Welding is a commonly used method for joining two or more parts together in steel construction. Various defects in weld regions such as cracks, pores, and slag inclusion can be present from the beginning, generated during the welding process, or can be developed while in service. Such defects are the weak spots that degrade the structure’s quality and can lead to structural failures. Therefore, early detection of these defects in welded joints, before visible cracks appear, is very important. Using appropriate ultrasonic non-destructive testing and evaluation (NDT&E) techniques, one can detect these defects and take remedial actions to prevent catastrophic structural failures. Guided acoustic wave-based techniques have been proven to be effective for damage detection in steel pipes and rods. Several studies have previously attempted to detect damage in steel tubes using guided ultrasonic waves. Unlike earlier attempts which mostly focused on conventional linear ultrasonic techniques, a relatively new nonlinear ultrasonic technique called sideband peak count-index (SPC-I) is carried out in this research. For this investigation, cast steel components and round hollow structural sections are welded together, and a four-point bending test is conducted under fatigue loading. The welded joints are continuously monitored in real time using strain gages and lead zirconate titanate (PZT) transducers. The PZT transducers are used to generate and receive guided acoustic waves. The signal is propagated through the specimen in a single-sided transmission mode setup. The strain gage readings and the nonlinear ultrasonic parameter, the SPC-I values, are monitored simultaneously. The results obtained from the nonlinear ultrasonic NDT&E measurements are compared with the data obtained from the strain gages to determine the robustness and reliability of the SPC-I technique for monitoring welded joints. This investigation also shows the potential effectiveness of the nonlinear ultrasonic parameter SPC-I for early detection of weld failure.
WangKLiuMSuZ, et al. Analytical Insight into ‘breathing’ crack-induced acoustic nonlinearity with an application to quantitative evaluation of contact cracks. Ultrasonics2018; 88: 157–167.
9.
JhangKY. Applications of nonlinear ultrasonics to the NDE of material degradation. IEEE Trans Ultrasonics Ferroelectr Freq Control2000; 47(3): 540–548.
10.
CantrellJHYostWT. Nonlinear ultrasonic characterization of fatigue microstructures. Int J Fatigue2001; 23; S487–S490.
11.
HikataAElbaumC. Generation of ultrasonic second and third harmonics due to dislocations. Phys Rev1966; 144(2): 469–477.
12.
BuckOMorrisWLRichardsonJM. Acoustic harmonic generation at unbonded interfaces and fatigue cracks. Appl Phys Lett1978; 33(5): 371–373.
13.
MeeganGDJohnsonPAGuyerRA, et al. Observations of nonlinear elastic wave behavior in sandstone. J Acoust Soc Am1993; 94:3387–3391.
JhangK-YKimK-C. Evaluation of material degradation using nonlinear acoustic effect. Ultrasonics1999; 37(1): 39–44.
16.
BiwaSNakajimaSOhnoN. On the acoustic nonlinearity of solid–solid contact with pressure-dependent interface stiffness. ASME J Appl Mech2004; 71(4): 508–515.
17.
StaufferJDWoodwardCBWhiteKR. Nonlinear ultrasonic testing with resonant and pulse velocity parameters for early damage in concrete. ACI Mater J2005; 102(2): 4–7.
18.
KimJ-YBaltazarAHuJW, et al. Hysteretic linear and nonlinear acoustic responses from pressed interfaces. Int J Solids Struct2006; 43(21): 6436–6452.
19.
ShahAARibakovYHiroseS. Nondestructive evaluation of damaged concrete using nonlinear ultrasonics. Mater Des2009; 30(3): 775–782.
20.
YanDDrinkwaterBWNeildS. Measurement of the ultrasonic nonlinearity of kissing bonds in adhesive joints. NDT Int2009; 42(5): 459–466.
21.
AmuraMMeoMAmeriniF. Baseline-free estimation of residual fatigue life using a third order acoustic nonlinear parameter. J Acoust Soc Am2011; 130(4): 1829–1837.
22.
LiWChoYHyunS. Characteristics of ultrasonic nonlinearity by thermal fatigue. Int J Precis Eng Manuf2012; 13(6): 935–940.
23.
LiWChoYAchenbachJD. Detection of thermal fatigue in composites by second harmonic lamb waves. Smart Mater Struct2012; 21(8): 085019.
24.
MatlackKHKimJ-YJacobsLJ, et al. Review of second harmonic generation measurement techniques for material state determination in metals. J Nondestruct Eval2015; 34(1): 273.
25.
LvHJiaoJWuB, et al. Evaluation of fatigue crack orientation using non-collinear shear wave mixing method. J Nondestruct Eval2018; 37(4): 74.
26.
LiWXuYHuN, et al. Impact damage detection in composites using a guided wave mixing technique. Meas Sci Technol2019; 31(1): 014001.
27.
XuWSuZRadzieńskiM, et al. Nonlinear pseudo-force in a breathing crack to generate harmonics. J Sound Vib2021; 492: 115734.
28.
