Investigation of shear response due to variation of fiber volume fraction,transverse steel,and placement method on short span R/UHPC beams

Abstract

This study investigates the response of small-scale, reinforced ultra high performance concrete beams. Seven specimens were cast and experimentally tested. Steel fiber volume fraction, amount of longitudinal and transverse steel reinforcement, and casting direction varied between specimens. High longitudinal reinforcement ratios of 4.1% and 9.5% were expected to drive relatively large shear demands and low steel fiber volume fractions of 0.5% and 1% were expected to decrease the UHPC’s ability to resist tension, shear, and compression. Specimens were either cast at one end or mid-span. All specimens failed in shear, as expected. R/UHPC beams with only 0.5% fibers and a stirrup spacing equal to half the beam’s depth carried more ultimate load than beams with 1% fibers and twice the stirrup spacing. At a 0.5% fiber volume fraction, UHPC performed well, exhibiting fiber bridging in tension and resisting spalling in compression. As longitudinal reinforcement ratio increased from 4.1% to 9.5%, load carrying capacity generally increased, but not proportional to the increase in steel. Placement method did not influence fiber orientation in the R/UHPC beams when measured in 2D planes transverse or longitudinal to the specimens’ major axis. The longitudinal and transverse reinforcement interrupted fiber flow and prevented significant fiber alignment; combined with the short span of the beams, these factors mitigated the influence of placement method.