The microstructural evolution and deformation behaviour of Fe-(13, 16, 18)Mn-8Al-0.8C (wt-%) low-density steels were investigated in the present work. During aging treatment, the increase in the volume fraction of κ’-carbides significantly improved the yield strength. The formation of κ/α lamellae increased the strain hardening rate. However, large fractions of intergranular κ-carbides deteriorated the ductility of the materials. Mn element stabilised austenite, restricted the precipitation of intergranular κ-carbides and delayed the formation of intragranular κ’-carbides, leading to the uniform distribution of the strain. Increasing Mn content also postponed the peak aging. A good balance of strength and ductility can be achieved by short-time aging treatment in the low-Mn steels or long-time aging treatment in the high-Mn steels.
ChenSRanaRHaldarACurrent state of Fe-Mn-Al-C low density steels. Prog Mater Sci. 2017; 89:345–391. doi: 10.1016/j.pmatsci.2017.05.002
2.
YooJDHwangSWParkKT.Origin of extended tensile ductility of a Fe-28Mn-10Al-1C steel. Metall Mater Trans A. 2009; 40(7):1520–1523. doi: 10.1007/s11661-009-9862-9
3.
ZambranoOA.A general perspective of Fe–Mn–Al–C steels. J Mater Sci. 2018; 53(20):14003–14062. doi: 10.1007/s10853-018-2551-6
4.
LiuDCaiMDingHControl of inter/intra-granular κ-carbides and its influence on overall mechanical properties of a Fe-11Mn-10Al-1.25C low density steel. Mater Sci Eng: A. 2018/02/07/; 715:25–32. doi: 10.1016/j.msea.2017.12.102
5.
ChoiKSeoC-HLeeHEffect of aging on the microstructure and deformation behavior of austenite base lightweight Fe–28Mn–9Al–0.8C steel. Scr Mater. 2010; 63(10):1028–1031. doi: 10.1016/j.scriptamat.2010.07.036
6.
YaoMJWelschEPongeDStrengthening and strain hardening mechanisms in a precipitation-hardened high-Mn lightweight steel. Acta Mater. 2017/11/01/2017; 140:258–273. doi: 10.1016/j.actamat.2017.08.049
7.
FengYSongRPeiZEffect of aging isothermal time on the microstructure and room-temperature impact toughness of Fe–24.8Mn–7.3Al–1.2C austenitic steel with κ-carbides precipitation. Met Mater Int. 2018 September 01;24(5):1012–1023. doi: 10.1007/s12540-018-0112-9
8.
ChooWKKimJHYoonJC.Microstructural change in austenitic Fe-30.0wt%Mn-7.8wt%Al-1.3wt%C initiated by spinodal decomposition and its influence on mechanical properties. Acta Mater. 1997/12/01/; 1997; 45(12):4877–4885. doi: 10.1016/S1359-6454(97)00201-2
9.
WuZQDingHAnXHInfluence of Al content on the strain-hardening behavior of aged low density Fe–Mn–Al–C steels with high Al content. Mater Sci Eng A. 2015; 639:187–191. doi: 10.1016/j.msea.2015.05.002
10.
SongWZhangWvon AppenJ. κ-phase formation in Fe-Mn-Al-C austenitic steels. Steel Res Int. 2015; 86(10):1161–1169. doi: 10.1002/srin.201400587
11.
LeeKParkS-JLeeJEffect of aging treatment on microstructure and intrinsic mechanical behavior of Fe–31.4Mn–11.4Al–0.89C lightweight steel. J Alloys Compd. 2016; 656:805–811. doi: 10.1016/j.jallcom.2015.10.016
12.
ChengW-CSongY-SLinY-SOn the eutectoid reaction in a quaternary Fe-C-Mn-Al Alloy: austenite → Ferrite + Kappa-carbide + M23C6 carbide. Metall Mater Trans A. 2013; 45(3):1199–1216. doi: 10.1007/s11661-013-2083-2
13.
ChengW-C.Phase transformations of an Fe-0.85 C-17.9 Mn-7.1 Al austenitic steel after quenching and annealing. Jom. 2014 Sep;66(9):1809–1820. doi: 10.1007/s11837-014-1088-7
ParkK-TJinKGHanSHStacking fault energy and plastic deformation of fully austenitic high manganese steels: effect of Al addition. Mater Sci Eng A. 2010; 2010/06/25/527(16):3651–3661. doi: 10.1016/j.msea.2010.02.058
16.
Standard Practice for X-Ray determination of retained austenite in steel with near random crystallographic orientation. ASTM International.
17.
SohnSSLeeSLeeBJMicrostructural developments and tensile properties of lean Fe-Mn-Al-C lightweight steels. Jom. 2014; 66(9):1857–1867. doi: 10.1007/s11837-014-1128-3
18.
JeongJLeeC-YParkI-JIsothermal precipitation behavior of κ-carbide in the Fe–9Mn–6Al–0.15C lightweight steel with a multiphase microstructure. J Alloys Compd. 2013;2013/10/15/; 574:299–304. doi: 10.1016/j.jallcom.2013.05.138
19.
SeolJ-BRaabeDChoiPDirect evidence for the formation of ordered carbides in a ferrite-based low-density Fe-Mn-Al-C alloy studied by transmission electron microscopy and atom probe tomography. Scr Mater. 2013 Mar;68(6):348–353. doi: 10.1016/j.scriptamat.2012.08.013
20.
KimCWKwonSILeeBHAtomistic study of nano-sized κ-carbide formation and its interaction with dislocations in a cast Si added FeMnAlC lightweight steel. Mater Sci Eng A. 2016; 673:108–113. doi: 10.1016/j.msea.2016.07.029
21.
AdlerPHOlsonGBOwenWS.Strain hardening of Hadfield manganese steel. Metall and Mater Trans A. 1986; 1986/10/01; 17(10):1725–1737. doi: 10.1007/BF02817271
22.
CurtzeSKuokkalaVTOikariAThermodynamic modeling of the stacking fault energy of austenitic steels. Acta Mater. 2011; 2011/02/01/59(3):1068–1076. doi: 10.1016/j.actamat.2010.10.037
23.
AllainSChateauJPBouazizOCorrelations between the calculated stacking fault energy and the plasticity mechanisms in Fe–Mn–C alloys. Mater Sci Eng A. 2004; 2004/12/15/387–389:158–162. doi: 10.1016/j.msea.2004.01.059
24.
DingHHanDCaiZMicrostructures and mechanical behavior of Fe-18Mn-10Al-(0.8-1.2)C steels. Jom. 2014; 66(9):1821–1827. doi: 10.1007/s11837-014-1063-3
25.
YooJDParkK-T.Microband-induced plasticity in a high Mn–Al–C light steel. Mater Sci Eng A. 2008; 496(1–2):417–424. doi: 10.1016/j.msea.2008.05.042
26.
SongHLeeSGSohnSSEffect of strain-induced age hardening on yield strength improvement in ferrite-austenite duplex lightweight steels. Metall Mater Trans A. 2016; 47(11):5372–5382. doi: 10.1007/s11661-016-3706-1
CalcagnottoMPongeDDemirEOrientation gradients and geometrically necessary dislocations in ultrafine grained dual-phase steels studied by 2D and 3D EBSD. Mater Sci Eng A. 2010;2010/04/25/527(10):2738–2746. doi: 10.1016/j.msea.2010.01.004
29.
SohnSSLeeBJLeeSEffects of aluminum content on cracking phenomenon occurring during cold rolling of three ferrite-based lightweight steel. Acta Mater. 2013 Sep;61(15):5626–5635. doi: 10.1016/j.actamat.2013.06.004
