Ba1−xSrxTiO3 (x = 0·3, 0·35) ceramics are fabricated by spark plasma sintering (SPS) technique and conventional sintering (CS) route. Their microstructures are determined together with the dielectric and ferroelectric properties. The grain sizes of SPS samples are smaller than those of CS. The differential scanning calorimetry data show that almost no latent heat associated with phase transition can be detected in the SPS sintered ceramics. Raman spectroscopy analysis suggests that the tetragonal phase increases with increasing the grain size, and the higher content of tetragonal phase leads the superior dielectric properties in CS sintered samples. Transmission electron microscopy analysis indicates that domain structure heavily relies on the grain size of ceramics. The poor ferroelectric properties of SPS ceramics are originated from the incomplete development of the tetragonal structure.
TakeuchiT, CapigliaC, BalakrishnanN, TakedaY, KageyamaH: ‘Preparation of fine-grained BaTiO3 ceramics by spark plasma sintering’, J. Mater. Res., 2002, 17, (3), 575–581.
12.
OmoriM: ‘Sintering, consolidation, reaction and crystal growth by the spark plasma system (SPS)’, Mater. Sci. Eng. A, 2000, A287, 183–188.
13.
WuYJ, LiJ, ChenXM, KakegawaK: ‘Densification and micro-structures of PbTiO3 ceramics prepared by spark plasma sintering’, Mater. Sci. Eng. A, 2010, A527, 5157–5160.
14.
NygrenM, ShenZ: ‘On the preparation of bio-, nano- and structure ceramics and composites by spark plasma sintering’, Solid State Sci., 2003, 5, 125–131.
15.
InamF, YanHX, PeijsT, ReeceMJ: ‘The sintering and grain growth behaviour of ceramic-carbon nanotube nanocomposites’, Compos. Sci. Technol., 2010, 70, 947–952.
16.
PerryCH, HallDB: ‘Temperature dependence of the Raman spectrum of BaTiO3’, Phys. Rev. Lett., 1965, 15, 700.
BuessemWR, CrossLE, GoswamiAK: ‘Phenomenological theory of high permittivity in fine-grained barium titanate’, J. Am. Ceram. Soc., 1996, 49, 33–39.
24.
ArltG, HenningsD, de WithG.: ‘Dielectric properties of fine-grained barium titanate ceramics’, J. Appl. Phys., 1985, 58, 1619–1625.
25.
BeggBD, FinnieKS, VanceER: ‘Raman study of relationship between room-temperature tetragonality and the curie point of barium titanate’, J. Am. Ceram. Soc., 1996, 79, 2666–2672.
26.
DobalPS, DixitA, KatiyarRS, GarciaD, GuoR, BhallaAS: ‘Phase transitions in Ba1−xSrxTiO3 ceramics’, Ferroelectr. Lett. Sect., 2002, 29, (3–4), 1–10.
27.
ArltG: ‘The influence of microstructure on the properties of ferroelectric ceramics’, Ferroelectrics, 1990, 104, 217–219.
28.
MartínMJ, MendiolaJ, ZaldoC: ‘Influence of deposition parameters and substrate on the quality of pulsed-laser-deposited Pb1−xCaxTiO3 ferroelectric films’, J. Am. Ceram. Soc., 1998, 81, 2542.
29.
MitoseriuL, RicinschiD, HarnageaC, OkuyamaM, TsukamotoT, TuraV: ‘Grain size dependence of switching properties of ferroelectric BaTiO3 ceramics’, Jpn J. Appl. Phys., 1996, 35, 5210.
30.
NiepceJC: in ‘Surface and interface of ceramic materials’, (ed. L. C. Dufour et al.), 521; 1989, Dordrecht, Kluwer.
31.
SunL, ChenYF, MaWH, WangLW, YuT, ZhangMS, MingNB: ‘Evidence of ferroelectricity weakening in the polycrystalline PbTiO3 thin films’, Appl. Phys. Lett., 1996, 68, 3728.
32.
NietoE, FernandezJF, MoureC, DuranP: ‘Characterization of Pb(Zr,Ti)O3 thin films obtained by MOD’, J. Mater. Sci., 1995, 30, 6243–6248.
