Dynamic precision analysis and experimental verification of high-speed precision punch press

Abstract

In order to investigate the impact factors and their affection on high-speed precision multilink punch press (MPP), the dynamic model with different joint clearance was established, and the influence of different clearance and speed on the dynamic positional repeatability of bottom dead center (BDC) was analyzed. The elastic dynamic model of high-speed MPP was established, the affection of the elastic deformation and elastic wave on the positional repeatability of the BDC were presented by using modal superposition method to solve dynamic equation. Meanwhile, experiments on the dynamic repeatability of the BDC of the punch during working were completed. At last, the comparison of the experimental results with the analyzed results was given, and based on which, it can be concluded that the clearance, elastic wave and deformation are the key factors of the dynamic repeatability precision of the BDC.

Keywords

Dynamic precision joint clearance elastic wave and deformation multilink punch press

Get full access to this article

View all access options for this article.

References

Khemili

Romdhane

. Dynamic analysis of a flexible slider-crank mechanism with clearance. Eur J Mech A/ Solids 2008; 27: 882–898.

Lee

Wang

. On the dynamics of intermittent-motion mechanisms, part 1: Dynamic model and response. J Mech Transm Autom Des 1983; 105: 534–540.

Flores

. A parametric study on the dynamic response of planar multibody systems with multiple clearance joints. Nonlin Dyn 2010; 61: 633–653.

Shi

Jin

. Dynamic simulation and modeling of revolute clearance joint for virtual prototyping. J Mech Eng 2009; 45: 299–303.

Dubowsky

. On predicting the dynamic effects of clearances in planar mechanisms. J Eng Ind ASME Ser B 1974; 6: 317–323.

Haines

. An experimental investigation into the dynamic behaviour of revolute joints with varying degrees of clearance. Mech Mach Theory 1985; 20: 221–231.

Miedema

Mansour

W M

. Mechanical joints with clearance: A three mode model. ASME J Eng Ind 1976; 98: 1319–1323.

Dubowsky

Freudenstein

. Dynamic analysis of mechanical system with clearances. Part I: Formation of dynamic model, Part II: Dynamic response. ASME J Eng Ind 1971; 93: 305–316.

Funabashi

Ogawa

Horie

. A dynamic analysis of mechanism with clearance. Bull JSME 1978; 21: 1652–1659.

10.

Furuhashi

Morita

. Research on dynamics of four-bar linkage with clearances at turning pairs. Bull JSME 1978; 21: 518–523.

11.

Wang

. New method for the dynamic modeling of compliant mechanism. J Mech Eng 2008; 44: 96–103.

12.

Mei

. Study on the dynamic modeling of a complex flexible hydraulic robot system carried by vehicle. China Mech Eng 2009; 21: 131–136.

13.

Smaili

. A three-node finite beam element for dynamic analysis of planar manipulators with flexible joints. Mech Mach Theory 1993; 28: 136–148.

14.

Sunda

Dubowsky

. On the dynamic analysis and behavior of industrial robotic manipulator with elastic members. J Mech Trans Autom Des 1983; 105: 183–196.

15.

Han

. Elastic dynamics analysis of Delta parallel robot. J Agric Mach 2011; 42: 197–202.

16.

Zhu

. Kinematic analysis of multi-link high-speed presses. China Mech Eng 2011; 122: 1296–1301.

17.

Zeng LB. Researches on key technologies of a novel high-speed toggle press. PhD Thesis, Nanjing University of Science and Technology, China, 2012.