This paper aims to better understand the onset and intensity of controlled end-gas autoignition (c-EGAI), which can help extend the knock limit of pilot-injection-ignited combustion modes. A set of experiments was designed where the pilot injection pressure (PInj), pilot start of injection (SOI) thermodynamic conditions, and premixed equivalence ratio were varied to induce c-EGAI. Common knock detection techniques such as maximum amplitude of pressure oscillation (MAPO), ringing intensity (RI), and signal energy ratio (SER) were found lacking in their ability to adequately characterize c-EGAI, suggesting that the underlying mechanism differs from conventional knock. Short time Fourier Transform (STFT) analysis showed that c-EGAI excited frequencies in the vicinity of the lowest resonant mode, with amplitudes comparable or greater than the diesel pilot ignition. The number and magnitude of the peaks in the fundamental cylinder oscillation modes (found from STFT) was able to correctly quantify the c-EGAI onset and intensity. To substantiate the time-frequency analysis, a kinetic analysis was performed. The kinetic predictions of end gas autoignition had a 1:1 scaling with the c-EGAI onset determined using the STFT.
SrinivasanKAgarwalAKrishnanS, et al. Natural gas engines: for transportation and power generation. Springer, 2018.
2.
KarimG.Dual-fuel diesel engines. CRC Press, 2015.
3.
WeiLGengP.A review on natural gas/diesel dual fuel combustion, emissions and performance. Fuel Process Technol2016; 142: 264–278.
4.
YousefiAGuoHBiroukM.Effect of diesel injection timing on the combustion of natural gas/diesel dual-fuel engine at low-high load and low-high speed conditions. Fuel2019; 235: 838–846.
5.
MousaviSMSarayRKBahlouliK, et al. Effects of pilot diesel injection strategies on combustion and emission characteristics of dual-fuel engines at part load conditions. Fuel2019; 258: 116153.
6.
García ValladolidPTunestålPMonsalve-SerranoJ, et al. Impact of diesel pilot distribution on the ignition process of a dual fuel medium speed marine engine. Energy Convers Manag2017; 149: 192–205.
7.
WangZZhaoZWangD, et al. Impact of pilot diesel ignition mode on combustion and emissions characteristics of a diesel/natural gas dual fuel heavy-duty engine. Fuel2016; 167: 248–256.
8.
WeaverCTurnerS. Dual fuel natural gas/diesel engines: Technology, performance, and emissions. International Congress & Exposition. 1994, 3.
9.
KahilaHKaarioOAhmadZ, et al. A large-eddy simulation study on the influence of diesel pilot spray quantity on methane-air flame initiation. Combust Flame2019; 206: 506–521.
10.
Zetterdahl (Anderson)M.SaloKFridellE. Particle- and gaseous emissions from an LNG powered ship. Environ Sci Technol2015; 49: 9.
11.
UshakovSStenersenDEinangPM.Methane slip from gas fuelled ships: a comprehensive summary based on measurement data. J Mar Sci Technol2019; 24: 1308–1325.
12.
HampsonG.High efficiency natural gas engine combustion using controlled auto-ignition. In: Internal combustion engine division fall technical conference, Chicago, IL, 2019.
13.
BayliffSWindomBMarcheseA, et al. Controlled end gas auto ignition with exhaust gas recirculation on a stoichiometric, spark ignited, natural gas engine. In: Internal combustion engine division fall technical conference, Virtual, 2020.
14.
RaduBMartinGChiriacR, et al. On the knock characteristics of LPG in a spark ignition engine. (No. 2005-01-3773). SAE Technical Paper, 2005.
GawaleGThombareD. Simulation of HCCI engine for performance optimization. In: National conference for engineering post graduates. Uran Islampur, India, 2015.
17.
HairuddinAAYusafTWandelAP.A review of hydrogen and natural gas addition in diesel HCCI engines. Renew Sustain Energ Rev2014; 32: 739–761.
18.
KokjohnSLHansonRMSplitterDA, et al. Fuel reactivity controlled compression ignition (RCCI): a pathway to controlled high-efficiency clean combustion. Int J Eng Res2011; 12: 209–226.
19.
LiuXKokjohnSLiY, et al. A numerical investigation of the combustion kinetics of reactivity controlled compression ignition (RCCI) combustion in an optical engine. Fuel2019; 241: 753–766.
20.
HockettAGHampsonGMarcheseAJ.Natural gas/diesel RCCI CFD simulations using multi-component fuel surrogates. Int J Powertrains2017; 6(1): 76.
21.
NiemanDEDempseyABReitzRD.Heavy-duty RCCI operation using natural gas and Diesel. SAE Int J Engines2012; 5: 270–285.
22.
MartinJBoehmanATopkarR, et al. Intermediate combustion modes between conventional diesel and RCCI. SAE Int J Engines2018; 11: 835–860.
23.
IICurranSPrikhodkoVWagnerR, et al. In-cylinder fuel blending of gasoline/diesel for improved efficiency and lowest possible emissions on a multi-cylinder light-duty diesel engine. SAE Technical Papers. 2010.
24.
YunHWermuthNNajtP.High Load HCCI operation using different valving strategies in a naturally-aspirated gasoline HCCI engine. SAE Int J Engines2011; 4: 1190–1201.
25.
YunHWermuthNNajtP.Extending the high load operating limit of a naturally-aspirated gasoline HCCI combustion engine. SAE Int J Engines2010; 3: 681–699.
26.
