A large fraction of diesel engine tailpipe NOx emissions are emitted before the aftertreatment components reach effective operating temperatures. As a result, it is essential to develop technologies to accelerate initial aftertreatment system warm-up. This study investigates the use of early exhaust valve opening (EEVO) and its combination with negative valve overlap to achieve internal exhaust gas recirculation (iEGR), for aftertreatment thermal management, both at steady state loaded idle operation and over a heavy-duty federal test procedure (HD-FTP) drive cycle. The results demonstrate that implementing EEVO with iEGR during steady state loaded idle conditions enables engine outlet temperatures above 400 °C, and when implemented over the HD-FTP, is expected to result in a 7.9% reduction in tailpipe-out NOx.
StadlbauerSWaschlHSchillingAdel ReL. DOC temperature control for low temperature operating ranges with post and main injection actuation. SAE technical paper 2013-01-1580, 2013.
2.
SongXSurenahalliHNaberJParkerGJohnsonJH. Experimental and modeling study of a diesel oxidation catalyst (DOC) under transient and CPF active regeneration conditions. SAE technical paper 2013-01-1046, 2013.
3.
KoebelMElsenerMKleemannM. Urea-SCR: a promising technique to reduce NOx emissions from automotive diesel engines. Catal Today2000; 59(3): 335–345.
4.
CharltonSDollmeyerTGranaT. Meeting the US heavy-duty EPA 2010 standards and providing increased value for the customer. SAE Int J Commer Veh2010; 3(1): 101–110.
5.
GirardJCavataioGSnowRLambertC. Combined Fe-Cu SCR systems with optimized ammonia to NOx ratio for diesel NOx control. SAE Int J Fuels Lubr2009; 1(1): 603–610.
6.
StantonDW. Systematic development of highly efficient and clean engines to meet future commercial vehicle greenhouse gas regulations. SAE Int J Engines2013; 6(3): 1395–1480.
7.
LambertCHammerleRMcGillRKhairMSharpC. Technical advantages of urea SCR for light-duty and heavy-duty diesel vehicle applications. SAE Trans2004; 113(4): 580–589.
8.
HouXMaYPengFYanFZhangX. Research on temperature characteristics of dpf regeneration technology based on catalytic combustion of fuel injection. In: Proceedings of the Asia-Pacific power and energy engineering conference, Chengdu, China, 28–31 March 2010, pp.1–4. New York: IEEE.
9.
GehrkeSKovácsDEiltsPRempelAEckertP. Investigation of VVA-based exhaust management strategies by means of a HD single cylinder research engine and rapid prototyping systems. SAE Int J Commer Veh2013; 6(1): 47–61.
10.
MayerALutzTLämmleCWyserMLegererF. Engine intake throttling for active regeneration of diesel particle filters. SAE technical paper 2003-01-0381, 2003.
11.
DingCRobertsLFainDJRameshAKShaverGMMcCarthyJet al. Fuel efficient exhaust thermal management for compression ignition engines during idle via cylinder deactivation and flexible valve actuation. Int J Engine Res2015; 17: 619–630.
12.
RameshAKShaverGMAllenCMNayyarSGosalaDBParraDCet al. Utilizing low airflow strategies, including cylinder deactivation, to improve fuel efficiency and after treatment thermal management. Int J Engine Res. Epub ahead of print 14March2017. DOI: 10.1177/1468087417695897.
13.
GargAMageeMDingCRobertsLShaverGKoeberleinEet al. Fuel-efficient exhaust thermal management using cylinder throttling via intake valve closing timing modulation. Proc IMechE, Part D: J Automobile Engineering2016; 230(4): 470–478.
14.
BouchezMDementhonJB. Strategies for the control of particulate trap regeneration. SAE technical paper 2000-01-0472, 2000.
15.
ParksJHuffSKassMStoreyJ. Characterization of in-cylinder techniques for thermal management of diesel aftertreatment. SAE technical paper 2007-01-3997, 2007.
16.
SinghPThalagavaraAMNaberJDJohnsonJHBagleyST. An experimental study of active regeneration of an advanced catalyzed particulate filter by diesel fuel injection upstream of an oxidation catalyst. PhD Thesis, Michigan Technological University, Houghton, MI, 2006.
17.
JoshiAChatterjeeSSawantAAkerlundCAnderssonSBlomquistMet al. Development of an actively regenerating dpf system for retrofit applications. SAE technical paper 2006-01-3553, 2006.
18.
RobertsLMageeMShaverGGargAMcCarthyJKoeberleinEet al. Modeling the impact of early exhaust valve opening on exhaust aftertreatment thermal management and efficiency for compression ignition engines. Int J Engine Res2015; 16(6): 773–794.
19.
BharathANYangYReitzRDRutlandC. Comparison of variable valve actuation, cylinder deactivation and injection strategies for low-load RCCI operation of a light duty engine. SAE technical paper 2015-01-0843, 2015.
20.
BlumenroderKBuschmannGKahrstedtJSommerAMaiwaldO. Variable valve trains for passenger-car diesel engines—potentials, limits and ways of realization. In: Proceedings of the international Vienna motor symposium, Vienna, 28 April 2006, pp. 280. DI-Verlag GMBH.
21.
Environmental Protection Agency. 40 cfr 86.1342-90 -calculations; exhaust emissions, July2002. 54 FR 14605, 11 April 1989, as amended at 62 FR 47135, 5September1997.
