Unsteady flow around suction elbow and inlet guide vanes in a centrifugal compressor

Abstract

Suction elbow and inlet guide vanes (IGVs) are typical upstream components in front of the first-stage impeller in a centrifugal compressor. As the flow field in the front of the impeller is subsonic, the flow motion induced by the rotating impeller interacts with the elbow and IGVs. These interactions induce turbulent unsteady flows inside compressors. The resulting unsteadiness affects efficiency, vibration, and noise generation of the compressor. To understand the mechanism controlling the interactions between upstream components and to optimize the compressor design for better efficiency and reliability, the turbulent unsteady flow inside the first stage of the compressor was simulated. The model included the suction elbow, IGV housing, and firststage impeller. HFC 134a was used as the working fluid. The thermodynamic and transport properties of the refrigerant gas were modelled by the Martin-Hou equation of state and power laws, respectively. The three-dimensional unsteady flow field was numerically simulated. The overall performance parameters were obtained by integrating the field quantities. The force, torque, and the arm of moments acting on the IGVs were then calculated. The results can be used to design IGVs and their motion control system to achieve higher efficiency and improve reliability.

Keywords

centrifugal compressor inlet guide vane suction elbow unsteady flow computational fluid mechanics heat transfer

Get full access to this article

View all access options for this article.

References

D. Hagelstein, R. Van den Braembussche, R. Keiper, and M. Rautenberg Experimental investigation of the circumferential static pressure distortion in centrifugal compressor stages. ASME paper 97-GT-50, 1997.

I. Kassens and M. Rautenberg Flow measurements behind the inlet guide vane of a centrifugal compressor. ASME paper 98-GT-86, 1998.

Y. Chen N., D. Hagelstein, I. Kassens, U. Haupt, and M. Rautenberg Overshoot of the Rankine vortex formed in the flow field behind the inlet guide vane of centrifugal compressors. ASME paper 99-GT-182, 1999.

Y. Chen N., D. Hagelstein, I. Kassens, U. Haupt, and M. Rautenberg Effect of decaying overshoot of the rankine vortex on the axial flow field behind the inlet guide vane of centrifugal compressors. ASME paper 2000-GT-427, 2000.

M. Cui M. Effect of suction elbow and inlet guide vanes on flow field in a centrifugal compressor stage. ASME paper GT2002–30376, 2002.