Basic Study on Laser Ablation Surface Cleaning of Nuclear Facility

Abstract

An ultra short pulsed Nd:YAG laser was employed to study the ablation effects and laser beam transport in optical fibres. Using 13 µm Zn coated carbon steel as a target, the relationship between ablation rate and laser fluence was investigated, and optimal processing conditions were determined. The laser induced products consisted of vapour and liquid particles. It was found that a smaller incident laser angle was more suitable for protecting the focusing lens from the pollution of the ablated products. The collection rate of the ablated products almost reached 100%. Additionally, a laser beam of over 5·6 W in power with a transportation rate of nearly 90% was output at the end of a 20 m long optical fibre. By this output power, a Zn coating of the same thickness could be completely ablated. A decontamination factor was introduced to estimate the cleaning effects of laser ablation, and satisfactory cleaning was obtained

Get full access to this article

View all access options for this article.

References

IMASAKI

: ‘Laser ablation cleaning of nuclear facilities’, Report of Institute for Laser Technology, Osaka, Japan, March 1999.

SEMEROK

A. F.

, CHALEARD

, DETALLE

et al.: Proc. Conf. on ‘High power laser ablation’, Santa Fe, NM, USA, April 1998, SPIE/The International Society for Optical Engineering, Part 2, Section 5, Paper 30. J. L. ocana, G. Nicolas, M. AUTRic et al.: in Proc. Conf. on ‘High power laser ablation’, Santa Fe, NM, USA, April 1998, SPIE/The International Society for Optical Engineering, Part 2, Section 5, Paper 16.

TSUNEMI

, ENDO

, and ICHISHIMA

: Proc. Conf. on ‘High power laser ablation’, Santa Fe, NM, USA, April 1998, SPIE/The International Society for Optical Engineering, Part 2, Section 5, Paper 26.

liu

and garmire

: Appl. Optics, 1995, 34, (21), 4409–4415.

Georgiou

, Zafiropulos

, Tomavi

et al.: Laser Phys. (Russia), 1998, 8, (1), 307–312.