Dynamic lubrication characteristics between a piston and a cylinder in an axial piston pump and motor have been calculated under mixed-lubrication conditions. The calculated results have shown that half-frequency whirling of the piston occurs under some operating conditions and specifications such as low supply pressure, narrow clearance and long sealing length between the piston and the cylinder, in a manner similar to the oil whirl phenomenon in journal bearings. The whirl phenomenon has been confirmed by measurements of piston motion.
YamaguchiA.Motion of piston in piston pumps and motors (1st Report, In Case of metallic contact) (in Japanese)Trans Japan Soc. Mech. Engrs B, 1989, 55, 3122–3128.
2.
YamaguchiA.Motion of piston in piston pumps and motors (2nd Report, Piston with hydrostatic pads) (in Japanese)Trans Japan Soc. Mech. Engrs B, 1991, 57, 1689–1694.
3.
FangY.ShirakashiM.Mixed lubrication characteristics between the piston and cylinder in hydraulic piston pump-motorTrans ASME, J. Tribology, 1995, 117, 80–85.
4.
KyogokuK.HamamuraY.NaganumaT.NakaharaT.Lubrication of oil-hydraulic piston pump/motor. Part 1: Measurement of piston friction force (in Japanese)J. JST, 1990, 35, 914–921.
5.
KyogokuK.NaganumaT.HamamuraY.NakaharaT.Lubrication of oil-hydraulic piston pump/motor. Part 2: Measurement of oil film thickness between piston and cylinder (in Japanese)J. JST, 1991, 36, 28–35.
6.
TanakaK.NakaharaT.KyogokuK.Piston rotation and frictional forces between piston and cylinder of piston pump and motor. In Proceedings of the JHPS International Symposium onFluid Power, Tokyo, Japan, 1993, pp. 235–240.
7.
RohdeS. M.A mixed friction model for dynamically loaded contacts with application to piston ring lubrication. In Proceedings of the Annual Meeting of the ASME, 1980, pp. 262–278 (American Society of Mechanical Engineers, New York).
8.
TanakaK.KyogokuK.NakaharaT.Lubrication characteristics on sliding surfaces in a piston pump and motor during running-in tests In Hydraulic Failure Analysis: Fluids, Components and System Effects, ASTM STP 1339, 2001, pp. 46–58 (American Society for Testing and Materials, Philadelphia, Pennsylvania).
9.
Ivantysyn and IvantysynovaHydrostatic Pumps and Motors, 2001 (Abi, New Delhi).
10.
PatirN.ChengH. S.An average flow model for determining effects of three-dimensional roughness on partial hydrodynamic lubricationTrans ASME, J. Lubric. Technol., 1978, 100, 12–17.
11.
PatirN.ChengH. S.Application of average flow model to lubrication between rough sliding surfacesTrans ASME, J. Lubric. Technol., 1979, 101, 220–230.
12.
KazamaT.YamaguchiA.Application of a mixed lubrication model for hydrostatic thrust bearings of hydraulic equipmentTrans ASME, J. Tribology, 1993, 115, 686–691.
13.
GreenwoodJ. A.TrippJ. H.The contact of two nominally flat rough surfacesProc. Instn Mech. Engrs, 1970, 185 (48/71), 625–633.
