Numerical and experimental investigation of the influence of infrared reflective interior surfaces on building temperature distributions

Abstract

Radiative properties of interior surfaces can affect not only the building heat flux but also the indoor environment, the latter of which has not been thoroughly investigated. The aim of this study is to analyse the effect of surface emissivity on indoor air and surface temperature distributions in a test cabin with reflective interior surfaces. This was done by comparing experimental and simulation data of the test cabin with that of a normal cabin. This study employs transient computational fluid dynamics (CFD) using re-normalisation group (RNG) k–ε model, surface-to-surface radiation model and an enhanced wall function. Boundary conditions were assigned to exterior surfaces under variable outdoor conditions. The numerical and the measurement results indicate that using interior reflective surfaces will affect the indoor air temperature distribution by increasing the vertical temperature gradient depending on the time of the day. CFD simulations with high spatial resolution results show increased interior surface temperature gradients consistent with the increased vertical air temperature gradient. The influence of reflective surfaces is potentially greater with higher indoor surface temperature asymmetry. The vertical indoor air temperature gradient and surface temperatures are important parameters for indoor thermal comfort.

Keywords

Reflective interior surfaces Indoor air temperature gradient Transient computational fluid dynamics Surface-to-surface radiation Building thermal performance

Get full access to this article

View all access options for this article.

References

Belusko

Bruno

Saman

. Investigation of the thermal resistance of timber attic spaces with reflective foil and bulk insulation, heat flow up. Appl Energ 2011; 88: 127–137.

Daoud

Galanis

Bellache

. Calculation of refrigeration loads by convection, radiation and condensation in ice rinks using a transient 3D zonal model. Appl Therm Eng 2008; 28: 1782–1790.

Joudi

Svedung

Cehlin

Rönnelid

. Reflective coatings for interior and exterior of buildings and improving thermal performance. Appl Energ 2013; 103: 562–570.

Baldinelli

. A methodology for experimental evaluations of low-e barriers thermal properties: field tests and comparison with theoretical models. Build Environ 2010; 45: 1016–1024.

Joudi

Svedung

Bales

Rönnelid

. Highly reflective coatings for interior and exterior steel cladding and the energy efficiency of buildings. Appl Energ 2011; 88: 4655–4666.

Lin

Chow

Tsang

Fong

Chan

. Stratum ventilation – a potential solution to elevated indoor temperatures. Build Environ 2009; 44: 2256–2269.

ISO 7730:2005 Ergonomics of the thermal environment – analytical determination and interpretation of thermal comfort using calculation of the PMV and PPD indices and local thermal comfort criteria. Geneva: International Organization for Standardization, 2005.

Sandberg

Fuchs

. Vertical temperature profiles in rooms ventilated by displacement: full-scale measurement and nodal modelling. Indoor Air 1992; 2: 225–243.

Park

Holland

. The effect of location of a convective heat source on displacement ventilation: CFD study. Build Environ 2001; 36: 883–889.

10.

Cehlin

Moshfegh

. Numerical modeling of a complex diffuser in a room with displacement ventilation. Build Environ 2010; 45: 2240–2252.

11.

Chen

Moshfegh

Cehlin

. Investigation on the flow and thermal behavior of impinging jet ventilation systems in an office with different heat loads. Build Environ 2013; 59: 127–144.

12.

Nielsen

. Computational fluid dynamics and room air movement. Indoor Air 2004; 14: 134–143.

13.

Ohba

Lun

Overview of natural cross ventilation studies and the latest simulation design tools used in building ventilation-related research. In: Santamouris

(ed). Advances in Building Energy Research, London: GBR Earthscan, 2010, pp. 127–166.

14.

Hensen

Integrated building airflow simulation. In: Malkawi

Augenbroe

(eds). Advanced building simulation, New York: Spon Press, 2004, pp. 87–118. .

15.

Woloszyn

Rode

Sasic Kalagasidis

Janssens

De Paepe

. From EMPD to CFD–overview of different approaches for heat air and moisture modeling in IEA Annex 41. ASHRAE Trans 2009; 115: 96–110.

16.

Azemati

Shirkavand Hadavand

Hosseini

Salemi Tajarrod

. Thermal modeling of mineral insulator in paints for energy saving. Energy Build 2013; 56: 109–114.

17.

Joudi A, Radiation properties of coil-coated steel in building envelope surfaces and the influence on building thermal performance. Department of Management and Engineering, Energy Systems. Linköping University, Linköping, 2015.

18.

Holman

. Heat transfer, 10th edn. Boston: McGraw Hill Higher Education, 2010.

19.

Shati A. The interaction between radiation and turbulent natural convection in square and rectangular enclosures. Department of Mechanical Engineering, University of Sheffield, Sheffield, 2013.

20.

Yakhot

Orszag

. Renormalization group analysis of turbulence. I. Basic theory. J Sci Comput 1986; 1: 3–51.

21.

Zhang

Zhai

Zhang

Chen

. Evaluation of various turbulence models in predicting airflow and turbulence in enclosed environments by CFD: Part 2—comparison with eperimental data from literature. HVAC&R Res 2007; 13: 871–886.

22.

ANSYS/Fluent. 12.0 theory guide, 2009. ANSYS FLUENT 12.0 documentation, theory guide. PA: ANSYS, Inc., 2009.

23.

EQUA. IDA indoor climate and energy (IDA ICE 4.5), Stockholm, Sweden: EQUA Simulation AB, 2013.

24.

Bring

Sahlin

Vuolle

. Models for building indoor climate and energy simulation: a report of task 22 building energy analysis tools, Stockholm: Department of Building Sciences, Royal Institute of Technology (KTH), 1999.

25.

Mirsadeghi

Cóstola

Blocken

Hensen

JLM

. Review of external convective heat transfer coefficient models in building energy simulation programs: implementation and uncertainty. Appl Therm Eng 2013; 56: 134–151.

26.

Duffie

Beckman

. Solar engineering of thermal processes, 3rd edn. Hoboken, NJ: Wiley, 2006.

27.

ASHRAE Handbook of Fundamentals, (SI ed.) Atlanta: American Society of Heating, Refrigerating and Air-Conditioning Engineers, Inc, 2006.

28.

Clarke

. Energy simulation in building design, 2nd edn. New York, NY: Routledge, 2001.

29.

Mackey

Wright

. Periodic heat flow – homogeneous walls or roofs. ASHRAE Trans 1944; 50: 293–312.