Off-axis estimation of lay-up orientation in CFRP laminated composites using eddy current testing

Abstract

This paper presents a traditional eddy current testing (ET) method to estimate the off-axis of lay-up in the cross-ply and multidirectional carbon fiber reinforced polymer (CFRP) laminates. The transmitter receiver (TR) probe equipped with two identical circular coils was utilized to scan surface of the CFRPs with artificially induced off-axis layers in different depths. A 2D fast Fourier transform (2D-FFT) was applied to the C-scan experimental images for determining the layer orientation. It was observed that several highlighted lines are located at different directions in the Fourier transform images, which correspond to the higher energy and indicate a periodicity in the corresponding direction. From these images, the layer orientation with a minimum −5° off-axis was measured, and the actual fibers direction 40° can be obtained by subtracted 90° from the frequency angle in the Fourier transform image. Additionally, mechanism of the output signal change caused by the off-axis lamina was analyzed using the finite element (FE) analysis. Numerical results showed that deformation of the space magnetic field occurs because of the redistribution eddy current induced in the off-axis lamina, which implies the possibility to measure and estimate the deviated fibers orientation of the CFRPs using the traditional ET method.

Keywords

Eddy current testing carbon fibers lay-up orientation off-axis electrical properties

Get full access to this article

View all access options for this article.

References

and Qiu

, Effects of interlaminar electrical behavior on eddy currents in carbon fiber composite materials, in: Proceedings of IEEE Far East NDT New Technology & Application Forum, 2017, pp. 133–137.

Cheng

Qiu

and Xu

, Research advances in eddy current testing for maintenance of carbon fiber reinforced plastic composites, International Journal of Applied Electromagnetics and Mechanics 51 (2016), 261–284.

Sadeghian

Rahai

and Ehsani

, Effect of fiber orientation on nonlinear behavior of cfrp composites, Journal of Reinforced Plastics and Composites 28 (2009), 2261–2272.

Tanaka

Ikeda

and Senba

, Sensitivity analysis of thermal deformation of cfrp laminate reflector due to fiber orientation error, in: 3rd International Conference on Materials and Reliability, 2015, pp. 31–32.

Kawai

and Suda

, Effects of non-negative mean stress on the off-axis fatigue behavior of unidirectional carbon/epoxy composites at room temperature, Journal of Composite Materials 38 (2004), 833–854.

Yokozeki

Ogasawara

and Ishikawa

, Nonlinear behavior and compressive strength of unidirectional and multidirectional carbon fiber composite laminates, Composites Part A 37 (2006), 2069–2079.

Lange

and Mook

, Structural analysis of cfrp using eddy current methods, NDT & E International 27 (1994), 241–248.

Dodd

and Deeds

, Analytical solutions to eddy current probe coil problems, Journal of Applied Physics 39 (1968), 2829–2838.

Cheng

Qiu

and Uchimoto

, Application of low frequency ECT method in noncontact detection and visualization of CFRP material, Composites Part B: Engineering 110 (2017), 141–152.

10.

Bardl

Nocke

and Klein

, Automated detection of yarn orientation in 3D-draped carbon fiber fabrics and preforms from eddy current data, Composites Part B: Engineering 96 (2016), 312–324.

11.

Pratap

and Weldon

, Eddy currents in anisotropic composites applied to pulsed machinery, IEEE Transactions on Magnetics 32 (1996), 437–444.