Abstract
Gas assisted injection moulding has become one of the most important methods for the manufacture of plastic products. However, there are several unsolved problems that confound the overall success of this technique. The weldline caused by the flow lead effect in the polymer melt is one of them. In this report, an L′18 orthogonal array design based on the Taguchi method has been conducted to investigate the flow lead induced weldlines in gas assisted injection moulded parts. A plate cavity with a gas channel on the side was used for moulding. Experiments were carried out on an 80 t reciprocating screw injection moulding machine equipped with a high pressure gas injection unit. After moulding, the depth of the weldline was measured. For the factors selected in the main experiments, melt injection temperature and mould temperature were found to be the principal factors affecting the weldline depth of gas assisted injection moulded parts. Experimental investigation of a gas assisted injection moulding problem can help in better understanding the weldlines caused by flow lead effects, so that steps can be taken to optimise the surface quality of moulded parts. PRC/1755
Get full access to this article
View all access options for this article.