Di(2-ethylhexyl) terephthalate (DEHTP) is a promising substitute for dioctyl phthalate (DOP, banned in certain countries) as a polyvinyl chloride (PVC) plasticizer. This research endeavors to present findings about the synthesis of DEHTP through the depolymerization of polyethylene terephthalate (PET) with 2-ethyl-1-hexanol, the production and assessment of PVC formulated with this plasticizer, and a comparative analysis with PVC compounded using commercial plasticizers (DOP and DEHTP). Approximately 200 post-consumer PET bottles underwent chemical recycling under various conditions, leading to complete depolymerization (99%) following a six-hour reaction at 300°C. The plasticizers were characterized by infrared spectroscopy, 1H nuclear magnetic resonance spectroscopy, and gas chromatography coupled to mass spectrometry. The flexible PVCs were tensile and hardness tested and submitted to dynamic mechanical and thermogravimetric analyses. The resulting plasticizer exhibited properties analogous to commercial DEHTP, producing flexible PVC with even better properties. For instance, the activation energy of the dehydrochlorination reaction of the flexible PVC produced with DHETP from depolymerization was 3.3% to 16.2% higher than those produced with commercial plasticizers.
Miliute-PlepieneJFråneAAlmasiAM. Overview of polyvinyl chloride (PVC) waste management practices in the Nordic countries. Clean Eng Technol2021; 4: 100246. DOI: 10.1016/j.clet.2021.100246.
6.
Rodolfo JuniorAMeiLHI. Mecanismos de degradação e estabilização térmica do PVC (Mechanisms of PVC thermal degradation and stabilization). Polimeros2007; 17: 263–2757. DOI: 10.1590/S0104-14282007000300018.
FirdovsiSTYagoubMParvinAE. Transesterification reaction of dimethyl terephthalate by 2-ethylhexanol in the presence of heterogeneous catalysts under solvent-free condition. Chin J Chem2007; 25: 246–249. DOI: 10.1002/cjoc.200790049.
14.
SilvaMJSamandarECalafatAM, et al.Identification of di-2-ethylhexyl terephthalate (DEHTP) metabolites using human liver microsomes for biomonitoring applications. Toxicol Vitro2015; 29: 716–721. DOI: 10.1016/j.tiv.2015.02.002.
15.
ZhouLLuXJuZ, et al.Alcoholysis of polyethylene terephthalate to produce dioctyl terephthalate using choline chloride-based deep eutectic solvents as efficient catalysts. Green Chem2019; 21: 897–906. DOI: 10.1039/C8GC03791D.
XuYCuiRHanY, et al.Efficient alcoholysis of poly (ethylene terephthalate) by using supercritical carbon dioxide as a green solvent. Polymers2024; 16: 1564. DOI: 10.3390/polym16111564.
GuthrieJP. Concerted mechanism for alcoholysis of esters: an examination of the requirements. J Am Chem Soc1991; 113: 3941–3949.
20.
DutKSoniRK. Syntehesis and characterization of polymeric plasticizer from PET waste and its applications in nitrile rubber and nitrile-PVC blend. Iran Polym J (Engl Ed)2013; 22: 481–491. DOI: 10.1007/s13726-013-0148-0.
DingJChenJJiY, et al.Kinetics of alcoholysis of poly(ethylene terephthalate) in sub- and super-critical isooctyl alcohol to produce dioctyl terephthalate. J Anal Appl Pyrol2014; 106: 99–103. DOI: 10.1016/j.jaap.2014.01.005.
23.
ChenJHenJLvJ, et al.Alcoholysis of PET to produce dicotyl terephthalate by isooctyl alcohol with ionic acid as cosolvent. Polym Degrad Stabil2014; 107: 178–183. DOI: 10.1016/j.polymdegradstab.2014.05.013.
24.
LiuFChenJLiZ, et al.Alcoholysis of poly(ethylene terephthalate) to produce dioctyl terephthalate with sub- and super-critical isooctyl alcohol. J Anal Appl Pyrol2013; 99: 16–22. DOI: 10.1016/j.jaap.2012.11.008.
25.
HeWZhuGGaoY, et al.Green plasticizers derived from epoxidized soybean oil for poly (vinyl chloride): continuous synthesis and evaluation in PVC films. Chem Eng J2020; 380: 122532. DOI: 10.1016/j.cej.2019.122532.
26.
LeeBMJungJGwonHJ, et al.Synthesis and properties of isosorbide-based eco-friendly plasticizers for poly(vinyl chloride). J Polym Environ2023; 31: 1351–1358. DOI: 10.1007/s10924-022-02643-7.
27.
LiuDJiangPNieZ, et al.Synthesis of an efficient bio-based plasticizer derived from waste cooking oil and its performance testing in PVC. Polym Test2020; 90: 106625. DOI: 10.1016/j.polymertesting.2020.106625.
