An experimental investigation of micro-milling brass considering run out by carbide micro-end mills

Abstract

This paper presented the effect of run out on the experimental characteristic of micro-milling brass using carbide micro-end mills. A method of calculation and measurement for the run out of tool-holder-spindle assembly in micro-end mill was developed. A series of micro-milling process experiments were carried out under varying cutting parameters. The effect of run out on cutting forces, effect of cutting parameters on surface roughness, and size effect were analyzed. It was seen that the cutting force signature was seriously affected by run out in the micro-milling process. When the feed per tooth is less than the run out, the cutting force signals showed that only one cutter flute engaged in cutting process due to the effect of run out. It was also seen that the cutting force signature showed erratic variations due to the effect of tool–workpiece and the run out of tool tip at higher spindle speed. Surface roughness was affected by both cutting speed and feed per tooth. For lower cutting speed, there was increase in the surface roughness with the decrease in the cutting speed due to the effect of built-up edge. For higher cutting speed, there was increase in the surface roughness with the increase in the cutting speed due to dominance of the shearing effects. When the feed per tooth was less than the minimum chip thickness, due to the indentation and ploughing-dominated process, nonlinear increase of specific shear energy can be obtained. At lower feed per tooth, the specific energy increases with increased cutting speed. These results are used to provide strategies to optimize cutting parameters and achieve better surface quality in micro-milling brass process.