Flow-Through Fourier Transform Infrared Sensor for Total Hydrocarbons Determination in Water

Abstract

A new flow-through Fourier transform infrared (FT-IR) sensor for oil in water analysis based on solid-phase spectroscopy on octadecyl (C18) silica particles has been developed. The C18 non-polar sorbent is placed inside the sensor and is able to retain hydrocarbons from water samples. The system does not require the use of chlorinated solvents, reducing the environmental impact, and the minimal sample handling stages serve to ensure sample integrity whilst reducing exposure of the analyst to any toxic hydrocarbons present within the samples. Fourier transform infrared (FT-IR) spectra were recorded by co-adding 32 scans at a resolution of 4 cm⁻¹ and the band located at 1462 cm⁻¹ due to the CH₂ bending was integrated from 1475 to 1450 cm⁻¹ using a baseline correction established between 1485 and 1440 cm⁻¹ using the areas as analytical signal. The technique, which provides a limit of detection (LOD) of 22 mg L⁻¹ and a precision expressed as relative standard deviation (RSD) lower than 5%, is considerably rapid and allows for a high level of automation.

Keywords

Fourier transform infrared sensor FT-IR spectroscopy Hydrocarbons Oil-in-water analysis Solid-phase spectroscopy Sequential injection

Get full access to this article

View all access options for this article.

References

US EPA Method 1664; Oil and Grease, Method 1664, Revision A: “n-hexane extractable material (HEM; Oil and Grease) and silica gel treated n-hexane extractable material (SGT-HEM; non-polar material) by extraction and gravimetry (United States Environmental Protection Agency, Office of Water, EPA-821-R-98-002, 1999).

Lambert

Fingas

and Goldthorp

, *J. Hazard. Mater. 83, 65 (2001).

US EPA Method 418.1; Petroleum Hydrocarbons, Total Recoverable for determining total petroleum hydrocarbons (TPH) in water. United States Environmental Protection Agency, Methods for Chemical Analysis of Water and Wastes (EPA 600/4-79-020, Revised March 1983).

Hayakawa

Yoneda

Okamoto

Kumamaru

and Ikeda

, Anal. Sci. 15, 803 (1999).

ASTM International Method D7066–04 Standard Test Method for dimer/trimer of chlorotrifluoroethylene (S-316) Recoverable Oil and Grease and Nonpolar Material by Infrared Determination.

Barwick

V. J.

Ellison

S. L.

Rafferty

M. J. Q.

and Farrant

T. J

, Int. J. Environ. Anal. Chem. 72, 235 (1998).

Farmaki

Kaloudis

Dimitrou

Thanasoulias

Kousouris

and Tzoumerkas

, Desalination 210, 52 (2007).

Lambert

, J. Hazard. Mater. 102, 39 (2003).

Kourti

, “Turbidimetry in Particle Size Analysis”, in Encyclopedia of Analytical Chemistry, Meyers

R. A.

Ed. (John Wiley and Sons, New York, 2006).

10.

Sontum

P. C.

Kolderup

E. M.

and in't Veldt

, J. Pharm. Biomed. Anal. 15, 1641 (1997).

11.

Weisman

W. H.

, Analysis of Petroleum Hydrocarbons in Environmental Media (Amherst Scientific Publishers, MA, 1998), vol. 1.

12.

Daghbouche

Garrigues

Morales-Rubio

and De la Guardia

, Anal. Chim. Acta 345, 161 (1997).

13.

Minty

Ramsey

E. D.

Davies

James

D. I.

O'Brien

P. M.

and Littlewood

M. I

, Anal. Commun. 35, 277 (1998).

14.

Haaland

D. M.

Han

and Niemczyk

T. M

, Appl. Spectrosc. 53, 390 (1999).

15.

Roy

E. G.

Jiang

Wells

M. L.

and Tripp

, Anal. Chem. 80, 4689 (2008).

16.

Alcudia-Leon

M. C.

Lucena

Cardenas

and Valcarcel

, Anal. Chem. 80, 1146 (2008).

17.

Armenta

and Lendl

, Vib. Spectrosc., paper in press, (2009), *doi:10.1016/j.vibspec.2008.10.004.

18.

*APHA, AWWA, and WEF, Standard Methods for the Examination of Water and Wastewater (American Health Public Association, Washington, D.C., 2000), 20th ed.

19.

Krupcík

Oswald

Oktavec

and Armstrong

D. W

, Water Air Soil Pollut. 153, 329 (2004).

20.

ISO 9377–2: 2000 Water quality. Determination of hydrocarbon oil index. Part 2. Method using solvent extraction and gas chromatography, International Organization for Standardization, (Geneva, Switzerland, 2000).

21.

Coenen

and De Kruif

C. G

, J. Colloid Interf. Sci. 124, 104 (1988).