When moist air comes into contact with a surface maintained at a subfreezing temperature, which is also below the dew-point temperature of water vapour in air, frost will form. Although this frost formation process is associated with a temporary increase in the heat transfer rate in the initial stages of deposition, the overall thermal performance over an extended period of time is degraded due to the insulating effect of the frost and also due to blockage of the coil and the accompanying reduction in air flow. One method of defrosting employs electric heat to melt the frost of the coil. This paper describes how the enthalpy method can be used to calculate the defrosting time and the temperature distribution in the frost layer during the defrosting process of a finned-tube evaporator coil. While the analysis presented applies mainly to electric defrosting, the method can be easily modified to handle different defrosting methods and processes.
WilliamsS. J.Energy equations for five defrost methods. Refrig. Engng, August 1952, 859–863.
2.
MerrillP.Heat pumps on-off capacity control and defrost performance test using time-temperature defrost controls. ASHRAE Trans., 1981, 87(1), 381–393.
3.
StoeckerW. F.LuxJ. J.Jr.KooyR. J.Energy considerations in hot gas defrosting of industrial refrigeration coils. ASHRAE Trans., 1983, 89(2A), 549–573.
4.
Abdel-WahedR. M.HifiniM. A.SherifS. A.Hot water defrosting of a horizontal flat plate cooling surface. Int. J. Refrig., May 1983, 6(3), 152–154.
5.
O'NealD. L.PetersonK. T.AnandN. K.SchliesingJ. S.Refrigeration system dynamics during the reverse cycle defrost. ASHRAE Trans., 1989, 95(2), 689–698.
6.
AnandN. K.SchliesingJ. S.O'NealD. L.PetersonK. T.Effects of outdoor coil fan pre-start on pressure transients during the reverse cycle defrost of a heat pump. ASHRAE Trans., 1989, 95(2), 699–704.
7.
ColeR. A.Refrigeration loads in a freezer due to hot gas defrost and their associated costs. ASHRAE Trans., 1989, 95(2), 1149–1154.
8.
KrakowK. L.YanL.LinS.A model of hot gas defrosting of evaporators–Part 1: Heat and mass transfer theory. ASHRAE Trans., 1992, 98(1), 451–461.
9.
KrakowK. L.YanL.LinS.A model of hot gas defrosting of evaporators–Part 2: Experimental analysis. ASHRAE Trans., 1992, 98(1), 462–474.
10.
KrakowK. L.LinS.YanS.An idealized model of reversed-cycle hot gas defrosting–Part 1: Theory. ASHRAE Trans., 1993, 99(2), 317–328.
11.
KrakowK. L.LinS.YanS.An idealized model of reversed-cycle hot gas defrosting–Part 2: Experimental analysis and validation. ASHRAE Trans., 1993, 99(2), 329–338.
12.
SherifS. A.HertzM. G.A semi-empirical model for electric defrosting of a cylindrical coil cooler. Int. J. Energy Res., January 1998, 22(1), 85–92.
13.
SherifS. A.Al-MutawaN. K.MathurG. D.SteadhamJ. M.TiedemanJ.MacFarlaneS.UrlaubJ.WestJ.HarkerR. A.A study to determine heat loads due to coil defrosting. Final Technical Report UFME/SEECL-9701, Contract ASHRAE-622-RP, submitted to The American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc., by the Solar Energy and Energy Conversion Laboratory, Department of Mechanical Engineering, University of Florida, Gainesville, Florida, January 1997.
14.
Al-MutawaN. K.SherifS. A.MathurG. D.WestJ.TiedemanJ.UrlaubJ.Determination of coil defrosting loads: Part I–experimental facility description (RP-622). ASHRAE Trans., January 1998, paper 4120, 104(1A), 268–288.
15.
Al-MutawaN. K.SherifS. A.MathurG. D.SteadhamJ. M.WestJ.HarkerR. A.TiedemanJ.Determination of coil defrosting loads: Part II–instrumentation and data acquisition systems (RP-622). ASHRAE Trans., January 1998, paper 4121, 104(1A), 289–302.
16.
Al-MutawaN. K.SherifS. A.MathurG. D.Determination of coil defrosting loads: Part III–testing procedures and data reduction (RP-622). ASHRAE Trans., January 1998, paper 4122, 104(1A), 303–312.
17.
Al-MutawaN. K.SherifS. A.SteadhamJ. M.Determination of coil defrosting loads: Part IV–refrigeration/defrost cycle dynamics (RP-622). ASHRAE Trans., January 1998, paper 4123, 104(1A), 313–343.
18.
Al-MutawaN. K.SherifS. A.Determination of coil defrosting loads: Part V–analysis of loads (RP-622). ASHRAE Trans., January 1998, paper 4124, 104(1A), 344–355.
19.
Al-MutawaN. K.SherifS. A.An analytical model for hot-gas defrosting of a cylindrical coil cooler: Part I–model development. ASHRAE Trans., January 1998, 104(1B), 1722–1730.
20.
Al-MutawaN. K.SherifS. A.An analytical model for hot-gas defrosting of a cylindrical coil cooler: Part II–model results and conclusions. ASHRAE Trans., January 1998, 104(1B), 1731–1737.
21.
AlexiadesV.SolomonA. D.Mathematical Modeling of Melting and Freezing Processes, 1993 (Hemisphere, Washington, DC).
22.
AlebrahimA.M.Electrical defrosting analysis of a finned tube evaporator coil using the enthalpy method. MS thesis, University of Florida, Gainesville, Florida, 1997.
23.
HayashiY.AokiA.AdachiS.HoriK.Study of frost properties correlating with frost formation types. J. Heat Transfer, 1977, 99(2), 239–245.
24.
HolmanJ. P.Heat Transfer, 1989 (McGraw-Hill, New York).
25.
OsborneN. S.StimsonH. F.GinningsD. C.Measurements of heat capacity and heat of vaporization of water in the range 0 to 100 °C. J. Res. National Bureau of Standards, July-December 1939, 23, 179–260.
SparrowE. M.SamieF.Heat transfer and pressure drop results for one- and two-row arrays of finned tubes. Int. J. Heat and Mass Transfer, 1985, 28(12), 2247–2259.
28.
TsubouchiT.MasudaM.Natural convection heat transfer from horizontal cylinders with circular fins. In Proceedings of 4th International Heat Transfer Conference, Paris, 1970, Vol. IV, paper NC 1.10.
29.
ChapmanA. J.Heat Transfer, 1974 (Macmillan, New York).
