An example of integrating a single research problem over a broad range of topics in a graduate-level course in applied elasticity (advanced strength of materials) is given in this paper. The research problem was obtained from an investigation of failures during the assembly of fulcrums of bascule bridges. Topics exemplified by using this problem included interference fits, axisymmetric problems, transformation of strains and stresses, comparison of failure theories, and the effect of temperature-dependent thermoelastic properties.
ShigleyJ. E. and MischkeC., ‘Limits and fits’, in Standard Handbook of Machine Design (McGraw Hill, New York, 1986).
2.
DenningerM., Design Tools for Trunnion Hub Girder Assemblies for Bascule Bridges, MS thesis, Mechanical Engineering Department, University of South Florida, Tampa, FL, USA (2000).
3.
RatnamB., Parametric Finite Element Modeling of Trunnion Hub Girder Assemblies for Bascule Bridges, MS thesis, Mechanical Engineering Department, University of South Florida, Tampa, FL, USA (2000).
4.
NichaniS., Full Scale Testing of Trunnion—Hub—Girder Assembly of a Bascule Bridge, MS thesis, Mechanical Engineering Department, University of South Florida, Tampa, FL, USA (2001).
UguralA. C. and FensterS. K., Advanced Strength and Applied Elasticity (Prentice Hall, New York, 1995).
7.
ConwayH. D. and FarnhamK. A., ‘Contact stresses between cyclindrical shafts and sleeves’, International Journal of Engineering Science, 5 (1967), 541–554.
8.
GreenbergH. D. and ClarkW. G.Jr, ‘A fracture mechanics approach to the development of realistic acceptance standards for heavy walled steel castings’, Metals Engineering Quarterly (August 1969), 30.
9.
RobertsonJ. S., Engineering Mathematics with Maple (McGraw-Hill, New York, 1996).
