A Refined Quasi-microstructure Model for Finite Element Analysis of Three-dimensional Braided Composites Under Ballistic Penetration

Abstract

The nondelamination characteristics of three-dimensional (3-D) braided composites under ballistic impact makes them possess considerable potential in ballistic protection applications. However, there are only a few references concerning the calculation of ballistic properties of these composites, and all are based on the continuum assumption of composite materials. In this paper, a refined quasi-microstructure model constructed with crossed inclined laminae of the same braided yarn with the same diameter and fiber volume fraction as in the 3-D braided composite at the actual microstructure level is established to analyze the ballistic penetration of 3-D braided composites target by a rigid projectile. The calculated results of the finite element analysis (FEA) are conservative to estimate the penetration resistance of the composite. From the acceleration-time history of the projectile and the damage morphology of the 3-D braided composite in FEA, it is indicated that the refined quasi-microstructure model can approximately simulate the real ballistic impact damage of these composites. The original ideas of this refined quasi-microstructure model are the scheme of decomposing the 3-D braided composite with the inclined lamina at its actual microstructure level and the adoption of constitutive equations of the reinforced fibers at a high strain rate. This model can also be extended to calculate the ballistic penetration of other 3-D textile preform-reinforced composites by rigid projectiles.

Keywords

three-dimensional braided composites refined quasi-microstructure model ballistic penetration FEM

Get full access to this article

View all access options for this article.

References

Mouritz, A.P. , Bannister, M.K. , Falzon, P.J. et al. (1999). Review of Applications for Advanced Three-dimensional Fibre Textile Composites , Composites: Part A, 30: 1445-1461 .

Flanagan, M.P. , Zikry, M.A. , Wall, J.W. et al. (1999). An Experimental Investigation of High Velocity Impact and Penetration Failure Modes in Textile Composites , Journal of Composite Materials, 33(12): 1080-1103 .

Baucom, J.N. and Zikry, M.A. (2003). Evolution of Failure Mechanisms in 2D and 3D Woven Composite Systems Under Quasi-static Perforation , Journal of Composite Materials, 37(18): 1651-1674 .

Jenq, S.T. and Mao, J.J. (1996). Ballistic Impact Response for Two-step Braided Three-dimensional Textile Composites , AIAA J., 34(2): 375-384 .

Jenq, S.T. , Kuo, J.T. and Sheu, L.T. (1998). Ballistic Impact Response of 3-D Four-step Braided Glass/Epoxy Composites , Key Engineering Materials, 141-143: 349-366 .

Xu, J. and Gu, B. (2002). Damage Pattern and Failure Mode of 3-dimensional Composites Under Ballistic Impact , Journal of Ballistics, 14(2): 39-43 (in Chinese).

Gu, B. and Xu, J. (2004). Finite Element Calculation of 4-step 3-dimensional Braided Composite Under Ballistic Perforation , Composites: Part B, 35(4): 291-297 .

Yang, J.M. , Ma, C.L. and Chou, T.W. (1986). Fiber Inclination Model of 3-D Textile Structural Composites , Journal of Composite Materials, 20(9): 472-484 .

Chou, T.W. (1992). Microstructural Design of Fiber Composites, pp. 389-422, Cambridge University Press, Cambridge .

10.

Potluri, P. , Rawal, A. , Rivaldi, M. and Porat, I. (2003). Geometrical Modelling and Control of a Triaxial Braiding Machine for Producing 3D Preforms , Composites: Part A, 34: 481-492 .

11.

Belytschko, T. , Liu, W.K. and Moran, B. (2000). Nonlinear Finite Elements for Continua and Structures, John Wiley & Sons Ltd, New York .

12.

Wang, Y. and Sun, X. (2001). Digital-element Simulation of Textile Processes , Composites Science and Technology, 61: 311-319 .

13.

Kessels, J.F.A. and Akkerman, R. (2002). Prediction of the Yarn Trajectories on Complex Braided Preforms , Composites: Part A, 33: 1073-1081 .

14.

Chen, L. , Tao, X.M. and Choy, C.L. (1999). Mechanical Analysis of 3-D Braided Composites by the Finite Multiphase Element Method , Composites Science and Technology, 59: 2383-2391 .

15.

Sun, H.Y. and Qiao, X. (1997). Prediction of the Mechanical Properties of 3-dimensional Braided Composites , Composites Science and Technology, 57: 623-629 .

16.

Hallquist, J.O. (1998). Ls-Dyna Theoretical Manual, Vol. 5, pp. 19.1-19.2, Livermore Software Technology Corporation .

17.

Staab, G.H. (1999). Laminar Composite, p. 135, Butterworth-Heinemann Publications, Boston, MA, USA .

18.

Gu, B. (2004). Ballistic Penetration of Conically Cylindrical Steel Projectile into Plain-woven Fabric Target - A Finite Element Simulation , Journal of Composite Materials, 38: 2049-2074 .