Abstract
Pulsation of current is widely employed in Tungsten Inert Gas (TIG) welding of titanium alloys. In the current study, the influence of welding speed and welding currents (peak and background) on the properties pulsed TIG welded Ti-5Al-2.5Sn alloy were investigated. The weldment characteristics which were analyzed included weld zone size, microstructure, residual stresses, tensile and impact properties. Increasing the welding speed and gradient of pulsed current enhanced grain strengthening in the fusion zone (FZ) which was attributed to increased cooling rate. Such a welding condition was also favorable in achieving full penetration weldments with a reduced; heat affected zone width, grain size in FZ and residual stresses. However, a tensile strength superior to the base metal was observed. The impact toughness reduced by increasing the pulsed current gradient and a high value of both peak and background currents were required to improve the impact toughness of the weldments.
Keywords
Get full access to this article
View all access options for this article.
References
Supplementary Material
Please find the following supplemental material available below.
For Open Access articles published under a Creative Commons License, all supplemental material carries the same license as the article it is associated with.
For non-Open Access articles published, all supplemental material carries a non-exclusive license, and permission requests for re-use of supplemental material or any part of supplemental material shall be sent directly to the copyright owner as specified in the copyright notice associated with the article.
