Sage Journals: Discover world-class research

Abstract

A series of TiO₂ modified hydroxyapatite composites (HA/TiO₂) with different compositions were prepared. Phase formations and morphologies of the obtained HA/TiO₂ composite were characterised using X-ray diffraction and SEM, and their photocatalytic activities were also determined by decomposition of methylene blue solution. Filter cloths were prepared by depositing the composite on polyester non-wovens via pad dry cure, and their filtering effectiveness was examined by photocatalytic activity measurement and bactericidal test. Hydroxyapatite/TiO₂ composites were successfully prepared and exhibited photocatalytic properties. With increasing ratio of anatase titania in the HA/TiO₂ composite from 20 to 30 and 50%, photocatalytic activity of composite material increased such that HATi5050 composite exhibited the highest photocatalytic activity. Non-woven filters coated with HA/TiO₂ composites also exhibited good photocatalytic activities. Less difference in photocatalytic activity between HATi7030 and HATi5050 coated non-woven filters was observed, compared to that in powder form. The filter coated with HA/TiO₂ composite exhibited good bactericidal effect.

Keywords

Hydroxyapatite Titanium dioxide Antibacterial Photocatalytic activity

Get full access to this article

View all access options for this article.

References

Fujishima

and Honda

: ‘Photosensitive electrode reactions. III Electrochemical evidence for the mechanism of the primary stage of photosynthesis’, Bull. Chem. Soc. Jpn, 1971, 44, (4) 1148–1150.

Fujishima

and Honda

: ‘Electrochemical photolysis of water at a semiconductior electrode’, Nature, 1972, 238, (5358), 37–38.

, Murakami

, Kamitakahara

and Ioku

: ‘Fabrication of titania/hydroxyapatite composite granules for photo-catalyst’, Mater. Res. Bull., 2009, 44, 768–774.

Anmin

, Ming

, Chengkang

and Dali

: ‘Preparation and characterization of a titanium-substituted hydroxyapatite photocatalyst’, J. Mol. Catal. A, 2007, 267A, 79–85.

Nishikawa

, Kato

and Ando

: ‘Rapid and complete oxidation of acetaldehyde on TiO₂ photocatalytic filter supported by photo-induced activated hydroxyapatite’, J. Mol. Catal. A, 2005, 236A, 145–148.

Lee

, Hong

and Mohseni

: ‘Synthesis of photocatalytic nanosized TiO₂–Ag particles with sol–gel method using reduction agent’, J. Mol. Catal. A, 2005, 242A, 135–140.

Liu

, Liu

, Wei

, Xiong

, Pan

and Shi

: ‘Enhanced adsorption and visible-light-included photocatalytic activity of hydroxyapatite modified Ag-TiO₂ powders’, Appl. Surf. Sci., 2010, 256, 6390–6394.

Nosaka

, Matsushita

, Nishino

and Nosaka

: ‘Nitrogen-doped titanium dioxide photocatalysts for visible response prepared by using organic compounds’, Sci. Tech. Adv. Mater., 2005, 6, 143–148.

, Ohmori

, Tsumura

, Nakata

and Li

: ‘Microstructural analysis and photocatalytic activity of plasma-sprayed titania-hydroxyapatite coatings’, J. Therm. Spray Technol., 2007, 16, (5–6), 776–782.

10.

Legeros

and Legeros

: ‘Dense hydroxyapatite’, in ‘An introduction to bioceramics’, (ed. Hench

L L

and Wilson

), 139–180; 1993, London, World Scientific.

11.

Tracy

and Doremus

: ‘Direct electron microscopy studies of the bone-hydroxyapatite interface’, J. Biomed. Mater. Res., 1984, 18, 719–726.

12.

Hench

: ‘Bioceramics: from concept to clinic’, J. Am. Ceram. Soc., 1991, 74, 1487–1510.

13.

Wakamura

: ‘Photocatalysis by calcium hydroxyapatite modified with Ti (IV)’, FUJITSU Sci. Tech. J., 2005, 41, (2), 181–190.

14.

Huang

, Best

, Bonfield

and Buckland

: ‘Development and characterization of titania-containing hydroxyapatite for medical applications’, Acta Biomater., 2010, 6, 241–249.

15.

Wakamura

, Kandori

and Ishikawa

: ‘Surface composition of calcium hydroxyapatite modified with metal ions’, Colloids Surf. A, 1998, 142A, 107–116.

16.

Wakamura

, Kandori

and Ishikawa

: ‘Influence of chromium (III) on the formation of calcium hydroxyapatite’, Polyhedron, 1997, 16, (12), 2047–2054.

17.

Wakamura

, Kandori

and Ishikawa

: ‘Surface structure and composition of calcium hydroxyapatite substituted with Al (III), La (III) and Fe (III) ions’, Colloids Surf. A, 2000, 164A, (23), 297–305.

18.

Cao

, Zhang

and Huang

: ‘Synthesis of hydroxyapatite nanoparticles in ultrasonic precipitation’, Ceram. Int., 2005, 31, 1041–1044.

19.

Kong

, Ma

and Boey

: ‘Nanosized hydroxyapatite powders derived from coprecipitation process’, J. Mater. Sci., 2002, 37, 1131–1134.

20.

Yuan

, Zhang

, Li

and Li

: ‘Effect of metal ion dopants on photochemical properties of anatase TiO₂ films synthesized by a modified sol–gel method’, Thin Solid Films, 2007, 515, 7091–7095.

21.

Liu

and Gao

: ‘Preparation and properties of nanocrystalline alpha-F_e2O₃-sensitized TiO₂ nanosheets as a visible light photocatalyst’, J. Am. Ceram. Soc., 2006, 89, 370–373.

22.

Bak

, Nowotny

, Sucher

and Wachsman

: ‘Photocatalytic water disinfection on oxide semiconductor: Part1-basic concepts of TiO₂ photocatalysis’, Adv. Appl. Ceram., 2012, 111, 4–15.

23.

Rahim

, Radiman

and Hamzah

: ‘Inactivation of Escherichia coli under fluorescent lamp using TiO₂’, Sains Malaysiana, 2012, 41, 219–224.

Preparation and properties of hydroxyapatite/titania composite for microbial filtration application

Abstract

Keywords

Get full access to this article

References