Dynamically cured PP/MAH-g-SEBS/epoxy blends

Abstract

A new method concerning the simultaneous reinforcing and toughening of polypropylene (PP) is reported. Dynamic cure of the epoxy resin with 2-ethylene-4-methane-imidazole was successfully applied in the PP/maleic anhydride grafted styrene–ethylene–butylene–styrene (MAH-g-SEBS) triblock co-polymer, and the obtained blends were named as dynamically cured PP/MAH-g-SEBS/epoxy blends. The stiffness and toughness of the blends are in a good balance, and the smaller size of the epoxy particle in the PP/MAH-g-SEBS/epoxy blends shows that MAH-g-SEBS was also used as a compatibiliser. The structure of the dynamically cured PP/MAH-g-SEBS/epoxy blends is the embedding of the epoxy particles by MAH-g-SEBS. The cured epoxy particles as organic filler increase the stiffness of the PP/MAH-g-SEBS blends, and the improvement in the toughness is attributed to the embedded structure. The tensile strength and flexural modulus of the blends increase with increasing epoxy resin content, and the impact strength reaches a maximum of 342 J m⁻¹ at the epoxy resin content of 10wt-%. Differential scanning calorimetry analysis shows that the epoxy particles in the dynamically cured PP/MAH-g-SEBS/epoxy blends could have contained embedded MAH-g-SEBS, decreasing the nucleating effect of the epoxy resin. Wide angle X-ray diffraction analysis shows that the dynamical cure and compatibilisation do not disturb the crystalline structure of PP in the blends.