Full-Load Converter Connected Asynchronous Generators for MW Class Wind Turbines

Abstract

Wind turbines equipped with full-load converter-connected asynchronous generators are a known concept. These have rating up to hundreds of kW and are a feasible concept for MW class wind turbines and may have advantages when compared to conventional wind turbines with directly connected generators.* The concept requires the use of full-scale frequency converters, but the mechanical gearbox is smaller than in conventional wind turbines of the same rating. Application of smaller gearbox may reduce the no-load losses in the wind turbines, which is why such wind turbines with converter connected generators may start operation at a smaller wind speed. Wind turbines equipped with such converted connected asynchronous generators are pitch-controlled and variable-speed. This allows better performance and control. The converter control may be applied to support the grid voltage at short-circuit faults and to improve the fault-ride-through capability of the wind turbines, which makes the concepts relevant for large wind farms. The Danish transmission system operator Energinet-DK has implemented the general model of wind turbines equipped with converter connected asynchronous generators with the simulation tool Powerfactory (DlgSilent). The article presents Energinet-DK's experience of modeling this feasible wind turbine concept.

Keywords

wind turbine variable-speed converter connected asynchronous generator pitch control converter control fault-ride-through

Get full access to this article

View all access options for this article.

References

Akhmatov

(2005). Modeling and fault-ride-through operation of wind turbines with converter connected asynchronous generators, 5th International Workshop on Large-Scale Integration of Wind Power and Transmission Networks for Offshore Wind Farms, Glasgow, Scotland, 8 p.

Akhmatov

Kundsen

Nielsen

A.H.

(2000). Advanced simulation of windmills in the electric power supply, Electrical Power and Energy Systems, vol. 22, No. 6 pp. 421–434.

Akhmatov

, (2006). Induction Generators for Wind Power, to be published by Multi-Science Publishing Company, London, U.K.

Eltra (2004). Wind Turbines Connected to Grids with Voltages above 100 kV – Technical regulations for the Properties and the Control of Wind Turbines, Eltra, Transmission System Operator of Western Denmark, Technical Regulations TF 3.2.5, 35 p, available on: www.eltra.dk.

Hansen

A.D.

Jauch

Sørensen

Lov

Blaabjerg

(2004). Dynamic wind turbine models in power system simulation tool DigSilent, Risø-R-1400(EN), Risø National Laboratory, Roskilde, Denmark.

Holdsworth

Charalambous

Ekanayake

J.B.

Jenkins

(2004). Power system fault ride through capabilities of induction generator based wind turbines, Wind Engineering, Vol. 28, No. 4, pp. 399–409.

Kojabadi

H.M.

Chang

(2004). A novel steady state wind turbine simulator using an inverter controlled induction motor, Wind Engineering, Vol. 28, No. 4, pp. 433–444.

Miler

Muljadi

Zinger

D.S.

(1997). A variable speed wind turbine power control, IEEE Transactions on Energy Conversion, vol. 12, No. 2, pp. 181–186.

Thiringer

Linders

(1993). Control by variable rotor speed of a fixed-pitch wind turbine operating in a wide speed range, IEEE Transactions on Energy Conversion, vol. 8, No. 3, pp. 520–526.

10.

Wang

Chang

(2001). PWM control strategies for wind turbine inverters, Wind Engineering, Vol. 25, No. 1, pp. 33–40.