Local two-point conductivity probe and film-thickness probes were developed for measurement of two-phase flow parameters in a packed bed containing spherical packing. The probes were calibrated and installed in a packed bed with minimal flow disturbance. A flush and two parallel wire film-thickness probes were used to measure the liquid film thickness on the packing. The conductivity probe and impedance meter were used to measure local and bed wise void fraction, respectively, for trickle, wavy, transitional, pulsing, and bubbly flow.
KriegD. A.HelwickJ. A.DillonP. O.McCreadyM. J.Origin of disturbances in concurrent gas-liquid packed bed flowsAIChE. J., 1995, 41, 1653–1662.
3.
HuangX.VarmaA.McCreadyM. J.Heat transfer characterization of gas-liquid flows in a trickle-bedChem. Eng. Sci., 2004, 18, 3767–3776.
4.
TrivizadakisM. E.KarabelasA. J.A study of local liquid/solid mass transfer in packed beds under trickling and induced pulsing flowChem. Eng. Sci., 2006, 61, 7684–7696.
5.
ClarkW. W.Liquid film thickness measurementMultiph. Sci. Technol., 2002, 14, 1–74.
6.
KangH. C.KimM. H.The development of a flushwire probe and calibration method for measuring liquid film thicknessInt. J. Multiph. Flow, 1992, 18 (3), 423–437.
7.
MiyaM.WoodmanseeD.E.HanrattyT. J.A model of roll waves in gas-liquid flowChem. Eng. Sci., 1971, 26, 1915–1931.
8.
BrownR. C.AndreussiP.ZanelliS.The use of parallel wire probes for measurment of film thickness in annular gas-liquid flowsCan. J. Chem. Eng., 1978, 56, 754–757.
9.
KoskieJ. E.MudawarI.TiedermanW. G.Parallelwire probes for measurement of thick liquid filmsInt. J. Multiph. Flow, 1989, 15 (4), 521–530.
10.
KimM.KangH. The development of a flush-wire probe and calibration technique for measuring liquid film thickness. In ASME Winter Annual Meeting, Dallas, 1990, FED 99, HTD 155, pp. 31–138.
11.
ConeyM. W. E.The theory and application of conductance probes for the measurement of liquid film thickness in two-phase flowJ. Phys. E, 1973, 6, 903–910.
12.
RevankarS. T.KongX.OhS. Co-current and counter-current two-phase flow through packed bed in microgravity. Report no. PU/NASA-03-12, School of Nuclear Engineering, Purdue University, West Lafayette, IN, USA, 2003.
13.
KongX.Concurrent gas-liquid two-phase flow through packed bed. MS Thesis, School of Nuclear Engineering, Purdue University, West Lafayette, IN, USA, 2004.
14.
RevankarS. T.IshiiM.Local interfacial area measurement in bubbly flowInt. J. Heat Mass Transf., 1992, 35, 913–925.
15.
RevankarS. T.IshiiM.Theory and measurement of local interfacial area using a four sensor probe in twophase flowInt. J. Heat Mass Transf., 1993, 36 (12), 2997–3007.
16.
NealL. G.BankoffS. G.A high resolution conductivity probe for determination of local void properties in gas-liquid flowAIChE J., 1963, 9, 490–494.
17.
ParkW. H.KangW. K.CapesC. E.OsbergG. L.The properties of bubbles in fluidized beds of conducting particles as measured by an electroconductivity probeChem. Eng. Sci., 1969, 24, 856–865.
18.
RigbyG. R.Van BlocklandG. P.ParkW. H.CapesC. E.Properties of bubbles in three phase fluidized beds as measured by an electroconductivity probeChem. Eng. Sci., 1970, 25, 1729–1741.
19.
HofferM. S.ResnickW.A Modified electroconductivity probe technique for steady- and unsteady-state measurements in fine dispersions-I. Hardware and practical aspectsChem. Eng. Sci., 1975, 30, 473–480.
20.
BurgessJ. M.CalderbankP. H.The measurement of bubble parameters in two-phase dispersions-I. The development of an improved probe techniqueChem. Eng. Sci., 1975, 30, 743–750.
21.
SerizawaA.KataokaI.MichiyoshiI.Turbulence structure of air-water bubbly flow-I. Measuring techniquesInt. J. Multiphase Flow, 1975, 2, 221–233.
22.
HerringeR. A.DavisM. R.Structural development of gas-liquid mixture flowsJ. Fluid Mech., 1976, 73, 97–123.
23.
BurgessJ. M.CalderbankP. H.The measurement of bubble parameters in two-phase dispersions-II. The Structure of sieve tray frothsChem. Eng. Sci., 1975, 30, 1107–1121.
24.
SekoguchiK.FukuiH.TsutsuiM.NishikawaK.Investigation into the statistical characteristics of bubbles in two-phase flow (2nd report, application and establishment of electrical conductivity probe method)Bull. JSME, 1975, 18, 397–404.
25.
KataokaI.SerizawaA. Averaged bubble diameter and interfacial area in bubbly flow. In Proceedings of 5th Two-Phase Symposium, Kobe, Japan, 28-29 November 1984, pp. 77–80.
26.
BuchholzR.TsepetonidesJ.SteinemannJ.OnkenU.Influence of gas distribution on interfacial area and mass transfer in bubble columnsGer. Chem. Eng., 1983, 6, 105–113.
27.
IliutaI.ThyrionF. C.MunteanO.Residence time distribution of the liquid in two-phase cocurrent downflow in packed beds: Air/Newtonian and non-Newtonian liquid systemsCan. J. Chem. Eng., 1996, 74, 783–795.
28.
ZunI.PerparM.FilipicB.Probe measurements of local carrying gas fraction in trickle bed reactorExpl Therm. Fluid Sci., 1997, 15, 163–173.
29.
RevankarS. T.IshiiM.MiY.BertodanoM. L.XuY.KellyS.RansomV. H.HanJ. T. Instrumentation for the PUMA facility. US Nuclear Regulatory Commission, report NUREG/CR-5578, PU/NE-98-3, March 1999.
30.
HewittG. F.Measurement of two-phase flow parameters, 1978 (Academic Press, New York).
31.
CimorelliL.EvangelistiR.The application of the capacitance method for void fraction measurement in bulk boiling conditionsInt. J. Heat Mass Transf., 1967, 10, 277–288.
