Corrosion behaviour of 304 austenitic stainless steel in simulated oilfield produced water at ∼25°C was investigated. The electrochemical properties of 304 stainless steel were assessed experimentally employing potentiodynamic polarisation and electrochemical impedance spectroscopy measurements. The corrosion mechanism of 304 stainless steel in simulated oilfield produced water along with appropriate modelling equivalent electrical circuits were deducted. Results showed that the corrosion rate is reduced with time. This behaviour does not indicate protection of 304 stainless steel. Instead, pits were formed on the surface of the specimens, and their evolution continued with time.
AhmadunF.-R.PendashtehA.AbdullahL. C.BiakD. R. A.MadaeniS. S. and AbidinZ. Z.: ‘Review of technologies for oil and gas produced water treatment.’J. Hazard. Mater., 2009170530–551. doi: 10.1016/j.jhazmat.2009.05.044
2.
ZhangY. L.DuM.ZhangJ. and DuJ. Q.: ‘Corrosion behavior of X65 carbon steel in simulated oilfield produced water’Mater. Corros., 201566366–374. doi: 10.1002/maco.201307448
3.
ZhangG. A. and ChengY. F.: ‘Localized corrosion of carbon steel in a CO2-saturated oilfield formation water’Electrochim. Acta2011561676–1685. doi: 10.1016/j.electacta.2010.10.059
4.
ZhangG. A. and ChengY. F.: ‘Corrosion of X65 steel in CO2-saturated oilfield formation water in the absence and presence of acetic acid’Corros. Sci., 2009511589–1595. doi: 10.1016/j.corsci.2009.04.004
5.
ZhangG. A. and ChengY. F.: ‘On the fundamentals of electrochemical corrosion of X65 steel in CO2-containing formation water in the presence of acetic acid in petroleum production’Corros. Sci., 20095187–94. doi: 10.1016/j.corsci.2008.10.013
6.
JiangX.ZhengY. G.QuD. R. and KeW.: ‘Effect of calcium ions on pitting corrosion and inhibition performance in CO2 corrosion of N80 steel’Corros. Sci., 2006483091–3108. doi: 10.1016/j.corsci.2005.12.002
7.
LiD. G.FengY. R.BaiZ. Q. and ZhengM. S.: ‘Characteristics of CO2 corrosion scale formed on N80 steel in stratum water with saturated CO2’Appl. Surf. Sci., 20072538371–8376. doi: 10.1016/j.apsusc.2007.04.011
8.
DingJ.ZhangL.LiD.LuM.XueJ. and ZhongW.: ‘Corrosion and stress corrosion cracking behavior of 316L austenitic stainless steel in high H2S–CO2–Cl2 environment.’J. Mater. Sci., 2013483708–3715. doi: 10.1007/s10853-013-7168-1
9.
PistoriusP. C. and BursteinG. T.: ‘Growth of corrosion pits on stainless steel in chloride solution containing dilute sulphate’Corros. Sci., 1992331885–1897. doi: 10.1016/0010-938X(92)90191-5
10.
LekatouA.ZoisD.KarantzalisA. E. and GrimanelisD.: ‘Electrochemical behaviour of cermet coatings with a bond coat on Al7075: pseudopassivity, localized corrosion and galvanic effect considerations in a saline environment’Corros. Sci., 2010522616–2635. doi: 10.1016/j.corsci.2010.04.010
11.
MohammadiF.NickchiT.AttarM. M. and AlfantaziA.: ‘EIS study of potentiostatically formed passive film on 304 stainless steel’Electrochim. Acta2011568727–8733. doi: 10.1016/j.electacta.2011.07.072
12.
StergioudiF.VogiatzisC. A.GkrekosK.MichailidisN. and SkolianosS. M.: ‘Electrochemical corrosion evaluation of pure, carburized and anodized Al foams’Corros. Sci., 201591151–159. doi: 10.1016/j.corsci.2014.11.017
13.
DiazB.HarkonenE.SwiatowskaJ.SeyeuxA.MauriceV.RitalaM. and MarcusP.: ‘Corrosion properties of steel protected by nanometre-thick oxide coatings’Corros. Sci., 201482208–217. doi: 10.1016/j.corsci.2014.01.024
14.
