In this research, the tribological and dynamical characteristics of a brake pad with multiple blocks are investigated using experimental and numerical methods. A dynamometer with a multiblock brake pad configuration on a brake disc is developed and a series of drag-type tests are conducted to study the brake squeal and wear behavior of a high-speed train brake system. Finite element analysis is performed to derive physical explanations for the observed experimental phenomena. The experimental and numerical results show that the rotational speed and braking force have important influences on the brake squeal; the trends of the multiblock and single-block systems are different. In the multiblock brake pad, the different blocks exhibit significantly different magnitudes of contact stresses and vibration accelerations. The blocks located in the inner and outer rings have higher vibration acceleration amplitudes and stronger vibration energies than the blocks located in the middle ring.
SinouJ-JLoyerAChielloO, et al.A global strategy based on experiments and simulations for squeal prediction on industrial railway brakes. J Sound Vib2013; 332: 5068–5085.
PapinniemiALaiJCZhaoJ, et al.Brake squeal: a literature review. Appl Acoust2002; 63: 391–400.
6.
SrinivasanSSaghirMZ. Experimental approaches to study thermodiffusion–A review. Int J Therm Sci2011; 50: 1125–1137.
7.
GhazalyNMEl-SharkawyMAhmedI. A review of automotive brake squeal mechanisms. J Mech Des Vib2014; 1: 5–9.
8.
RabiaAMGhazalyNMSalemM, et al.Experimental studies of automotive disc brake noise and vibration: a review. Int J Modern Eng Res2013; 3: 199–203.
9.
Chiello O, Sinou J-J, Vincent N, et al. Squeal noise generated by railway disc brakes: experiments and stability computations on large industrial models. In: Proceedings of meetings on acoustics ICA2013: ASA, 2013, p. 065049.
10.
RusliMOkumaM. Effect of surface topography on mode-coupling model of dry contact sliding systems. J Sound Vib2007; 308: 721–734.
11.
HoffmannNFischerMAllgaierR, et al.A minimal model for studying properties of the mode-coupling type instability in friction induced oscillations. Mech Res Commun2002; 29: 197–205.
12.
ChenGZhouZ. Correlation of a negative friction–velocity slope with squeal generation under reciprocating sliding conditions. Wear2003; 255: 376–384.
13.
HoffmannNGaulL. A sufficient criterion for the onset of sprag-slip oscillations. Arch Appl Mech2004; 73: 650–660.
14.
PaliwalMMahajanADonJ, et al.Noise and vibration analysis of a disc brake system using a stick slip friction model involving coupling stiffness. J Sound Vib2005; 282: 1273–1284.
15.
KangJKrousgrillCMSadeghiF. Wave pattern motion and stick–slip limit cycle oscillation of a disc brake. J Sound Vib2009; 325: 552–564.
16.
NeisPFerreiraNPolettoJ, et al.Quantification of brake creep groan in vehicle tests and its relation with stick–slip obtained in laboratory tests. J Sound Vib2016; 369: 63–76.
17.
YoonSShinMLeeW, et al.Effect of surface contact conditions on the stick–slip behavior of brake friction material. Wear2012; 294: 305–312.
18.
KangJKrousgrillCMSadeghiF. Analytical formulation of mode-coupling instability in disc–pad coupled system. Int J Mech Sci2009; 51: 52–63.
19.
WeiDSongJNanY, et al.Analysis of the stick-slip vibration of a new brake pad with double-layer structure in automobile brake system. Mech Syst Signal Process2019; 118: 305–316.
20.
TonazziDMassiFBailletL, et al.Interaction between contact behaviour and vibrational response for dry contact system. Mech Syst Signal Process2018; 110: 110–121.
21.
KchaouMLazimAMHamidMA, et al.Experimental studies of friction-induced brake squeal: influence of environmental sand particles in the interface brake pad-disc. Tribol Int2017; 110: 307–317.
22.
GianniniOAkayAMassiF. Experimental analysis of brake squeal noise on a laboratory brake setup. J Sound Vib2006; 292: 1–20.
23.
AkayAGianniniOMassiF, et al.Disc brake squeal characterization through simplified test rigs. Mech Syst Signal Process2009; 23: 2590–2607.
24.
KadoNSatoNTadokoroC, et al.Effect of yaw angle misalignment on brake noise and brake time in a pad-on-disc-type apparatus with unidirectional compliance for pad support. Tribol Int2014; 78: 41–46.
25.
ButlinTWoodhouseJ. A systematic experimental study of squeal initiation. J Sound Vib2011; 330: 5077–5095.
26.
