A multi-component fuel vaporization model has been developed and implemented into an in-house multi-phase computational fluid dynamics flow solver simulating the flow, spray, and air-fuel mixing processes taking place in gasoline direct injection (GDI) engines. Multi-component fuel properties are modelled assuming a specified composition of pure hydrocarbons. High-pressure and -temperature effects, as well as gas solubility and compressibility, are considered. Remote droplet vaporization is initially investigated in order to quantify and validate the most appropriate vaporization model for conditions relevant to those realized with GDI engines. Phenomena related to the fuel injection system and pressure-swirl atomizer flow as well as the subsequent spray development are considered using an one-dimensional fuel injection equipment model predicting the wave dynamics inside the injection system, a Eulerian volume of fluid-based two-phase flow model simulating the liquid film formation process inside the injection hole of the swirl atomizer and a Lagrangian spray model simulating the subsequent spray development, respectively. The computational results are validated against experimental data obtained in an optical engine and include laser Doppler velocimetry measurements of the charge air motion in the absence of spray injection and charge coupled device images of the fuel spray injected during the induction stroke. The results confirm that fuel composition affects the overall fuel spray vaporization rate, but not significantly relative to other flow and heat transfer processes taking place during the engine operation.
WirthM.ZimmermannD.FriedfeldtR.CaineJ.SchamelA.DaviesM.A cost optimised gasoline spray guided direct injection system for improved fuel economy. Seminar on Fuel Economy and Engine Downsizing, Institution of Mechanical Engineers, UK, 2004.
2.
LippertA. M.El TahryS. H.HueblerM. S.ParrishS. E.InoueH.NoyoriT.Development and optimization of a small-displacement spark-ignition direct-injection engine-stratified operation. SAE paper 2004–01-0033, 2004.
3.
PontoppidanM.GavianiG.BellaG.De MaioA.Optimization by CFD simulation of spray formation parameters to adapt direct injection high-pressure fuel injectors to high-speed SI-engines. SAE paper 2004–01-0539, 2004.
GavaisesM.ArcoumanisC.Modelling of sprays from high-pressure swirl atomisers. Int. J. Engine Res., 2001, 2, 95–117.
6.
LandenfeldT.KufferathA.GerhardtJ.Gasoline direct injection SULEV emission concept. SAE paper 2004–01-0041, 2004.
7.
AllenJ.HargraveG.KhooY.In-nozzle and spray diagnostic techniques for real sized pressure swirl and plain orifice gasoline direct injectors. SAE paper 2003–01-3151, 2003.
8.
IppW.WagnerH. K.WensingM.LeipertzA.ArndtS.JainA. K.Spray formation of high-pressure swirl gasoline injectors investigated by two-dimensional Mie and LIEF techniques. SAE paper 1999–01-0498, 1999.
9.
NouriJ. M.WhitelawJ. H.Spray characteristics of a GDI injector with short injection duration. Exp. in Fluids, 2001, 31, 377–383.
10.
ShelbyM. H.VanDerWegeB. A.HochgrebS.Early spray development in gasoline direct-injection spark-ignition engines. SAE paper 980160, 1998.
11.
Abo-SerieE.ArcoumanisC.GavaisesM.ArgueyrollesB.GalzinF.Structure of sprays generated by pressure swirl injectors for direct-injection gasoline engines. 15th Annual Conference onLiquid atomisation and spray systems, 1999 (ILASS-Europe).
12.
Abo-SerieE.ArcoumanisC.GavaisesM.Spray characteristics of pressure-swirl atomisers for G-DI engines: Phase Doppler measurements. 16th Annual Conference onLiquid atomisation and spray systems, Germany, 2000 (ILASS-Europe).
13.
ArcoumanisC.GavaisesM.Pressure-swirl atomizers for DISI engines: Further modelling and experiments. SAE paper 2000–01-1044, 2000.
14.
