Carbon nanotube reinforced aluminum powders (Al-CNT) were fabricated by ball milling. The morphology observed by a scanning electron microscope showed impregnation of CNTs on the surface of aluminum flakes (Al-flakes). Polycarbonate (PC)/Al-CNT nanocomposites were prepared by a twin-screw extruder. The electrical resistivity of PC/Al-flake composites did not change with Al-flake content, while that of PC/CNT nanocomposites decreased with increasing CNT content, and the percolation threshold was obtained at 2 wt% CNT loading. The electrical resistivity of PC/Al-CNT nanocomposites showed a behavior similar to PC/CNT nanocomposites. The thermal conductivity of the composites increased with increasing filler contents. The PC/Al-CNT composites showed a viscosity trend that is similar to PC/CNT composites; however, it showed higher viscosities (G*, G") than PC/Al-flake composites in the low frequency range (up to ∼10 Hz) and lower viscosities in the higher frequency range (>10 Hz). The tensile modulus of PC/ Al-CNT composite increased while the strength decreased with increasing filler content. The modulus of PC/Al-CNT composite was higher than PC/CNT and PC/ Al-flake composites.
Curran, S.A. , Talla, J., Dias, S., Zhang, D., Carroll, D. and Birx, D. ( 2009). Electrical Transport Measurements of Highly Conductive Carbon Nanotube/Poly(Bisphenol A Carbonate) Composite, J. Appl. Phys., 105: 073711.
2.
Mormann, W. , Lu, Y., Zou, X. and Berger, R. ( 2008). Modification and Grafting of MultiWalled Carbon Nanotubes with Bisphenol-A-polycarbonate, Macromol. Chem. Phys., 209(20): 2113-2121.
3.
Wang, M., Pramoda, K.P. and Goh, S.H. ( 2006). Enhancement of Interfacial Adhesion and Dynamic Mechanical Properties of Poly(Methyl Methacrylate)/Multiwalled Carbon Nanotube Composites with Amine-terminated Poly(Ethylene Oxide), Carbon , 44: 613-617.
4.
Liu, J. , Rasheed, A., Minus, M.L. and Kumar, S. ( 2009). Processing and Properties of Carbon Nanotube/Poly(Methyl Methacrylate) Composite Films, J. Appl. Polym. Sci., 112(1): 142-156.
5.
Gojny, F.H. , Nastalczyk, J., Roslaniec, Z. and Schulte, K. ( 2003). Surface Modified Multiwalled Carbon Nanotubes in CNT/Epoxy-composites , Chem. Phys. Lett. , 370: 820.
6.
Wang, S., Liang, Z., Liu, T., Wang, B. and Zhang, C. ( 2006). Effective Amino-functionalization of Carbon Nanotubes for Reinforcing Epoxy Polymer Composites, Nanotechnology, 17(6): 1551-1557.
7.
Liu, L., Etika, K.C., Liao, K.-S., Hess, L.A., Bergbreiter, D.E. and Grunlan, J.C. ( 2009). Comparison of Covalently and Noncovalently Functionalized Carbon Nanotubes in Epoxy, Macromol. Rapid Comm., 30(8): 627-632.
8.
Yang Kai , Gu, M.G.Y., Pan , X. and Mu , G. (2009). Effects of Carbon Nanotube Functionalization on the Mechanical and Thermal Properties of Epoxy Composites , Carbon, 47(7): 1723-1737.
9.
Zhao, D., Hu, G., Justice, R., Schaefer, D.W., Zhang, S. and Yang, M. ( 2005). Synthesis and Characterization of Multi-walled Carbon Nanotubes Reinforced Polyamide 6 Via In situ Polymerization , Polymer, 46: 5125-5132.
10.
Yan, D. and Yang, G. (2009). Synthesis and Properties of Homogeneously Dispersed Polyamide 6/MWNTs Nanocomposites Via Simultaneous In situ Anionic Ring-opening Polymerization and Compatibilization , J. Appl. Polym. Sci., 112(6): 3620-3626.
11.
Li, J., Fang, Z., Tong, L., Gu, A. and Liu, F. ( 2007). Improving Dispersion of Multiwalled Carbon Nanotubes in Polyamide 6 Composites Through Amino-functionalization, J. Appl. Polym. Sci., 106(5): 2898-2906.
12.
Zhu, B.K. , Xie, S.H., Xu , Z.K. and Xu , Y.Y. (2006). Preparation and Properties of the Polyimide/Multi-walled Carbon Nanotubes (MWNTs) Nanocomposites, Compos . Sci. Technol., 66: 548-554.
13.
