A cyclic variation in total particle number concentration was observed while making routine exhaust emission measurements. Many dilution and engine operating conditions were examined and, by sequentially shutting down individual cylinders, the problem was traced to cylinder 2. The engine was disassembled and piston 2's oil control ring was found to be fractured. Replacement of the ring eliminated the particle concentration fluctuation. This paper presents the results of experimental measurements made to determine the cause of the irregular emissions.
KittelsonD. B.‘Engines and nanoparticles: a review.’J. Aerosol Sci.29 (5–6) (1998): 575–588.
2.
BranstetterR.BurrahmR.DietzmannH.‘Relationship of underground diesel engine maintenance to emissions, vol. I.’ Report OFR 110(1)-84 (USBM Contract H0292009), US Department of the Interior, Bureau of Mines, Washington, DC, USA, 1983, pp. 25–26, 45.
3.
ChanL.CarlsonD.JohnsonJ.‘Evaluation and application of a portable tailpipe emissions measurement apparatus for field use.’ SAE technical paper 921647, 1992.
4.
UllmanT. L.HareC. T.‘Influence of maladjustment on emissions from two heavy-duty diesel bus engines.’ SAE technical paper 840416, 1984.
5.
UllmanT. L.HumanD. M.‘Fuel and maladjustment effects on emissions from a diesel bus engine.’ SAE technical paper 910735, 1991.
6.
HumanD. M.UllmanT. L.‘Development of an I/M short emissions test for buses.’ SAE technical paper 920727, 1992.
7.
ZellerH. W.‘Fuel additive and engine operation effects on diesel soot emissions.’ Information Circular 9238, US Bureau of Mines, Washington, DC, USA, 1992, pp.5–9.
8.
CarlsonD.OsborneM.JohnsonJ.‘The development and application to detector tubes of a laboratory method to assess accuracy of occupational pollutant concentration measurements.’AIHA J.43 (1982): 275–285.
9.
SpearsM. W.‘An emissions-assisted maintenance procedure for diesel-powered equipment.’ Report (Contract USDI/1432 C0369004), Center for Diesel Research, University of Minnesota Minneapolis, Minnesota, USA, October 1997, available from http://www.cdc.gov/niosh/mining/topics/diesel/eamp/eamp.htm.
10.
ChernichD. J.‘Development of a chassis based inspection and maintenance program for heavy-duty diesel powered vehicles.’ In Proceedings of the 13th CRC On-road Vehicle Emissions Workshop, San Diego, California, USA, 7–9 April 2003 (Coordinating Research Council, Alpharetta, Georgia).
11.
McGinnS.‘The relationship between diesel engine maintenance and exhaust emissions.’ Final report for the Diesel Emissions Evaluation Program (DEEP), Noranda Technology Centre, St-Laurent, Québe Canada, available from http:/www.deep.org/reports/mtce.report.pdf.
BurtscherH.‘Measurements and characteristics of combustion aerosols with special consideration of photoelectric charging and charging by flame ions.’J. Aerosol Sci.23 (1992): 549–595.
14.
MinB.-S.KimJ.-S.OhD.-Y.ChoiJ.-K.JinJ.-H.‘Dynamic characteristics of oil consumption – relationship between the instantaneous oil consumption and the location of piston ring gap.’ SAE technical paper 982442, 1998.
15.
JungJ.KittelsonD. B.‘Characterization of aerosol surface instruments in transition regime.’Aerosol Sci. Technol.39 (2005): 902–911.
16.
KittelsonD. B.WattsW. F.SavstromJ. C.JohnsonJ. P.‘Influence of a catalytic stripper on the response of the PAS, DC, CPC and the SMPS.’J. Aerosol Sci.36 (2005): 1089–1107.
17.
Abdul-KhalekI.KittelsonD. B.BrearF.‘The influence of dilution conditions on diesel exhaust particle size distribution measurements.’ SAE technical paper 1999-01-1142, 1998.
18.
MillerA.StipeC.HabjanM.AlstrandG.‘Role of lubrication oil in particulate emissions from a hydrogen-powered internal combustion engine.’Environ. Sci. Technol.41 (2007): 6828–6835.
19.
SakuraiH.TobiasH. J.ParkK.ZarlingD.DochertyK. S.KittelsonD. B.McMurryP. H.ZiemannP. J.‘On-line measurements of diesel nanoparticle composition and volatility.’Atmos. Environ.37 (2003): 1199–1210.
20.
SchneiderE. W.BlossfeldD. H.LechmanD. C.HillR. F.ReisingR. F.BrevickJ. E.‘Effect of cylinder bore out-of-roundness on piston ring rotation and engine oil consumption.’ SAE technical paper 930796, 1993.
21.
SchneiderE. W.BlossfeldD. H.‘Method for measurement of piston ring rotation in an operating engine.’ SAE technical paper 900224, 1990.
