Testing of an automobile exhaust thermoelectric generator in a light truck

Abstract

Testing was conducted on a prototype automobile exhaust thermoelectric generator (AETEG) installed in a 1999 GMC Sierra pick-up truck. The system consisted of the generator, its power conditioning unit, and the interfaces to the test truck's engine coolant and exhaust systems. The objective of the test was to measure the AETEG's performance and its effect on the truck systems as well as to determine which factors are important for optimizing an AETEG design. Testing was performed in a dynamometer-equipped wind tunnel at Delphi Corporation's Harrison Thermal Systems Division in Lockport, New York. The first tests established the benchmark data set. Then the prototype AETEG was installed and three configurations of the system were tested in succession: the AETEG alone, the AETEG with portions of the exhaust pipes leading to it insulated, and the AETEG with insulated upstream exhaust pipes and with a pre-cooling heat exchanger operating to lower the inlet coolant temperature to the generator. Some of the important outcomes of the tests were: insulating the exhaust and lowering the coolant temperature had a significant positive effect on the power, parasitic losses resulting from the AETEG weight and the coolant pumping power were significant but manageable, and the increased exhaust flow resistance and the additional heat load from the AETEG were not significant effects.

Keywords

thermoelectric generator vehicle exhaust engine coolant fuel savings electric power alternator load power conditioning system test

Get full access to this article

View all access options for this article.

References

Office of Nuclear Energy, Science and Technology of the US Department of Energy, Space radio-isotope power systems: Multi-mission radioisotope thermoelectric generator (http://www.nuclear.gov/pdf/MMRTG.pdf), 2006 (accessed 12 April 2006).

Bauer

R. H.

Auxiliary electric power for an automobile through the utilization of a thermoelectric generator: A critical examination. MS Thesis, Department of Mechanical Engineering, Clarkson College of Technology, Potsdam, New York, 1963.

Tomarchio

A. J.

A feasibility study of replacing an electrical generator of a standard American automobile with a thermoelectric generator. MS Thesis, Department of Mechanical Engineering, Clarkson College of Technology, Potsdam, New York, 1964.

Menchen

W. R.

Osmeyer

W. E.

McAlonan

Thermoelectric conversion to recover heavy duty diesel exhaust energy. In Proceedings of the Annual Automotive Technology Development Contractors Meeting, 1990, 445–449.

Crane

Jackson

Holloway

Towards optimization of automotive waste heat recovery using thermoelectrics. In SAE 2001 World Congress, Detroit, Michigan, 2001.

Vazquez

Sanz-Bobi

M. A.

Palacios

Arenas

State of the art of thermoelectric generators based on heat recovered from the exhaust gases of automobiles. In Proceedings of the 7th European Workshop on

Thermoelectrics http://www.iit.upco.es/palacios/thermo/EWT02-Exhaust_gases.pdf, Pamplona, Spain, 2002.

Kushch

A. S.

Bass

J. C.

Ghamaty

Elsner

N. B.

Bergstrand

R. A.

Furrow

Melvin

Thermoelectric development at Hi-Z Technology. In 7th Diesel Engine Emissions Reduction Workshop (http://www.osti.gov/fcvt/deer2001/kushch.pdf), Portsmouth, Virginia, 2001.

Takanose

Tamakoshi

The development of thermoelectric generator for passenger car. In Proceedings of the 12th International Conference on

Thermoelectrics, Yokohama, Japan, November 1993, pp. 467–470.

Bass

J. C.

Elsner

N. B.

Leavitt

F. A.

Performance of the 1 kW thermoelectric generator for diesel engines. In Proceedings of the 13th International Conference on

Thermoelectrics, 1994, pp. 295–298.

10.

Bauer

(Editor-in-Chief) Bosch automotive handbook, 2000 (Robert Bosch GmbH, Stuttgart, Germany).

11.

Hi-Z Technology, HZ-20 product brochure (http://hi-z.com/websit04.htm), 2006 (accessed 12 April 2006).

12.

Angrist

S. W.

Direct energy conversion, 1982 (Allyn and Bacon Inc., Boston, Massachusetts).

13.

Thacher

E. F.

Thermoelectric power from vehicle exhaust: Phase2A — Progress Report 10. The New York State Energy Research and Development Authority, Albany, New York, 2004.

14.

Kays

W. M.

London

A. L.

Compact heat exchangers, 2nd edition, 1964, 154 pp. (McGraw-Hill Inc., New York).

15.

White

F. M.

Fluid Mechanics, McGraw-Hill Inc., New York.