GianniniOSestieriA. Predictive model of squeal noise occurring on a laboratory brake. J Sound Vib2006; 296: 583–601.
27.
RenaultAMassaFLallemandB, et al.Experimental investigations for uncertainty quantification in brake squeal analysis. J Sound Vib2016; 367: 37–55.
28.
OuyangHNackWYuanY, et al.Numerical analysis of automotive disc brake squeal: a review. Int J Veh Noise Vib2005; 1: 207–231.
29.
JuniorMTGergesSNJordanR. Analysis of brake squeal noise using the finite element method: a parametric study. Appl Acoust2008; 69: 147–162.
30.
KangJ. Squeal analysis of gyroscopic disc brake system based on finite element method. Int J Mech Sci2009; 51: 284–294.
31.
Esgandari M, Taulbut R and Olatunbosun O. Effect of damping in complex eigenvalue analysis of brake noise to control over-prediction of instabilities: an experimental study. SAE Technical Paper, 2013.
32.
WangDMoJOuyangH, et al.Experimental and numerical studies of friction-induced vibration and noise and the effects of groove-textured surfaces. Mech Syst Signal Process2014; 46: 191–208.
33.
DeziMFortePFrendoF. Motorcycle brake squeal: experimental and numerical investigation on a case study. Meccanica2014; 49: 1011–1021.
34.
BashmalSBhatRRakhejaS. Experimental and numerical study of the vibration of stationary and rotating annular disks. J Vib Acoust2016; 138: 051003–051003.
35.
Gräbner N, Tiedemann M, Von Wagner U, et al. Nonlinearities in friction brake NVH-experimental and numerical studies. SAE Technical Paper, 2014.
36.
Wallner D, Bernsteiner S, Hirschberg W, et al. Numerical and experimental parameter studies on brake squeal. SAE Technical Paper, 2010.
37.
WangXMoJOuyangH, et al.Squeal noise of friction material with groove-textured surface: an experimental and numerical analysis. J Tribol2016; 138: 021401–021401.
38.
WangDMoJGeX, et al.Disc surface modifications for enhanced performance against friction noise. Appl Surf Sci2016; 382: 101–110.
39.
OuyangHCaoQMottersheadJ, et al.Vibration and squeal of a disc brake: modelling and experimental results. Proc IMechE, Part D: J Automobile Engineering2003; 217: 867–875.
40.
NoubyMMathivananDSrinivasanK. A combined approach of complex eigenvalue analysis and design of experiments (DOE) to study disc brake squeal. Int J Eng Sci Technol2009; 1: 254–271.
41.
MassiFGianniniOBailletL. Brake squeal as dynamic instability: an experimental investigation. J Acoust Soc Am2006; 120: 1388–1398.
42.
TangBMoJZhangX, et al.Experimental investigation of the squeal characteristics in railway disc brakes. Proc IMechE, Part J: J Engineering Tribology2018; 232: 1437–1449.
43.
WangDMoJLiuM, et al.Improving tribological behaviours and noise performance of railway disc brake by grooved surface texturing. Wear2017; 376: 1586–1600.
44.
JiguangCFeiG. Temperature field and thermal stress analyses of high-speed train brake disc under pad variations. Open Mech Eng J2015; 9: 371–378.
45.
Lorang X, Loyer A, Chiello O, et al. A mechanical modeling strategy for squeal prediction on industrial railway brakes. In: 9th world congress on railway research, 2011, p. 7.
46.
OstermeyerGMüllerM. Dynamic interaction of friction and surface topography in brake systems. Tribol Int2006; 39: 370–380.
47.
Abu BakarAOuyangHJamesS, et al.Finite element analysis of wear and its effect on squeal generation. Proc IMechE, Part D: J Automobile Engineering2008; 222: 1153–1165.
48.
NeisPFerreiraNFeketeG, et al.Towards a better understanding of the structures existing on the surface of brake pads. Tribol Int2017; 105: 135–147.
49.
Lorang X and Chiello O. Stability and transient analysis in the modelling of railway disc brake squeal. In: Noise and vibration mitigation for rail transportation systems (eds. B Schulte-Werning, D Thompson, Pierre-Etienne Gautier, C Hanson, B Hemsworth, J Nelson, T Maeda, P de Vos). Berlin, Heidelberg: Springer, 2008, pp.447–453.
50.
QianWChenGZhouZ. Dynamic transient analysis of squealing vibration of a reciprocating sliding system. Wear2013; 301: 47–56.
51.
SinouJ-J. Transient non-linear dynamic analysis of automotive disc brake squeal–on the need to consider both stability and non-linear analysis. Mech Res Commun2010; 37: 96–105.
