An optical method for measuring surface roughness of machined carbon fibre-reinforced plastic composites

Abstract

Characterization of the damage induced by machining of fibre-reinforced composites is usually performed by measuring surface roughness. Contact-based surface profilometers are the most used equipment in industry; however, it has been found that there are performance limitations which may result when used to measure machined heterogeneous composite surfaces. In this research, surface roughness is characterised using a commercial non-contact optical method, and compared with a conventional stylus profilometer. Unidirectional and multidirectional carbon fibre laminates were edge trimmed and slot milled. The variation in surface roughness was compared using different tool types, fibre orientations and cutting parameters. Surface damage and cutting mechanisms were assessed by using scanning electron microscope images, and the suitability of roughness parameters were also analysed including: S_a, Skewness and Kurtosis. Using the optical system allowed accurate roughness calculation of individual plies on a multidirectional laminate with different fibre orientations. The research has also shown that the optical system, including the use of areal roughness parameters, can increase the accuracy of roughness measurement for machined fibrous composite surfaces and is less sensitive to measurement position than the stylus.