GavaisesM.Abdul-WahabE.ArcoumanisC.Nozzle hole film formation and its link to spray characteristics in swirl-pressure atomisers for direct injection gasoline engines. SAE paper 2002–01-1136, 2002.
15.
SazhinS. S.Advanced models of fuel droplet heating and evaporation. Prog. Energy Combust. Sci., 2006, 32, 162–214.
16.
FuchsN. A.Vaporisation and droplet growth in gaseous media, 1959 (Pergamon Press, London).
17.
SchrageR.W.A theoretical study of interphase mass transfer, 1953 (Columbia University Press, New York).
18.
BellanJ.Supercritical (and subcritical) fluid behavior and modelling: Drops, steams, shear and mixing layers, jets and sprays. Prog. Energy Combust. Sci., 2000, 26, 329–366.
TongA. Y.SirignanoW. A.Analysis of vaporising droplet with slip, internal circulation and unsteady liquid-phase and quasi-steady gas-phase heat transfer. ASME-JSME Thermal Joint Engineering Conference, 1983.
28.
HubbardG. L.DennyV. E.MillsA. F.Droplet vaporisation: Effects of transient and variable properties. Int. J. Heat Mass Transfer, 1975, 18, 1003–1008.
29.
HohmannS.RenzU.Numerical simulation of fuel sprays at high ambient pressure: The influence of real gas effects and gas solubility on droplet vaporisation. Int. J. Heat Mass Transfer, 2003, 46, 3017–3028.
30.
KimH.SungN.The effect of ambient pressure on the vaporisation of a single droplet and a spray. Combust. Flame, 2003, 135, 261–270.
31.
TrujilloM. F.TorresD. J.O'RourkeP. J.High-pressure multicomponent liquid sprays: Departure from ideal behaviour. Int. J. Engine Res., 2004, 5 (3), 229–246.
32.
ZhuG. S.AggarwalS. K.Fuel droplet vaporisation in a supercritical environment. J. Engng Gas Turbines Power: Trans. ASME, 2002, 124 (4), 762–770.
33.
ZhuG. S.AggarwalS. K.Transient supercritical droplet vaporisation with emphasis on the effects of equation of state. Int. J. Heat Mass Transfer, 2000, 43 (7), 1157–1171.
34.
GraboskiM. S.DaubertT. E.A modified Soave equation of state for phase equilibrium calculations. Part I: Hydrocarbon systems. Ind. Engng Chem. Process Des. Dev., 1987, 17, 337–443.
35.
PengD.RobinsonD. B.A new two-constant equation of state. Ind. Engng Chem. Fundamentals, 1976, 15, 59–64.
36.
RedlichO.KwongJ. N. S.On the thermodynamics of solutions. V: An equation of state. Fugacities of gaseous solutions. Chem. Rev., 1949, 44.
37.
PrausnitzJ. M.LichtenthalerR. N.Gomes de AzevedoE.Molecular thermodynamics of fluid-phase equilibria. Prentice Hall International Series in the Physical and Chemical Engineering Sciences, 1999.
38.
CottermanR. L.PrausnitzJ. M.Flesh calculations for continuous and semicontinuous mixtures using an equation of state. Ind. Engng Chem. Process Des. Dev., 1985, 24, 434–443.
39.
PatankarS. V.Numerical heat transfer and fluid flow, 1980 (Taylor and Francis).
40.
WeiY. S.SadusR. J.Equations of state for the calculation of fluid phase equilibria. AIChE J., 2000, 46, 169–196.
41.
KneerR.SchneiderM.Diffusion controlled vaporisation of a multi-component droplet: Theoretical studies on the importance of variable liquid properties. Int. J. Heat Mass Transfer, 1993, 36 (9), 2403–2415.
42.
MegaridisC. M.SirignanoW. A.Numerical modelling of a vaporizing multicomponent droplet. 23rd Symposium (International) on Combustion, The Combustion Institute, 1990, pp. 1413–1421.
43.
