Abstract
Forced heat transfer of Al2O3-water, CuO-water, and TiO2-water nanofluids, Al2O3-CuO-water, Al2O3-TiO2-water, and CuO-TiO2-water nanoparticles in volumetric concentrations of 0.5%, 0.9%, and 2% were studied in a flat tube car radiator. In this work, the thermal performance of hybrid nanofluid will be compared with mono nanofluid and pure water base fluid. These nanoparticles were combined in ratios of (75:25), (50:50), and (25:75) in pure water. Mono and hybrid nanofluids with an inlet temperature of 90 °C, and in different Reynolds numbers (272–816) were studied and numerically simulated. The heat transfer performances of mono and hybrid nanofluids were determined using Nusselt number (Nu), overall heat transfer coefficient (U), convective heat transfer coefficient (h), and heat transfer rate (Qa). The results show an enhancement in the thermal performances of the radiator with an increase in Reynolds number and volume concentration as follows: (Al2O3-water > Al2O3-CuO-water (75:25) > Al2O3-CuO-water (50:50) >Al2O3-CuO-water (25:75) > Al2O3-TiO2-water (75:25) > CuO-TiO2-water (75:25) > Al2O3-TiO2-water (50:50) > CuO-TiO2-water (50:50) > CuO-water > Al2O3-TiO2-water (25:75) > CuO-TiO2-water (25:75) > TiO2-water).
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
