Abstract
The machining response of metallurgically and mechanically modified materials when processed by employing the microwire electrical discharge machining (μWEDM) technology is reported in this paper. In particular, the effects of the material microstructure on resulting surface integrity of Al5000 series aluminium alloys after μWEDM processing is studied. The machining response of an ‘as received’ aluminium alloy was compared against the results obtained on samples processed through extrusion strain hardening and severe plastic deformation. Especially, the process–material effects on the resulting microhardness, phase content changes, heat-affected zone, surface roughness, microcracks, recast layer, material removal rate, and element spectrum after both rough and finishing μWEDM cuts were investigated. This study shows that an ultrafine grained (UFG) Al5083 exhibits not only superior mechanical properties but also the machining response to μWEDM is favourable. A reduction of the recast layer after μWEDM was observed when compared with ‘as received’ and ‘conventionally’ processed Al5083.