XuLSuYWangK, et al. An elastodynamic reciprocity theorem-based closed-form solution to second harmonic generation of lamb waves by a fatigue crack: theory & experimental validation. J Sound Vib2021; 509: 116226.
29.
Van Den AbeeleKE-AJohnsonPASutinA. Nonlinear elastic wave spectroscopy (NEWS) techniques to discern material damage, Part I: nonlinear wave modulation spectroscopy (NWMS). Res Nondestruct Eval2000; 12(1): 17–30.
30.
Van Den AbeeleKE-ACarmelietJTen CateJA, et al. Nonlinear elastic wave spectroscopy (NEWS) techniques to discern material damage, Part II: single-mode nonlinear resonance acoustic spectroscopy. Res Nondestruct Eval2000; 12(1): 31–42.
31.
ChenXJKimJ-YKurtisKE, et al. Characterization of progressive microcracking in Portland cement mortar using nonlinear ultrasonics. NDT Int2008; 41(2): 112–118.
32.
YoderNCAdamsDE. Vibro-acoustic modulation using a swept probing signal for robust crack detection. Struct Health Monit2010; 9(3): 257–267.
33.
EirasJNPopovicsJSBorracheroMV, et al. Nonlinear impact resonant acoustic spectroscopy to discern mechanical damage in cement based materials. In: 15th international conference on experimental mechanics, University of Porto, Portugal, 2012.
34.
KlepkaAStaszewskiWJJenalRB, et al. Nonlinear acoustics for fatigue crack detection – experimental investigations of vibro-acoustic wave modulations. Struct Health Monit2012; 11(2): 197–211.
35.
ZhouCHongMSuZ, et al. Evaluation of fatigue cracks using nonlinearities of acousto-ultrasonic waves acquired by an active sensor network. Smart Mater Struct2013; 22(1): 015018.
36.
SohnHLimHJDeSimioMP, et al. Nonlinear ultrasonic wave modulation for fatigue crack detection. J Sound Vib2013; 333(5): 1473–1484.
37.
EirasJNKunduTBomillaM, et al. Nondestructive monitoring of ageing of alkali resistant glass fiber reinforced cement (GRC). J Nondestruct Eval2013; 32(2–13): 300–314.
38.
LiuPSohnHKunduT, et al. Noncontact detection of fatigue cracks by laser nonlinear wave modulation spectroscopy (LNWMS). NDT Int2014; 66: 106–116.
39.
KunduTEirasJNLiW, et al. Chapter 1: Fundamentals of nonlinear acoustical techniques and sideband peak count. In: KunduT (ed.) Nonlinear ultrasonic and vibro-acoustical techniques for nondestructive evaluation. Switzerland: Springer Nature, 2019, pp. 1–88.
40.
KunduT. Chapter 4: Nonlinear ultrasonic techniques for nondestructive evaluation. In: KunduT (ed.) Mechanics of elastic waves and ultrasonic nondestructive evaluation. Boca Raton, FL: CRC Press, Taylor and Francis Group, 2019, pp. 287–315.
41.
AlnuaimiHAmjadURussoP, et al. Monitoring damage in composite plates from crack initiation to macro-crack propagation combining linear and nonlinear ultrasonic techniques. Struct Health Monit2021; 20(1): 139–150.
42.
BasuSThirumalaiselviASasmalS, et al. Nonlinear ultrasonics based technique for monitoring damage progression in reinforced concrete structures. Ultrasonics2021; 115: 106472.
43.
ArumaikaniTSasmalSKunduT. Detection of initiation of corrosion induced damage in concrete structures using nonlinear ultrasonic techniques. J Acoust Soc Am2021; 151(2): 1341–1352.
44.
CastellanoAFraddosioAPiccioniMD, et al. Linear and nonlinear ultrasonic techniques for monitoring stress-induced damages in concrete. ASME J Nondestruct Eval2021; 4(4): 041001.
45.
Nikvar-HassaniAAlnuaimiHNAmjadU, et al. Alkali activated fly ash based concrete: evaluation of curing process using non-linear ultrasonic approach. ASME J Nondestruct Eval2022; 5(2): 021006.
46.
AlnuaimiHAmjadUParkS, et al. An improved nonlinear ultrasonic technique for detecting and monitoring impact induced damage in composite plates. Ultrasonics2022; 119: 106620.
47.
ParkSKunduT. A modified sideband peak count based nonlinear ultrasonic technique for material characterization. Ultrasonics2023; 128: 106585.
48.
ParkSBokhariIAlnuaimiH, et al. Inspection of steel tube welded joint using nonlinear ultrasonic technique. In: Proceedings of the SPIE 12048, health monitoring of structural and biological systems, California, 19 April 2022, vol. XVI, p. 120480V. SPIE.
49.
ZhangGLiXZhangS, et al. Sideband peak count – index technique for monitoring multiple cracks in plate structures using ordinary state-based peri-ultrasound theory. J Acoust Soc Am2022; 152: 3035–3048.