ZhangG. A. and ChengY. F.: ‘Electrochemical characterization and computational fluid dynamics simulation of flow-accelerated corrosion of X65 steel in a CO2-saturated oilfield formation water’Corros. Sci., 2010522716–2724. doi: 10.1016/j.corsci.2010.04.029
15.
DiazB.SwiatowskaJ.MauriceV.SeyeuxA.HarkonenE.RitalaM.TervakangasS.KolehmainenJ. and MarcusP.: ‘Tantalum oxide and coatings prepared by atomic layer and filtered cathodic arc deposition for corrosion protection of steel: comparative surface and electrochemical analysis’Electrochim. Acta201390232–245. doi: 10.1016/j.electacta.2012.12.007
16.
ChenC. and MansfeldF.: ‘Corrosion protection of an Al 6092/SiCp metal matrix composite’Corros. Sci., 1997391075–1082. doi: 10.1016/S0010-938X(97)00008-5
17.
OrazemM. and TribolletB.: ‘Electrochemical impedance spectroscopy’316–318; 2008Hoboken, NJWiley.
18.
SaeedikhaniM.JavidiM. and YazdaniA.: ‘Anodizing of 2024-T3 aluminum alloy in sulfuric–boric–phosphoric acids and its corrosion behavior’Trans. Nonferr. Met. Soc., 2013232551–2559. doi: 10.1016/S1003-6326(13)62767-3
19.
SongG-L. and LiuM.: ‘Corrosion and electrochemical evaluation of Al–Si–Cu aluminum alloy in ethanol solutions’Corros. Sci., 20137273–81. doi: 10.1016/j.corsci.2013.03.009
20.
FreireL.CarmezimM. J.FerreiraM. G. S. and MontemorM. F.: ‘The electrochemical behaviour of stainless steel AISI 304 in alkaline solutions with different pH in the presence of chlorides’Electrochim. Acta2011565280–5289. doi: 10.1016/j.electacta.2011.02.094
21.
ZhangP. Q.WuJ. X.ZhangW. Q.LuX. Y. and WangK.: ‘A pitting mechanism for passive 304 stainless steel in sulphuric acid media coating chloride ions’Corros. Sci., 199334, (8), 1343–1354. doi: 10.1016/0010-938X(93)90091-T
22.
AttiaA. A.SalihS. A. and BarakaA. M.: ‘Corrosion and passivation behaviors of some stainless steel alloys in molten alkali carbonates’Electrochim. Acta200248113–118. doi: 10.1016/S0013-4686(02)00506-6
23.
BautistaA.BlancoG.VelascoF.GutiιrrezA.SorianoL.PalomaresF. J. and TakenoutiH.: ‘Changes in the passive layer of corrugated austenitic stainless steel of low nickel content due to exposure to simulated pore solutions’Corros. Sci., 200951785–792. doi: 10.1016/j.corsci.2009.01.012
24.
Santana RodrıguezJ. J.Santana HernandezF. J. and Gonzalez GonzalezJ. E.: ‘Comparative study of the behaviour of AISI 304 SS in a natural seawater hopper, in sterile media and with SRB using electrochemical techniques and SEM’Corros. Sci., 2006481265–1278. doi: 10.1016/j.corsci.2005.04.007
25.
AbreuC. M.CristobalM. J.LosadaR.NovoaX. R.PenaG. and PerezM. C.: ‘Long-term behaviour of AISI 304L passive layer in chloride containing medium’Electrochim. Acta2006511881–1890. doi: 10.1016/j.electacta.2005.06.040
26.
YinZ. F.FengY. R.ZhaoW. Z.YinC. X. and TianW.: ‘Pitting corrosion behavior of 316 stainless steel in chloride solution with acetic acid and CO2’Corros. Eng., Sci. Technol., 20114656–63. doi: 10.1179/147842208X388780
27.
LopezD. A.SimisonS. N. and de SanchezS. R.: ‘Inhibitors performance in CO2 corrosion EIS studies on the interaction between their molecular structure and steel microstructure’Corros. Sci., 200547735–755. doi: 10.1016/j.corsci.2004.07.010
