Abstract
Background:
Success of valgus-type supramalleolar osteotomy (SMOT) depends on adequate correction of malalignment, which can be hard to achieve with current 2-dimensional (2D) planning and operative techniques. A personalized digital 3-dimensional (3D) workflow to virtually plan and perform a 2-step 3D-guided medial opening (MO) SMOT has the potential to improve precision of correction.
Methods:
Computed tomography (CT)–based Proplan medical 3D models were made to virtually plan the desired MO SMOT, and exported to 3-Matic medical to develop patient-specific 2-step cutting and wedge guides. Workflow accuracy was tested in this limited clinical pilot study (3 patients) by comparing the virtual planned position of the osteotomized distal tibial fragment with the 1-year post-MO SMOT configuration. Two millimeters or less translation deviation in every plane was defined as accurate.
Results:
Primary outcome analysis of the osteotomized distal tibial fragment deviation showed a median translation in all planes of 0.7 (range 0-8.2) mm (interquartile range 1.55) with an excellent interrater reliability of the measurements (intraclass correlation coefficient 0.998). There was a strong reduction in ankle pain as reflected by an increase of the AOFAS-AH score and decrease of NRS pain score with an unrestricted hindfoot motion 1 year after surgery.
Conclusion:
3D virtually planned bone cutting and wedge guides is a promising approach associated with minimal postoperative deviation from the desired correction in medial opening supramalleolar osteotomy.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
