Abstract
The quality of iron ore sinter mainly depends on sinter mineralogy, which in turn depends on the chemical composition of the sinter mix. Dolomite is the critical additive for fluxing the sinter and controlling the sinter MgO. Recently, the silica level in the sinter product of the sinter plant 1 has been varying in the range of 5·51 to 9·58% owing to variation in silica content of iron ore fines. At the same time, as per the blast furnace requirement, the rate of addition of dolomite has been changed from 2·40 to greater than 3·00% at the sinter plant 1. In iron ore sinter, MgO plays different roles on sinter properties at different silica ranges. Because of wide range of fluctuation in iron ore silica it is essential to optimise the MgO addition in sinter mix to get desired properties. Laboratory pot grate sintering experiments have been carried out to know the influence of MgO addition on microstructure and properties of low silica and high silica sinter. MgO addition has been varied from 1·40 to 3·20% for low silica (4·47%), and high silica (6·25%) iron ore fines. High silica with high MgO sinter showed lower strength, higher reduction degradation index, and lower reducibility compared to low silica with low and high MgO and high silica with low MgO sinter. To achieve better sinter properties MgO content in the sinter should not be more than 2·80% when silica is more than 6·0%.
Keywords
Get full access to this article
View all access options for this article.