MuckhopadhyayA.SanyalD.A study of thin-flame quasi-steady spherosymmetric combustion of multicomponent fuel droplets, Part I: Modelling for droplet surface regression and non unity gas-phase Lewis number. Int. J. Energy Res., 1999, 23, 963–977.
44.
AggarwalS. K.Modelling of a dilute vaporising multicomponent fuel spray. Int. J. Heat Mass Transfer, 1987, 30, 1949–1961.
45.
Abdel-QaderZ.HallettW. L. H.The role of liquid mixing in vaporisation of complex multi-component mixtures: Modelling using continuous thermodynamics. Chem. Engng Sci., 2005, 60, 1629–1640.
46.
HarstadK.BellanJ.Modelling vaporisation of Jet A, JP-7, and RP-1 drops at 1 to 15 bars. Comb. Flame, 2004, 137, 163–177.
47.
LippertA. M.Modelling of multicomponent fuels with application to sprays and simulation of diesel engine cold start. PhD thesis, University of Wisconsin-Madison, 1999.
48.
TamimJ.HallettW. L. H.A continuous thermodynamics model for multi-component droplet vaporization. Chem. Engng Sci., 1995, 50.
49.
GavaisesM.Modelling of diesel fuel injection processes. PhD thesis, Imperial College, University of London, 1997.
50.
GiannadakisE.Modelling of cavitation in automotive fuel injector nozzles. PhD thesis, Imperial College London, UK, 2005.
51.
TheodorakakosA.Numerical simulation of flow processes in IC engines. PhD thesis, National Technical University of Athens, Greece, 1998.
52.
ToniniS.Fuel spray modelling in direct injection diesel and gasoline engines. PhD thesis, City University London, UK, 2006.
53.
TheodorakakosA.BergelesG.Simulation of sharp gas-liquid interface using VOF method and adaptive grid local refinement around the interface. Int. J. Numer. Methods Fluids, 2004, 45, 421–439.
54.
DukowiczJ. K.A particle-fluid numerical model for liquid sprays. J. Comput. Phys., 1980, 35, 229–253.
55.
ArcoumanisC.GavaisesM.Abdul-WahabE.MoserV.Modeling of advanced high-pressure fuel injection systems for passenger car diesel engines. Society of Automotive Engineers, technical paper series, 1999.
56.
FengZ. G.MichaelidesE. E.Drag coefficients of viscous spheres at intermediate and high Reynolds numbers. J. Fluids Engng, Trans. ASME, 2001, 123 (4), 841–849.
YuenM. C.ChenL. W.On the drag of evaporating droplet. Combust. Sci. Technol., 1976, 14, 145–154.
59.
DowningC. G.The evaporation of drops of pure liquids at elevated temperatures: Rates of evaporation and wet-bulb temperatures. AIChE Journal, 1966, 12 (4), 760–766.
60.
WongS. C.LinA. C.Internal temperature distributions of droplets vaporizing in high-temperature convective flows. J. Fluid Mech., 1992, 237, 671–687.
61.
PostonR. S.McKettaJ. J.Vapor-liquid equilibrium in the n-hexane-nitrogen system. J. Chem. Engng Data, 1966, 11.
62.
63.
StengeleJ.PrommersbergerK.WillmannM.WittigS.Experimental and theoretical study of one- and two- component droplet vaporization in a high pressure environment. Int. J. Heat Mass Transfer, 1999, 42, 2683–2694.
64.
KampanisN.ArcoumanisC.KatoR.KometaniS.Flow, combustion and emissions in a five-valve research gasoline engine. SAE paper 2001–01-3556, 2001.
65.
KampanisN.ArcoumanisC.KometaniS.KatoR.KinoshitaH.Flow and mixture distribution in a high-speed five-valve direct injected gasoline engine. Int. J. Engine Res., 2006, 7 (2).
66.
KampanisN.Flow, mixture distribution and combustion in five-valve gasoline engines. PhD thesis, Imperial College, University of London, 2003.
67.
MitroglouN.Multihole injectors for direct injection gasoline engines. PhD thesis, The City University London, 2006.
