2012: turbine technical conference and exposition, 11–15 June 2012, Copenhagen, Denmark.

Shao W, Wang X, Yang J, et al. Design parameters exploration for supercritical CO₂ centrifugal compressors under multiple constraints. In: Proceedings of the ASME turbo expo 2017: turbomachinery technical conference and exposition, Charlotte, NC, USA, 26–30 June 2017. ISBN 9780791849873. DOI: 10.1115/GT2016-56820.

Ameli A, Turunen-saaresti T and Backman J. Numerical investigation of the flow behavior inside a supercritical CO₂ centrifugal compressor. In: Proceedings of the ASME turbo expo 2016: turbomachinery technical conference and exposition, 13–17 June 2016, Seoul, South Korea.

10.

Hosangadi A, Weathers T, Liu Z, et al. Numerical simulations of CO₂ compressors at near-critical and sub-critical inlet conditions. In: Proceedings of the ASME turbo expo 2018: tubomachinery technical conference and exposition, 11–15 June 2018, Oslo, Norway.

11.

Pecnik

Rinaldi

Colonna

. Computational fluid dynamics of a radial compressor operating with supercritical CO₂. J Eng Gas Turbine Power 2012; 134: 122301–122301.

12.

Katsanis

. Use of arbitrary quasi-orthogonals for calculating flow distribution in the meridional plane of a turbomachine. NASA Tech Note 1964. DOI: 10.1115/1.3678504.

13.

Casey

Robinson

. A new streamline curvature throughflow method for radial turbomachinery. J Turbomach 2008; 6: 2119–2130.

14.

Novak

. Streamline curvature computing procedures for fluid-flow problems. J Eng Gas Turbine Power 1967; 89: 478–478.

15.

Marsh H. A digital computer program for the through-flow fluid mechanics in an arbitrary turbomachine using a matrix method. ARC R & M Report No 3509, 1968.

16.

Simon J and Léonard O. A throughflow analysis tool based on the Navier-Stokes equations. In: Proceedings of the sixth European turbomachinery conference, Lille, France, 7–11 March 2005.

17.

Stockman NO and Kramer JL. Method for design of pump impellers using a high-speed digital computer. NASA Technical Note, 1962.

18.

Jansen W. A method for calculating the flow in a centrifugal impeller when entropy gradient are present. Inst Mech Eng Internal Aerodynamics 1970.

19.

Stanitz JD and Prian VD. A rapid approximate method for determining velocity distribution on impeller blades of centrifugal compressors. NASA Technical Note, 1951.

20.

Span

Wagner

. A new equation of state for carbon dioxide covering the fluid region from the triple-point temperature to 1100 K at pressures up to 800 MPa. J Phys Chem Ref Data 1996; 25: 1509–1596.

21.

Shao W, Yang J, Du J, et al. Investigation on one-dimensional loss models for predicting performance of multistage centrifugal compressors in supercritical CO₂ Brayton cycle. J Therm Sci (Accepted for publication.).

22.

Ameli A, Afzalifar A, Turunen-saaresti T, et al. Effects of real gas model accuracy and operating conditions on supercritical CO₂ compressor performance and flow field. In: Proceedings of the ASME turbo expo 2017: tubomachinery technical conference and exposition, Charlotte, NC, USA, 26–30 June 2017.

23.

Patel

Diez

Pecnik

, et al. Turbulence modelling for flows with strong variations in thermo-physical properties. Int J Heat Fluid Flow 2018; 73: 114–123.

24.

Fuller RL and Eisemann K. Centrifugal compressor off-design performance for super-critical CO₂. In: Supercritical CO₂ power cycle symposium, 2011, pp.1–20.

25.

Lettieri

Paxson

Spakovszky

, et al. Characterization of nonequilibrium condensation of supercritical carbon dioxide in a de Laval nozzle. J Eng Gas Turbines Power 2017; 140: 041701–041701.

26.

Noall JS and Pasch JJ. Achievable efficiency and stability of supercritical CO₂ compression systems. In: Supercritical CO₂ power cycle symposium, Pittsburgh, PA, 9–10 September 2014.

27.

Kimball KJ and Clementoni EM. Supercritical carbon dioxide Brayton power cycle development overview. In: Proceedings of the ASME turbo expo 2013: turbine technical conference and exposition, San Antonio, TX, USA, 3–7 June 2013.

28.

Wilkinson DH. Paper 35: stability, convergence, and accuracy of two-dimensional streamline curvature methods using quasi-orthogonals. Proceedings of the Institution of Mechanical Engineers, Conference Proceedings 1969; 184: 108–126. DOI: 10.1243/PIME_CONF_1969_184_168_02.