A new two-dimensional model of rolling–sliding contact creep curves for a range of lubrication types

Abstract

Experimentally determined creep curves for rolling–sliding contact in lubricated conditions are found to deviate greatly from the standard theory for two-body contact. This article presents a new model to represent coefficient of adhesion (also known as traction coefficient) and creep based on experimental data gathered for a range of railway rail–wheel contact conditions. The model developed is based on a two-dimensional elastic foundation representation of a twin disc contact. This is used to quantify the creep curves in a similar manner to existing models of three-dimensional real rail–wheel contacts undergoing partial slip for a range of lubrication conditions. The work focuses on very low levels of creep, ranging from 0 to 1%, and lubricants experienced by a rail–wheel contact in service (dry, wet, flange lubricant). Lubricants used during the simulation of low adhesion conditions for driver training (soap and water, lignin and water) are also represented. The motivation for the research is inclusion of creep-traction characteristics in an on-board system being developed for prediction of low adhesion conditions at the rail–wheel interface based upon monitoring running conditions prior to brake application.

Keywords

Rail–wheel adhesion model two-dimensional creep lubrication railway

Get full access to this article

View all access options for this article.

References

Poole W. An overview of low adhesion factors for ERTMS. Project T080 final report, July 2003, Rail Safety and Standards Board, London.

GM/GN2642. Guidance on wheel/ rail low adhesion measurement. Issue 1, February 2008, Rail Safety and Standards Board, London.

Onboard detection of low adhesion. Rail Safety and Standards Board project T959, Research and Development E-Newsletter, Issue 69, January 2011, www.rssb.co.uk.

Fletcher

Lewis

. Creep curve measurement using a continuously variable creep twin disc machine. Wear 2012; (submitted).

Johnson

. Contact mechanics, Cambridge, UK: Cambridge University Press, 1987.

Carter

. On the action of a locomotive driving wheel. Proc Roy Soc Lond Ser A 1926; 112(760): 151–157.

Haines

Ollerton

. Contact stress distribution on elliptical contact surfaces subject to radial and tangential forces. Proc Instn Mech Engrs 1963; 177(95): 261–265.

Polach

. Creep forces in simulations of traction vehicles running on adhesion limit. Wear 2005; 258: 992–1000.

Kalker JJ. On the rolling contact of two elastic bodies in the presence of dry friction. Thesis, Delft, 1967.

10.

Fletcher

Beynon

. Development of a machine for closely controlled rolling contact fatigue and wear testing. J Test Eval 2000; 28(4): 267–275.

11.

Carroll

Beynon

. Rolling contact fatigue of white etching layer: Part 1: Crack morphology. Wear 2007; 262(9–10): 1253–1266.

12.

Engineering Science Data Unit Item 78035. Contact phenomena I: stresses, deflections and contact dimensions for normally-loaded unlubricated elastic components. ESDU International, London, 1995.

13.

Williams T and Kelley C. Gnuplot 4.4, An interactive plotting program, www.gnuplot.info (accessed 10 February 2012).