Abstract
The influence of the surface area by the impact of high temperatures after wire electric discharge machining (WEDM) is a known fact. However, the affected parameters also include a change in microhardness. In order to further investigate this statement, 5 different ferrous and non-ferrous materials were selected, from which three samples were always made with different settings of machine parameters (gap voltage, pulse on and off time, wire feed and discharge current). This examined not only the effect of the machining itself on the material but also whether the change in the microhardness of the material is affected by the setting of the machine parameters. In order to measure the microhardness of the subsurface layer, a metallographic preparation was made from each sample, which enabled accurate measurements always in the same area. Subsequent evaluation revealed that the microhardness may not be affected at all and everything depends only on the type of material being machined. The changes in microhardness affected by setting machine parameters are negligible.
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
