Field measurements of perceived air quality were conducted in four refurbished offices at the Czech Technical University in Prague. The offices were refurbished as part of the research project Clear-up to serve as a field test facility. The present paper describes measurements conducted to investigate the perceived air quality, sensory pollution load and concentration of Volatile Organic Compounds (VOCs) in the offices. As the refurbishment comprised also installation of demand controlled ventilation (DCV), its influence on the perceived air quality was also tested. Measurements comprised the assessments of perceived air quality and objective measurements of operative temperature, relative humidity, CO2 and VOCs concentrations. Results showed that the mean sensory pollution load in unoccupied offices was 0.09 ± 0.01 olf/m2 (mean ± SEM). This falls into the category of a low-polluting building according to CEN Report CR 1752. The acceptability of the air quality was worst in unoccupied offices ventilated with minimum air change rate (0.4 h-1). Application of DCV decreased the CO2 concentration, but did not result in statistically significant improvement of perceived air quality.
Clear-up. Clean and resource efficient buildings for real life. Collaborative research project funded by the EC 7th Framework Programme; grant agreement no. 211948, http://www.clear-up.eu/ (accessed March 2014).
2.
European Concerted Action “Indoor Air Quality & Its Impact on Man”, COST Project 613. Report no. 10: Effects of indoor air pollution on human health. Technical report, EUR 14086 EN. Office for Publications of the European Communities, Luxembourg 1991.
3.
WargockiP. Perceived air quality, sick building syndrome symptoms and productivity in an office with two different pollution loads. Indoor Air1999; 9: 165–179.
4.
Wyon DP. Indoor environmental effects on productivity. In: Keynote address to indoor air quality ’96 conference. Proceedings of American Society of Heating, Refrigerating, and Air-Conditioning Engineers, Inc. (ASHRAE), Baltimore, Maryland, USA, October 6–8 1996.
5.
FangerPO. Introduction to the olf and decipol units to quantify air pollution perceived by humans indoors and outdoors. Energy Build1988; 12: 1–6.
6.
CR 1752. CEN report ventilation for buildings: design criteria for the indoor environment, CEN/TC 156/WG 6, Brussels: European Committee for Standardization (CEN), 1998.
7.
WargockiPFangerPOKrupiczPSzczecinskiA. Sensory pollution loads in office buildings and a department store. Energy Build2004; 36: 995–1001.
8.
FangerPOLauridsenJBluyssenPClausenG. Air pollution sources in offices and assembly halls quantified by the olf unit. Energy Build1988; 12: 7–19.
9.
BluyssenPDe Oliveira FernandesEGroesLClausenGFangerPOValbjørnOBernhardCARouletCA. European indoor air quality audit project in 56 office buildings. Indoor Air1996; 6: 221–238.
10.
FiskWJAlmeidaATD. Sensor-based demand-controlled ventilation: a review. Energy Build1998; 29: 35–45.
11.
HaghighatFDonniniG. IAQ and energy-management by demand controlled ventilation. Environ Technol1992; 13: 351–359.
12.
MysenMRydockaJPTjelflaatPO. Demand controlled ventilation for office cubicles-can it be profitable?Energy Build2003; 35: 657–662.
13.
NielsenTDrivsholmC. Energy efficient demand controlled ventilation in single family houses. Energy Build2010; 42(11): 1995–1998.
14.
NorbackDNordstromKZhaoZ. Carbon dioxide (CO2) demand-controlled ventilation in university computer classrooms and possible effects on headache, fatigue and perceived indoor environment: an intervention study. Int Arch Occup Environ Health2013; 86(2): 199–209.
15.
EneaDGuerriniGL. Photocatalytic properties of cement-based plasters and paints containing mineral pigments. Transport Res Rec2010; 2141: 52–60.
16.
Simone A, Babiak J, Bullo M, Landkilde G and Olesen BW. Operative temperature control of radiant surface heating and cooling systems. In: Proceedings of Clima 2007 wellbeing indoors, the 9th REHVA World Congress, Helsinki, Finland (CD-rom); June 10–14 2007.
17.
EN ISO/FDIS 16200-2:2000. Workplace air quality – sampling and analysis of volatile organic compounds by solvent desorption/gas chromatography – Part 2: diffusive sampling method, Geneva, Switzerland: International Organisation for Standardisation, 2000.
18.
EN ISO/FDIS 16000-4: 2004. Indoor air – Part 4: Determination of formaldehyde – diffusive sampling method, Geneva, Switzerland: International Organisation for Standardisation, 2004.
19.
EN ISO/FDIS 16000-6:2004. Indoor air – Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS/FID, Geneva, Switzerland: International Organisation for Standardisation, 2004.
20.
KolarikJWargockiP. Can a photocatalytic air purifier be used to improve the perceived air quality indoors?Indoor Air2010; 20(3): 255–262.
21.
GunnarsenLFangerPO. Adaptation to indoor air-pollution. Environ Int1992; 18(1): 43–54.
22.
R Development Core Team. R: a language and environment for statistical computing. Vienna, Austria: R Foundation for Statistical Computing, 2007, http://www.Rproject.org.
23.
StatSoft, Inc. STATISTICA (data analysis software system), version 7, http://www.statsoft.com (2004).
24.
LairdNMWareJH. Random-effects models for longitudinal data. Biometrics1982; 38: 963–974.
25.
HillTLewickiP. STATISTICS: methods and applications, Tulsa, OK: StatSoft, 2007.
26.
GeissOGiannopoulosGTirendiSBarrero-MorenoJLarsenBRKotziasD. The AIRMEX study – VOC measurements in public buildings and schools/kindergartens in eleven European cities: statistical analysis of the data. Atmos Environ2011; 45: 3676–3684.
27.
CainWSSchmidtRWolkoffP. Olfactory detection of ozone and D-limonene: reactants in indoor spaces. Indoor Air2007; 17: 337–347.
28.
KlenoJGWolkoffPWilkinsCKPedersenT. Degradation of the adsorbent Tenax TA by nitrogen oxides, ozone, hydrogen perodixe, OH radical, and limonene oxidation products. Environ Sci Technol2002; 36(10): 4121–4126.
29.
KolarikJToftumJ. The impact of photocatalytic paint on indoor air pollutants: sensory assessments. Build Environ2012; 57: 396–402.
30.
EN ISO 15251:2007. Indoor environmental input parameters for design and assessment of energy performance of buildings addressing indoor air quality, thermal environment, lighting and acoustics, Brussels, Belgium: European Committee for Standardization, 2007.
31.
ISO/IEC Guide 98-3: 2008(E). Uncertainty of measurement – Part 3: guide to the expression of uncertainty in measurement (GUM:1995), Geneva, Switzerland: International Standardization Organization, 2008.
