Sage Journals: Discover world-class research

Abstract

Full-scale laboratory measurements were taken and 2D simulations were performed to determine the moisture convection performance of the joint of an external wall and an attic floor. Both the measured and simulated results showed that the building fabric is locally sensitive to exfiltration airflow as moisture convection could cause a remarkable increase in the moisture accumulation rate on the inner surface of the sheathing. The results prove that in modern houses with balanced ventilation, where the positive pressure caused by the stack effect cannot be easily controlled, it is essential to control moisture convection by good airtightness and the use of assembly solutions with improved hygrothermal performance, such as the case with mineral wool sheathing that was tested. The simulated results showed that the use of a constant moisture excess value instead of the profile did not cause any inaccuracy in the moisture content. At the same time, the use of the constant outdoor temperature over a long time period did change the hygrothermal performance, which became significantly more critical when simulated with variable outdoor temperatures. The laboratory measurement and simulation results show that in a cold climate, for the assemblies being studied with mineral wool sheathing, leakage rates of 0.1—0.2 L/(s·m) at a 10 Pa pressure difference may be used as performance criteria for moisture convection in a two-storey house with dimensioning moisture excess 4 g/m³ and a cold outdoor climate. Previous studies on the leakage characteristics show that these leakage rates are easily achievable in practice with careful workmanship.

Keywords

moisture convection air leakages hygrothermal performance exfiltration building envelope.

Get full access to this article

View all access options for this article.

References

Basset, M. ( 1987). Air Flow Resistance in Timber Frame Walls, Air Infiltration and Ventilation Centre, Moisture Workshop, 23.03.1987, Building Research Association of New Zealand.

Bomberg, M. and Onysko, D.M. ( 2002). Heat, Air and Moisture Control in Walls of Canadian Houses: A Review of the Historic Basis for Current Practices, J. Therm. Envelope Build. Sci., 26: 3-31.

Burch, D.M. and TenWolde, A. ( 1993). Computer Analysis of Moisture Accumulation in the Walls of Manufactured Housing, ASHRAE Transactions, 99: 977-990.

DIN 4108 Teil 3. Wärmeschutz im Hochbau; Klimabendingter Feuchteschults; Anforderungen und Hinweise für Planung und Ausfuührung, Deutsches Institut für Normung, 2001.

Grunewald, J. and Nicolai, A. ( 2006). CHAMPS-BES Program for Coupled Heat, Air Moisture and Pollutant Simulation in Building Envelope Systems, version 1, 2006, User Manual , p. 107.

Hagentoft, C.-E. and Harderup, E. ( 1996). Moisture Conditions in a North Facing Wall with Cellulose Loose Fill Insulation: Constructions with and without Vapor Retarder and Air Leakage, J. Therm. Envelope Build. Sci., 19: 228-243.

Janssens, A. ( 1998). Reliable Control of Interstitial Condensation in Lightweight Roof Systems, Calculation and Assessment Methods, Doctoral Dissertation, K.U. Leuven.

Janssens, A. and Hens, H. ( 2003). Interstitial Condensation Due to Air Leakage: a Sensitivity Analysis, J. Therm. Envelope Build. Sci., 27: 15-29.

Jokisalo, J. , Kurnitski, J. , Korpi, M. , Kalamees, T. and Vinha, J. ( 2009). Building Leakage, Infiltration, and Energy Performance Analyses for Finnish Detached Houses, Build. Environ., 44: 377-387.

10.

Karagiozis, A. ( 2001). Impact of Air Leakage on the Thermal and Moisture Performance of the Building Envelope, In: Proceedings of the Air Barriers III Conference: Air Barrier Solutions for Buildings in North American Climates, Washington, DC, US.

11.

Karagiozis, A.N. and Salonvaara, M.H. ( 1999). Hygrothermal Performance of EIFS-Clad Walls: Effect of Vapor Diffusion and Air Leakage on the Drying of Construction Moisture, ASTM Special Technical Publication, no. 1352, pp. 32-51.

12.

Kumaran, K. and Sanders, C. ( 2008). Final Report of the IEA Annex 41 Whole Building Heat Air and Moisture Response - Subtask 3: Boundary Conditions and Whole Building HAM Analysis, IEA Exco ECBCS.

13.

Kalamees, T. , Korpi, M. , Eskola, L. , Kurnitski, J. and Vinha, J. ( 2008). The Distribution of the Air Leakage Places and Thermal Bridges in Finnish Detached Houses and Apartment Buildings, In: Proceedings of the 8th Symposium on Building Physics in the Nordic Countries, Copenhagen, Denmark.

14.

Kalamees, T. , Vinha, J. and Kurnitski, J. ( 2006). Indoor Humidity Loads and Moisture Production in Lightweight Timber-frame Detached Houses, J. Build. Phys., 29: 219-246.

15.

Kalamees, T. , Kurnitski, J. , Jokisalo, J. , Eskola, L. , Jokiranta, K. and Vinha, J. ( 2007). Air Pressure Conditions in Finnish Residences, In: Seppänen, O. and Säteri, J.H. (eds), REHVA World Congress: Clima 2007 WellBeing Indoors, Proceedings of Clima 2007 WellBeing Indoors, Helsinki, Finland, FINVAC, p. 278.

16.

Kalamees, T. and Vinha, J. ( 2004). Estonian Climate Analysis for Selecting Moisture Reference Years for Hygrothermal Calculations, J. Therm. Envelope Build. Sci., 27: 199-220.

17.

Ojanen, T. and Kumaran, K. ( 1996). Effect of Exfiltration on the Hygrothermal Behaviour of a Residential Wall Assembly, J. Therm. Insulation Build. Environ., 19: 215-227.

18.

Sandberg, P.-I. and Sikander, E. ( 2004). Lufttähetsfragorna i byggprocessen - Kunskapsinventering, aboratoriemätningar och simuleringar for att kartlägga behov av tekniska lösningar och utbildning, SP Energiteknik, SP Swedish National Testing and Research Institute, SP Rapport 2004:22. Borås.

19.

Sandberg, P.-I. and Sikander, E. ( 2007). Lufttäthetsfrågorna i byggprocessen - Etapp B. Tekniska konsekvenser och lönsamhetskalkyler, SP Energiteknik, SP Swedish National Testing and Research Institute, SP Report 2007:23. Boras.

20.

Vinha, J. , Valovirta, I. , Korpi, M. , Mikkilä, A. and Käkelä, P. ( 2005). Rakennusmateriaalien rakennusfysikaaliset ominaisuudet lämpötilan ja suhteellisen kosteuden funktiona (Building Physic Material Properties as a Function of Temperature and Relative Humidity), Tampere University of Technology, Department of Civil Engineering, Structural Engineering Laboratory, Research report 129. Tampere 2005 (in Finnish).

21.

Vinha, J. ( 2007). Hygrothermal Performance of Timber-framed External Walls in Finnish Climatic Conditions. A Method for Determining the Sufficient Water Vapour Resistance of the Interior Lining of a Wall Assembly, Doctoral Thesis, Tampere University of Technology, Publication 658. p. 338.

22.

Wilson, A.G. and Garden, G.K. ( 1965). Moisture Accumulation in Walls Due to Air Leakage, In: RILEM/CIB Symposium on Moisture Problems in Buildings, Vol. 1, Helsinki.

Moisture Convection Performance of External Walls and Roofs

Abstract

Keywords

Get full access to this article

References