Piping elbows with cracks Part 2: Global finite element and experimental plastic loads under opening bending

Abstract

Experimental and finite element (FE) plastic load results of cracked piping elbows under opening in-plane bending are presented and compared with data from similar defect-free components. The elbows used were short-radius components with an outside diameter of 88.9 mm and thickness 5.49 mm. Axial (at the crown) and circumferential (at the intrados) blunt crack-like defects were produced using electric discharge machining (EDM) procedures. Both short (0 = 21° axial or 2β = 46° circumferential) and long (0 = 75° axial or 2β = 120° circumferential) defects were investigated with three depth-thickness ratios a/t = 0.5, 0.75 and 1.0. The FE simulations employed the measured true stress-strain properties for the elbow material and included geometric non-linear behaviour.

The results obtained show that piping elbows under opening bending can tolerate substantial defects, with reductions in plastic loads compared with the defect-free component of the order of 15 per cent or less in most cases, except when the defect is through-wall and circumferential and covers an angle 2β = 120° or more, in which case the reduction in plastic load can be as high as 40 per cent.

Keywords

piping elbows cracks finite element loads experimental plastic loads opening bending

Get full access to this article

View all access options for this article.

References

Yahiaoui

Moffat

D. G.

Moreton

D. N.

Piping elbows with cracks. Part 1: A parametric study of the influence of crack size on limit loads due to pressure and opening bending. J. Strain Analysis, 2000, 35 (1), 35–46.

Assessment of the integrity of structures containing defects. Document R/H/R6, Revision 3, up to and including Amendment 9, Nuclear Electric Limited, August 1998.

Griffiths

J. E.

The effect of cracks on the limit load of pipe bends under in-plane bending: Experimental study. Int. J. Mech. Sci., 1979, 21 (2), 119–130.

Yahiaoui

Moffat

D. G.

Moreton

D. N.

Damage assessment of piping elbows loaded by steady internal pressure and dynamic in-plane or out-of-plane bending. In Proceedings of the Eighth International Conference on

Pressure Vessel Technology, Vol. 1, Montreal, 1996, pp. 361–375 (American Society for Mechanical Engineers, New York).

Patran, Versions 3, 5 and 6, 1993–97 (PDA Engineering, Santa Ana, California).

Abaqus/Standard - Abaqus/Post User Manuals, Versions 5 and 6, 1996 (Hibbit, Karlsson and Sorensen, Pawtucket, Rhode Island).

Gerdeen

J. C.

A critical evaluation of plastic behaviour and a united definition of plastic loads for pressure vessels. Welding Research Council Bulletin 254, 1979.

Bolt

Greenstreet

W. L.

Experimental determinations of plastic collapse loads of pipe elbows. In Proceedings of the International Conference on

Pressure Vessels and Piping, 1972, paper 71-PVP-37, pp. 2–12 (American Society for Mechanical Engineers, New York).

ASME, Boiler and Pressure Vessel Code, Section III, 1992.