Experimental study on fire performance of double-skin glass facades

Abstract

This article presents an experimental study to investigate the fire performance of double-skin facades made with double glazing. First, preliminary tests were carried out to study the breakage of double glazing using a window assembly exposed to fires located in a small burn room. The glazing was 6-mm-thick toughened glass. The results show that at the time when the glass panes broke, the temperatures on the exposed surface of the first layer reached about 600°C–800°C. Second, a full-scale facility was built to study double-skin glass facades exposed to room fires as well as fire spread in the cavity. The internal skin was double glazing using 6-mm-thick glass, and the external skin was double glazing using 12-mm-thick glass with an intervening gel layer. Three fire scenarios with different heat release rates were tested. The temperatures on the outer glass of the internal skin and the inner glass of the external skin on the upper floor were lower than 300°C, which was not high enough to break the upper glass. For the fire scenario with a maximum heat release rate of 2.0 MW, the inner glass of the external skin broke on the first floor opposite to the fire source. The intervening gel layer ignited, and it caused failure of the external skin. The smoke could be exhausted directly to the atmosphere through the broken area on the external skin, and this helped to release the heat trapped in the cavity.

Keywords

Double-skin facade glass breakage full-scale fire test fire spread smoke movement

Get full access to this article

View all access options for this article.

References

Chow

. Building fire safety in the far east. Architect Sci Rev 2005; 48(4): 285–294.

Chow

Gao

Chow

. A review on fire safety in buildings with glass facade. J Appl Fire Sci 2006–2007; 16(3): 201–223.

Babrauskas

. Glass breakage in fires. Issaquah, WA: Fire Science and Technology Inc., 2010.

Shields

Silcock

GWH

Hassani

SKS

. The behavior of double glazing in an enclosure fire. J Appl Fire Sci 1997/1998; 7: 267–286.

Shields

Silcock

GWH

Flood

. Performance of a single glazing assembly exposed to a fire in the centre of an enclosure. Fire Mater 2002; 26: 61–75.

Shields

Silcock

GWH

Flood

. Behaviour of double glazing in corner fires. Fire Technol 2005; 41: 37–65.

Xie

Zhang

Wan

. Full-scale experimental study on crack and fallout of toughened glass with different thicknesses. Fire Mater 2008; 32: 293–306.

Mowrer

. Window breakage induced by exterior fires (NIST GCR 98-751). Gaithersburg, MD: National Institute of Standards and Technology, 1998.

Manzello

Gann

Kuckak

. An experimental determination of a real fire performance of a non-load bearing glass wall assembly. Fire Technol 2007; 43: 77–89.

10.

Richardson

Oleszkiewicz

. Fire tests on window assemblies protected by automatic sprinklers. Fire Technol 1987; 23: 115–132.

11.

Chow

Hung

. Effect of cavity depth on smoke spreading of double-skin facade. Build Environ 2006; 41(7): 970–979.

12.

Chow

. Full-scale burning tests on double-skin facade fires. Fire Mater 2012.

13.

Guo

. Performance-based fire safety analysis for a double skin facade (in Chinese). Fire Sci Technol 2004; 23(4): 341–344.

14.

National Institute of Science and Technology. Center mattress fire, http://www.fire.nist.gov/fire/fires/matt1/mat1.html (2010, accessed 1 February 2012).

15.

National Institute of Science and Technology. Corner mattress fire, http://www.fire.nist.gov/fire/fires/matt2/mat2.html (2010, accessed 1 February 2012).