Zhang, Q., Naito, K. and Kagawa, Y. ( 2009). Functionalization of Multi-Walled Carbon Nanotubes with a Silane Coupling Agent and Synthesis of Polyimide Nanocomposite, J. Nanosci. Nanotechnol., 9(1): 267-274.
14.
Srivastava, R., Banerjee, S., Jehnichen , D., Voit, B. and Bohme, F. (2009). In situ Preparation of Polyimide Composites Based on Functionalized Carbon Nanotubes, Macromol. Mater. Eng., 294(2): 96-102.
15.
Shin, D.H., Yoon, K.H., Kwon, O.H., Min, B.G. and Hwang, C.I. ( 2006). Surface Resistivity and Rheological Behaviors of Carboxylated Multiwall Carbon Nanotube-filled PET Composite Film, J. Appl. Polym. Sci., 99: 900-904.
16.
Mun, S.J. , Jung, Y.M., Kim , J.-C. and Chang, J.-H. (2008). Poly(Ethylene Terephthalate) Nanocomposite Fibers with Functionalized Multiwalled Carbon Nanotubes Via In-situ Polymerization, J. Appl. Polym. Sci., 109(1): 638-646.
17.
Shen, L., Gao, X., Tong, Y., Yeh, A., Li, R. and Wu, D. ( 2008). Influence of Different Functionalized Multiwall Carbon Nanotubes on the Mechanical Properties of Poly(Ethylene Terephthalate) Fibers , J. Appl. Polym. Sci., 108(5): 2865-2871.
18.
Dong, S.R., Tu, J.P. and Zhang, X.B. ( 2001). An Investigation of the Sliding Wear Behavior of Cu-matrix Composite Reinforced by Carbon Nanotubes, Mater. Sci. Eng. A, 313: 83-87.
19.
Chen, X., Xia, J., Peng, J., Li, W. and Xie, S. ( 2000). Carbon-nanotube Metal-matrix Composites Prepared by Electroless Plating, Compos. Sci. Technol., 60: 301-306.
20.
Esawi, A. and Morsi, K. ( 2007). Dispersion of Carbon Nanotubes (CNTs) in Aluminum Powder , Composites, 38: 646-650.
21.
Elimat, Z.M. , Zihlif, A.M. and Ragosta, G. ( 2008). Study of AC Electrical Properties of Aluminium-Epoxy Composites, J. Phys. D: Appl. Phys., 41(16): 155001.
22.
Hong, S.H., Lee, D.W. and Kim, B.K. ( 2000). Manufacturing of Aluminum Flake Powder from Foil Scrap by Dry Ball Milling Process, J. Mater. Proc. Technol. , 100: 105-109.
23.
Chen, L., Pang, X.J. and Yu, Z.L. ( 2007). Study on Polycarbonate/Multi-walled Carbon Nanotubes Composite Produced by Melt Processing, Mater. Sci. Eng. A , 457: 287-291.
24.
Satapathy, B.K. , Weidisch, R., Pötschke , P. and Janke, A. (2007). Tough-to-brittle Transition in Multiwalled Carbon Nanotube (MWNT)/Polycarbonate Nanocomposites, Compos . Sci. Technol., 67: 867-879.
25.
Pötschke, P., Fornes, T.D. and Paul, D.R. (2002). Rheological Behavior of Multiwalled Carbon Nanotube/Polycarbonate Composites , Polymer, 43: 3247-3255.
26.
Berber, S., Kwon, Y.K. and Tomanek, D. ( 2000). Unusually High Thermal Conductivity of Carbon Nanotubes , Phys. Rev. Lett., 84: 4613-4616.
27.
Mark, J.E. (ed.) (2009 ). Polymer Data Handbook, 2nd edn, p. 481, Oxford University Press, Oxford.
28.
Callister, W.D. (2003). Materials Science and Engineering , 6th edn, p. 755, John Wiley & Sons, New York.
29.
Kim, P. , Shi, L., Majumdar , A. and McEuen , P.L. (2001). Thermal Transport Measurements of Individual Multiwalled Nanotubes, Phys. Rev. Lett., 87: 215502.
30.
Lee, S.H. , Cho, E., Jeon , S.H. and Youn, J.R. (2007). Rheological and Electrical Properties of Polypropylene Composites Containing Functionalized Multi-walled Carbon Nanotubes and Compatibilizers, Carbon, 45: 2810-2822.
31.
Sung, Y.T., Han, M.S., Song, K.H., Jung, J.W., Lee, H.S., Kum, C.K., Joo, J. and Kim, W.N. ( 2006). Rheological and Electrical Properties of Polycarbonate/Multi-walled Carbon Nanotube Composites, Polymer, 47: 4434-4439.