28.
TanJZhangSLuT, et al.Design and synthesis of ethoxylated esters derived from waste frying oil as anti-ultraviolet and efficient primary plasticizers for poly(vinyl chloride). J Clean Prod2019; 229: 1274–1282. DOI: 10.1016/j.jclepro.2019.04.395.
29.
ChenRDengSCuiT, et al.Progress in recycling and reutilization of waste polyethylene terephthalate. Prog Rubber Plast Re2023; 40: 77–97. DOI: 10.1177/14777606231195399.
30.
Associação Brasileira da Indústria do (The BrazilianPETPET Association). Censo da Reciclagem de PET no Brasil (Survey on Recycling of PET in Brazil). 12th ed.São Paulo, Brazi: Abipet, 2022. https://www.abipet.org.br/publicacoes(accessed 08 March 2024).
31.
ChanpiwatPNumprasanthaiA. Factors affecting cadmium toxicity to rice germinated in soils collected from downstream areas of abandoned zinc mines. Global J Environ Sci Manage2024; 10: 133–154. DOI: 10.22034/gjesm.2024.01.10.
32.
ASTMStandard 638. Standard test method for tensile properties of plastics. Annual Book of ASTM Standards. West Conshohocken, USA: ASTM International, 2000.
BoySBöhmeK. Determination of kinetic parameters from TG curves by non-linear optimization. Thermochim Acta1981; 46: 229-237. DOI: 10.1016/0040-6031(81)80321-8.
35.
RodolfoAJrInnocentini‐MeiLH. Synthesis of copper(II)-zinc-molybdenum compounds as smoke suppressants for PVC compositions. Fire Mater2021; 45: 396–405. DOI: 10.1002/fam.2817.
36.
SilversteinRMBasslerCGMorrilTC. Spectrometric identification of organic compounds. 4th ed.New York, NY: John Wiley & Sons, 1981.
RomãoWSpinacéMASPaoliMAD. Poli(tereftalato de etileno), PET: uma revisão sobre os processos de síntese, mecanismos de degradação e sua reciclagem. Polimeros2009; 19: 121–132. DOI: 10.1590/S0104-14282009000200009.
GallandGBTavaresMIB. Ressonância magnética nuclear (nuclear magnetic resonance). In: Canevarolo JúniorSV (ed). Técnicas de Caracterização de Polímeros (Polymer characterization techniques). São Paulo, Brazil: Artliber, 2004, pp. 61–82.
42.
GenaySFeutryFMasseM, et al.Identification and quantification by 1H nuclear magnetic resonance spectroscopy of seven plasticizers in PVC medical devices. Anal Bioanal Chem2017; 409: 1271–1280. DOI: 10.1007/s00216-016-0053-4.
43.
LiuSZhouLLiL, et al.Isooctanol alcoholysis of waste polyethylene terephthalate in acidic ionic liquid. J Polym Res2013; 20: 310–315. DOI: 10.1007/s10965-013-0310-6.
Rodolfo JuniorANunesLROrmanjiW. Tecnologia do PVC (PVC technology). 1st ed.São Paulo, Brazil: ProEditores/Braskem, 2006.
46.
LandelRFNielsenLE. Mechanical properties of polymer and composites. 1st ed.New York, NY: CRC Press, 1993.
47.
BudrugeacP. An iterative model-free method to determine the activation energy of non-isothermal heterogeneous processes. Thermochim Acta2010; 511: 8–16. DOI: 10.1016/j.tca.2010.07.018.
48.
Sánches-JiménezPEPerejónACriadoJM, et al.Kinetic model for thermal dehydrochlorination of poly(vinyl chloride). Polymer2010; 51: 3998–4007. DOI: 10.1016/j.polymer.2010.06.020.
49.
SlapakMJPVan KasterenJMNDrinkenburgAAH. Determination of the pyrolytic degradation kinetics of virgin-PVC and PVC-waste by analytical and computational methods. Comput Theor Polym Sci2000; 10(10): 481–489. DOI: 10.1016/S1089-3156(99)00055-0.
50.
SimõesPNCoelhoJFJGonçalvezPMFO, et al.Comparative non-isothermal kinetic analysis of thermal degradation of poly(vinyl chloride) prepared by living and conventional free radical polymerization methods. Eur Polym J2009; 45: 1949–1959. DOI: 10.1016/j.eurpolymj.2009.04.021.
51.
DuGDuanJJiaP, et al.Preparation of intercalated hydrotalcite materials and its effect on thermal stability properties of polyvinyl chloride. Prog Rubber Plast Re2024; 40: 357–377. DOI: 10.1177/14777606241229205.