PotrzebowskiAMisztalJXuHM, et al. An autoignition combustion model for homogeneous charge compression ignition engine cycle simulations. Proc Inst Mech Eng D J Automobile Eng2009; 223: 1207–1221.
27.
KaragiorgisSCollingsNGloverK, et al. WeC14.2 dynamic modeling of combustion and gas exchange processes for controlled auto-ignition engines. 2006.
28.
HernándezJJLapuertaMSanz-ArgentJ.Autoignition prediction capability of the Livengood–Wu correlation applied to fuels of commercial interest. Int J Engine Res2014; 15: 817–829.
29.
AzimovUTomitaEKawaharaN, et al. Premixed mixture ignition in the end-gas region (PREMIER) combustion in a natural gas dual-fuel engine: operating range and exhaust emissions. Int J Engine Res2011; 12: 484–497.
30.
Valipour BerenjestanakiAKawaharaNTsuboiK, et al. End-gas autoignition characteristics of PREMIER combustion in a pilot fuel-ignited dual-fuel biogas engine. Fuel2019; 12 pp. 484-497 (2011,10) 254: 115634.
31.
AksuCKawaharaNTsuboiK, et al. Extension of PREMIER combustion operation range using split micro pilot fuel injection in a dual fuel natural gas compression ignition engine: A performance-based and visual investigation. Fuel2016; 185: 243–253.
32.
BauckeDPWiseDMBremmerRJ, et al. Experimental evaluation of the methane number measurement procedure for gaseous fuel rating. Energies2024; 17: 2172.
33.
BrecqGBellettreJTazeroutM.A new indicator for knock detection in gas SI engines. Int J Therm Sci2003; 42: 523–532.
34.
NajtP.Evaluating threshold knock with a semi-empirical model—Initial results. SAE Transactions. pp. 920-933 (1987)
35.
Abu-QudaisM.Exhaust gas temperature for knock detection and control in spark ignition engine. Energy Convers Manag1996; 37: 1383–1392.
36.
GotoSItohY.Development of Lean Burn High-output spark-ignited gas engines(experimental study of knocking in lean burn gas engines). Trans Jpn Soc Mech Eng1997; 63: 1055–1061.
37.
KonigGSheppardC.End Gas Autoignition and Knock in a Spark Ignition Engine. International Fuels & Lubricants Meeting & Exposition. (1990,10)
38.
BurgdorfKDenbrattI.Comparison of Cylinder Pressure Based Knock Detection Methods. International Fuels & Lubricants Meeting & Exposition. (1997,10)
39.
WorretRBernhardtSSchwarzF, et al. Application of different cylinder pressure based knock detection methods in spark ignition engines. Spring Fuels & Lubricants Meeting & Exhibition. 2002.
40.
XiaofengGStoneRHudsonC, et al. The detection and quantification of knock in spark ignition engines. International Fuels & Lubricants Meeting & Exposition. 1993.
41.
EngJ.Characterization of pressure waves in HCCI combustion. SAE Technical Paper, 2002.
42.
YunHMirskyW.Schlieren-streak measurements of instantaneous exhaust gas velocities from a spark-ignition engine. SAE Transactions. pp. 3143-3158 (1974)
43.
KrishnanS. Advanced analysis of biomedical signals. In: AkayM (ed.) Biomedical signal analysis for connected healthcare. Wiley, 2021, pp.157–222.
44.
JeonHJungYLeeS, et al. Area-efficient short-time Fourier transform processor for time–frequency analysis of non-stationary signals. Appl Sci2020; 10: 7208.
45.
GriffinDLimJ.Signal estimation from modified short-time Fourier transform. IEEE Trans Acoust Speech Signal Process1984; 32: 236–243.
46.
ZhuXBeauregardGTWyseLL.Real-time signal estimation from modified short-time Fourier transform magnitude spectra. IEEE Trans Audio Speech Lang Process2007; 15: 1645–1653.
47.
Hofmann-WellenhofBMoritzH.Introduction to spectral analysis. In: SunkelH (ed.) Mathematical and numerical techniques in physical geodesy. Springer, 2005, pp.157–259.
48.
BelattarS.Signals and systems exercises-part A. Belacademya, 2021.
49.
Cohen TenoudjiF. Time–frequency analysis. In: HartmanW (ed.) Analog and digital signal analysis: from basics to applications. Springer, 2016, pp.207–226.
50.
DraperCSMorsePM.Acoustical analysis of the pressure waves accompanying detonation in the internal-combustion engine. J Aeronaut Sci1939; 10: 259–226.
51.
KesslerFM.Engine Noise: excitation, vibration, and radiation. edited by HicklingRobertKamalMounir M. J Acoust Soc Am1983; 74: 1661–1661.
52.
LivengoodJWuP.Correlation of autoignition phenomena in internal combustion engines and rapid compression machines. Symp (Int) Comb1955; 5: 347–356.
HealyDKalitanDAulC, et al. Oxidation of C1-C5 alkane quinternary natural gas mixtures at high pressures. Energy Fuels2010; 24: 2.
55.
HealyDDonatoNAulC, et al. Isobutane ignition delay time measurements at high pressure and detailed chemical kinetic simulations. Combustion Flame2010; 157: 1540–1551.
56.
ZhouCWLiYBurkeU, et al. An experimental and chemical kinetic modeling study of 1,3-butadiene combustion: ignition delay time and laminar flame speed measurements. Combust Flame2018; 197: 423–438.
57.
JanecekD. Experimental Investigation of natural gas kinetics using a fuel substitution method. ProQuest, 2018.
